ARM: mvebu: make DTS comments reflect DEBUG_LL changes

The Kconfig symbol DEBUG_MVEBU_UART_ALTERNATE was renamed to
DEBUG_MVEBU_UART0_ALTERNATE. And the symbol DEBUG_MVEBU_UART1_ALTERNATE
was added to allow UART1 as a DEBUG_LL target. Make the comment at the
top of this DTS reflect those changes.

Since we're touching this DTS add comments to show which blocks describe
UART0 and UART1.

Signed-off-by: Paul Bolle <pebolle@tiscali.nl>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>

diff --git a/arch/arm/boot/dts/armada-xp-axpwifiap.dts b/arch/arm/boot/dts/armada-xp-axpwifiap.dts
index ca0200e..28174ab 100644 (file)
--- a/arch/arm/boot/dts/armada-xp-axpwifiap.dts
+++ b/arch/arm/boot/dts/armada-xp-axpwifiap.dts
@@ -3,8 +3,8 @@
  *
  * