[SERIAL] sunsab: Get line numbers and table sizing correct.

Table sizing code should look for "se" not "su" nodes.

The chip at the lower address should get the first index.

Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/serial/sunsab.c b/drivers/serial/sunsab.c
index cb55d81..dc673e1 100644 (file)
--- a/drivers/serial/sunsab.c
+++ b/drivers/serial/sunsab.c
@@ -1047,12 +1047,13 @@ static int __devinit sab_probe(struct of_device *op, const struct of_device_id *
        up = &sunsab_ports[inst * 2];
 
        err = sunsab_init_one(&up[0], op,
-                             sizeof(union sab82532_async_regs),
+                             0,
                              (inst * 2) + 0);
        if (err)
                return err;
 
-       err = sunsab_init_one(&up[1], op, 0,
+       err = sunsab_init_one(&up[1], op,
+                             sizeof(union sab82532_async_regs),
                              (inst * 2) + 1);
        if (err) {
                of_iounmap(up[0].port.membase,
@@ -1061,8 +1062,8 @@ static int __devinit sab_probe(struct of_device *op, const struct of_device_id *
                return err;
        }
 
-       uart_add_one_port(&sunsab_reg, &up[1].port);
        uart_add_one_port(&sunsab_reg, &up[0].port);
+       uart_add_one_port(&sunsab_reg, &up[1].port);
 
        dev_set_drvdata(&op->dev, &up[0]);
 
@@ -1117,7 +1118,7 @@ static int __init sunsab_init(void)
        int err;
 
        num_channels = 0;
-       for_each_node_by_name(dp, "su")
+       for_each_node_by_name(dp, "se")
                num_channels += 2;
        for_each_node_by_name(dp, "serial") {
                if (of_device_is_compatible(dp, "sab82532"))