USB: serial: pl2303: new device id for Chilitag
[pandora-kernel.git] / drivers / usb / host / isp1760-hcd.h
1 #ifndef _ISP1760_HCD_H_
2 #define _ISP1760_HCD_H_
3
4 /* exports for if */
5 struct usb_hcd *isp1760_register(phys_addr_t res_start, resource_size_t res_len,
6                                  int irq, unsigned long irqflags,
7                                  int rst_gpio,
8                                  struct device *dev, const char *busname,
9                                  unsigned int devflags);
10 int init_kmem_once(void);
11 void deinit_kmem_cache(void);
12
13 /* EHCI capability registers */
14 #define HC_CAPLENGTH            0x00
15 #define HC_HCSPARAMS            0x04
16 #define HC_HCCPARAMS            0x08
17
18 /* EHCI operational registers */
19 #define HC_USBCMD               0x20
20 #define HC_USBSTS               0x24
21 #define HC_FRINDEX              0x2c
22 #define HC_CONFIGFLAG           0x60
23 #define HC_PORTSC1              0x64
24 #define HC_ISO_PTD_DONEMAP_REG  0x130
25 #define HC_ISO_PTD_SKIPMAP_REG  0x134
26 #define HC_ISO_PTD_LASTPTD_REG  0x138
27 #define HC_INT_PTD_DONEMAP_REG  0x140
28 #define HC_INT_PTD_SKIPMAP_REG  0x144
29 #define HC_INT_PTD_LASTPTD_REG  0x148
30 #define HC_ATL_PTD_DONEMAP_REG  0x150
31 #define HC_ATL_PTD_SKIPMAP_REG  0x154
32 #define HC_ATL_PTD_LASTPTD_REG  0x158
33
34 /* Configuration Register */
35 #define HC_HW_MODE_CTRL         0x300
36 #define ALL_ATX_RESET           (1 << 31)
37 #define HW_ANA_DIGI_OC          (1 << 15)
38 #define HW_DATA_BUS_32BIT       (1 << 8)
39 #define HW_DACK_POL_HIGH        (1 << 6)
40 #define HW_DREQ_POL_HIGH        (1 << 5)
41 #define HW_INTR_HIGH_ACT        (1 << 2)
42 #define HW_INTR_EDGE_TRIG       (1 << 1)
43 #define HW_GLOBAL_INTR_EN       (1 << 0)
44
45 #define HC_CHIP_ID_REG          0x304
46 #define HC_SCRATCH_REG          0x308
47
48 #define HC_RESET_REG            0x30c
49 #define SW_RESET_RESET_HC       (1 << 1)
50 #define SW_RESET_RESET_ALL      (1 << 0)
51
52 #define HC_BUFFER_STATUS_REG    0x334
53 #define ISO_BUF_FILL            (1 << 2)
54 #define INT_BUF_FILL            (1 << 1)
55 #define ATL_BUF_FILL            (1 << 0)
56
57 #define HC_MEMORY_REG           0x33c
58 #define ISP_BANK(x)             ((x) << 16)
59
60 #define HC_PORT1_CTRL           0x374
61 #define PORT1_POWER             (3 << 3)
62 #define PORT1_INIT1             (1 << 7)
63 #define PORT1_INIT2             (1 << 23)
64 #define HW_OTG_CTRL_SET         0x374
65 #define HW_OTG_CTRL_CLR         0x376
66
67 /* Interrupt Register */
68 #define HC_INTERRUPT_REG        0x310
69
70 #define HC_INTERRUPT_ENABLE     0x314
71 #define HC_ISO_INT              (1 << 9)
72 #define HC_ATL_INT              (1 << 8)
73 #define HC_INTL_INT             (1 << 7)
74 #define HC_EOT_INT              (1 << 3)
75 #define HC_SOT_INT              (1 << 1)
76 #define INTERRUPT_ENABLE_MASK   (HC_INTL_INT | HC_ATL_INT)
77
78 #define HC_ISO_IRQ_MASK_OR_REG  0x318
79 #define HC_INT_IRQ_MASK_OR_REG  0x31C
80 #define HC_ATL_IRQ_MASK_OR_REG  0x320
81 #define HC_ISO_IRQ_MASK_AND_REG 0x324
82 #define HC_INT_IRQ_MASK_AND_REG 0x328
83 #define HC_ATL_IRQ_MASK_AND_REG 0x32C
84
85 /* urb state*/
86 #define DELETE_URB              (0x0008)
87 #define NO_TRANSFER_ACTIVE      (0xffffffff)
88
89 /* Philips Proprietary Transfer Descriptor (PTD) */
90 typedef __u32 __bitwise __dw;
91 struct ptd {
92         __dw dw0;
93         __dw dw1;
94         __dw dw2;
95         __dw dw3;
96         __dw dw4;
97         __dw dw5;
98         __dw dw6;
99         __dw dw7;
100 };
101 #define PTD_OFFSET              0x0400
102 #define ISO_PTD_OFFSET          0x0400
103 #define INT_PTD_OFFSET          0x0800
104 #define ATL_PTD_OFFSET          0x0c00
105 #define PAYLOAD_OFFSET          0x1000
106
107 struct slotinfo {
108         struct isp1760_qh *qh;
109         struct isp1760_qtd *qtd;
110         unsigned long timestamp;
111 };
112
113
114 typedef void (packet_enqueue)(struct usb_hcd *hcd, struct isp1760_qh *qh,
115                 struct isp1760_qtd *qtd);
116
117 /*
118  * Device flags that can vary from board to board.  All of these
119  * indicate the most "atypical" case, so that a devflags of 0 is
120  * a sane default configuration.
