[PATCH] sata_promise: cleanups, take 2
authorMikael Pettersson <mikpe@it.uu.se>
Wed, 6 Dec 2006 08:55:43 +0000 (09:55 +0100)
committerJeff Garzik <jeff@garzik.org>
Thu, 7 Dec 2006 12:21:24 +0000 (07:21 -0500)
This patch performs two simple cleanups of sata_promise.

* Remove board_20771 and map device id 0x3577 to board_2057x.
  After the recent corrections for SATAII chips, board_20771 and
  board_2057x were equivalent in the driver.

* Remove hp->hotplug_offset and use hp->flags & PDC_FLAG_GEN_II
  to compute hotplug_offset in pdc_host_init(). hp->hotplug_offset
  was used to distinguish 1st and 2nd generation chips in one
  particular case, but now we have that information in a more
  general form in hp->flags, so hp->hotplug_offset is redundant.

Changes since previous submission: rebased on libata-dev #upstream,
cleaned up hotplug_offset computation based on Tejun's comments,
expanded hotplug_offset removal rationale.

This patch does not depend on the pending new EH conversion patch.

Signed-off-by: Mikael Pettersson <mikpe@it.uu.se>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
drivers/ata/sata_promise.c

index a2778cf..6f7bc5b 100644 (file)
@@ -66,9 +66,8 @@ enum {
        board_2037x             = 0,    /* FastTrak S150 TX2plus */
        board_20319             = 1,    /* FastTrak S150 TX4 */
        board_20619             = 2,    /* FastTrak TX4000 */
-       board_20771             = 3,    /* FastTrak TX2300 */
-       board_2057x             = 4,    /* SATAII150 Tx2plus */
-       board_40518             = 5,    /* SATAII150 Tx4 */
+       board_2057x             = 3,    /* SATAII150 Tx2plus */
+       board_40518             = 4,    /* SATAII150 Tx4 */
 
        PDC_HAS_PATA            = (1 << 1), /* PDC20375/20575 has PATA */
 
@@ -90,7 +89,6 @@ struct pdc_port_priv {
 
 struct pdc_host_priv {
        unsigned long           flags;
-       int                     hotplug_offset;
 };
 
 static u32 pdc_sata_scr_read (struct ata_port *ap, unsigned int sc_reg);
@@ -205,16 +203,6 @@ static const struct ata_port_info pdc_port_info[] = {
                .port_ops       = &pdc_pata_ops,
        },
 
-       /* board_20771 */
-       {
-               .sht            = &pdc_ata_sht,
-               .flags          = PDC_COMMON_FLAGS | ATA_FLAG_SATA,
-               .pio_mask       = 0x1f, /* pio0-4 */
-               .mwdma_mask     = 0x07, /* mwdma0-2 */
-               .udma_mask      = 0x7f, /* udma0-6 ; FIXME */
-               .port_ops       = &pdc_sata_ops,
-       },
-
        /* board_2057x */
        {
                .sht            = &pdc_ata_sht,
@@ -244,6 +232,7 @@ static const struct pci_device_id pdc_ata_pci_tbl[] = {
        { PCI_VDEVICE(PROMISE, 0x3570), board_2057x },
        { PCI_VDEVICE(PROMISE, 0x3571), board_2057x },
        { PCI_VDEVICE(PROMISE, 0x3574), board_2057x },
+       { PCI_VDEVICE(PROMISE, 0x3577), board_2057x },
        { PCI_VDEVICE(PROMISE, 0x3d73), board_2057x },
        { PCI_VDEVICE(PROMISE, 0x3d75), board_2057x },
 
@@ -256,15 +245,6 @@ static const struct pci_device_id pdc_ata_pci_tbl[] = {
 
        { PCI_VDEVICE(PROMISE, 0x6629), board_20619 },
 
-/* TODO: remove all associated board_20771 code, as it completely
- * duplicates board_2037x code, unless reason for separation can be
- * divined.
- */
-#if 0
-       { PCI_VDEVICE(PROMISE, 0x3570), board_20771 },
-#endif
-       { PCI_VDEVICE(PROMISE, 0x3577), board_20771 },
-
        { }     /* terminate list */
 };
 
@@ -645,9 +625,14 @@ static void pdc_host_init(unsigned int chip_id, struct ata_probe_ent *pe)
 {
        void __iomem *mmio = pe->mmio_base;
        struct pdc_host_priv *hp = pe->private_data;
-       int hotplug_offset = hp->hotplug_offset;
+       int hotplug_offset;
        u32 tmp;
 
+       if (hp->flags & PDC_FLAG_GEN_II)
+               hotplug_offset = PDC2_SATA_PLUG_CSR;
+       else
+               hotplug_offset = PDC_SATA_PLUG_CSR;
+
        /*
         * Except for the hotplug stuff, this is voodoo from the
         * Promise driver.  Label this entire section
@@ -742,8 +727,6 @@ static int pdc_ata_init_one (struct pci_dev *pdev, const struct pci_device_id *e
                goto err_out_free_ent;
        }
 
-       /* Set default hotplug offset */
-       hp->hotplug_offset = PDC_SATA_PLUG_CSR;
        probe_ent->private_data = hp;
 
        probe_ent->sht          = pdc_port_info[board_idx].sht;
@@ -767,8 +750,6 @@ static int pdc_ata_init_one (struct pci_dev *pdev, const struct pci_device_id *e
        switch (board_idx) {
        case board_40518:
                hp->flags |= PDC_FLAG_GEN_II;
-               /* Override hotplug offset for SATAII150 */
-               hp->hotplug_offset = PDC2_SATA_PLUG_CSR;
                /* Fall through */
        case board_20319:
                        probe_ent->n_ports = 4;
@@ -780,10 +761,7 @@ static int pdc_ata_init_one (struct pci_dev *pdev, const struct pci_device_id *e
                probe_ent->port[3].scr_addr = base + 0x700;
                break;
        case board_2057x:
-       case board_20771:
                hp->flags |= PDC_FLAG_GEN_II;
-               /* Override hotplug offset for SATAII150 */
-               hp->hotplug_offset = PDC2_SATA_PLUG_CSR;
                /* Fall through */
        case board_2037x:
                probe_ent->n_ports = 2;