* 'upstream-linus' of master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev:
[PATCH] libata-sff: Allow for wacky systems
[PATCH] ahci: readability tweak
[PATCH] libata: typo fix
[PATCH] ATA must depend on BLOCK
[PATCH] libata: use correct map_db values for ICH8
config ATA
tristate "ATA device support"
+ depends on BLOCK
depends on !(M32R || M68K) || BROKEN
depends on !SUN4 || BROKEN
select SCSI
/* hmmm... a spurious interupt */
/* some devices send D2H reg with I bit set during NCQ command phase */
- if (ap->sactive && status & PORT_IRQ_D2H_REG_FIS)
+ if (ap->sactive && (status & PORT_IRQ_D2H_REG_FIS))
return;
/* ignore interim PIO setup fis interrupts */
.present_shift = 8,
.map = {
/* PM PS SM SS MAP */
- { P0, NA, P1, NA }, /* 00b (hardwired) */
+ { P0, P2, P1, P3 }, /* 00b (hardwired when in AHCI) */
{ RV, RV, RV, RV },
- { RV, RV, RV, RV }, /* 10b (never) */
+ { IDE, IDE, NA, NA }, /* 10b (IDE mode) */
{ RV, RV, RV, RV },
},
};
mask = (1 << 2) | (1 << 0);
if ((tmp8 & mask) != mask)
legacy_mode = (1 << 3);
+#if defined(CONFIG_NO_ATA_LEGACY)
+ /* Some platforms with PCI limits cannot address compat
+ port space. In that case we punt if their firmware has
+ left a device in compatibility mode */
+ if (legacy_mode) {
+ printk(KERN_ERR "ata: Compatibility mode ATA is not supported on this platform, skipping.\n");
+ return -EOPNOTSUPP;
+ }
+#endif
}
rc = pci_request_regions(pdev, DRV_NAME);
ATA_DFLAG_CFG_MASK = (1 << 8) - 1,
ATA_DFLAG_PIO = (1 << 8), /* device limited to PIO mode */
- ATA_DFLAG_NCQ_OFF = (1 << 9), /* devied limited to non-NCQ mode */
+ ATA_DFLAG_NCQ_OFF = (1 << 9), /* device limited to non-NCQ mode */
ATA_DFLAG_SUSPENDED = (1 << 10), /* device suspended */
ATA_DFLAG_INIT_MASK = (1 << 16) - 1,