121  */
122 #define ISP1760_FLAG_BUS_WIDTH_16       0x00000002 /* 16-bit data bus width */
123 #define ISP1760_FLAG_OTG_EN             0x00000004 /* Port 1 supports OTG */
124 #define ISP1760_FLAG_ANALOG_OC          0x00000008 /* Analog overcurrent */
125 #define ISP1760_FLAG_DACK_POL_HIGH      0x00000010 /* DACK active high */
126 #define ISP1760_FLAG_DREQ_POL_HIGH      0x00000020 /* DREQ active high */
127 #define ISP1760_FLAG_ISP1761            0x00000040 /* Chip is ISP1761 */
128 #define ISP1760_FLAG_INTR_POL_HIGH      0x00000080 /* Interrupt polarity active high */
129 #define ISP1760_FLAG_INTR_EDGE_TRIG     0x00000100 /* Interrupt edge triggered */
130 #define ISP1760_FLAG_RESET_ACTIVE_HIGH  0x80000000 /* RESET GPIO active high */
131
132 /* chip memory management */
133 struct memory_chunk {
134         unsigned int start;
135         unsigned int size;
136         unsigned int free;
137 };
138
139 /*
140  * 60kb divided in:
141  * - 32 blocks @ 256  bytes
142  * - 20 blocks @ 1024 bytes
143  * -  4 blocks @ 8192 bytes
144  */
145
146 #define BLOCK_1_NUM 32
147 #define BLOCK_2_NUM 20
148 #define BLOCK_3_NUM 4
149
150 #define BLOCK_1_SIZE 256
151 #define BLOCK_2_SIZE 1024
152 #define BLOCK_3_SIZE 8192
153 #define BLOCKS (BLOCK_1_NUM + BLOCK_2_NUM + BLOCK_3_NUM)
154 #define MAX_PAYLOAD_SIZE BLOCK_3_SIZE
155 #define PAYLOAD_AREA_SIZE 0xf000
156
157 /* ATL */
158 /* DW0 */
159 #define DW0_VALID_BIT                   1
160 #define FROM_DW0_VALID(x)               ((x) & 0x01)
161 #define TO_DW0_LENGTH(x)                (((u32) x) << 3)
162 #define TO_DW0_MAXPACKET(x)             (((u32) x) << 18)
163 #define TO_DW0_MULTI(x)                 (((u32) x) << 29)
164 #define TO_DW0_ENDPOINT(x)              (((u32) x) << 31)
165 /* DW1 */
166 #define TO_DW1_DEVICE_ADDR(x)           (((u32) x) << 3)
167 #define TO_DW1_PID_TOKEN(x)             (((u32) x) << 10)
168 #define DW1_TRANS_BULK                  ((u32) 2 << 12)
169 #define DW1_TRANS_INT                   ((u32) 3 << 12)
170 #define DW1_TRANS_SPLIT                 ((u32) 1 << 14)
171 #define DW1_SE_USB_LOSPEED              ((u32) 2 << 16)
172 #define TO_DW1_PORT_NUM(x)              (((u32) x) << 18)
173 #define TO_DW1_HUB_NUM(x)               (((u32) x) << 25)
174 /* DW2 */
175 #define TO_DW2_DATA_START_ADDR(x)       (((u32) x) << 8)
176 #define TO_DW2_RL(x)                    ((x) << 25)
177 #define FROM_DW2_RL(x)                  (((x) >> 25) & 0xf)
178 /* DW3 */
179 #define FROM_DW3_NRBYTESTRANSFERRED(x)          ((x) & 0x7fff)
180 #define FROM_DW3_SCS_NRBYTESTRANSFERRED(x)      ((x) & 0x07ff)
181 #define TO_DW3_NAKCOUNT(x)              ((x) << 19)
182 #define FROM_DW3_NAKCOUNT(x)            (((x) >> 19) & 0xf)
183 #define TO_DW3_CERR(x)                  ((x) << 23)
184 #define FROM_DW3_CERR(x)                (((x) >> 23) & 0x3)
185 #define TO_DW3_DATA_TOGGLE(x)           ((x) << 25)
186 #define FROM_DW3_DATA_TOGGLE(x)         (((x) >> 25) & 0x1)
187 #define TO_DW3_PING(x)                  ((x) << 26)
188 #define FROM_DW3_PING(x)                (((x) >> 26) & 0x1)
189 #define DW3_ERROR_BIT                   (1 << 28)
190 #define DW3_BABBLE_BIT                  (1 << 29)
191 #define DW3_HALT_BIT                    (1 << 30)
192 #define DW3_ACTIVE_BIT                  (1 << 31)
193 #define FROM_DW3_ACTIVE(x)              (((x) >> 31) & 0x01)
194
195 #define INT_UNDERRUN                    (1 << 2)
196 #define INT_BABBLE                      (1 << 1)
197 #define INT_EXACT                       (1 << 0)
198
199 #define SETUP_PID       (2)
200 #define IN_PID          (1)
201 #define OUT_PID         (0)
202
203 /* Errata 1 */
204 #define RL_COUNTER      (0)
205 #define NAK_COUNTER     (0)
206 #define ERR_COUNTER     (2)
207
208 #endif /* _ISP1760_HCD_H_ */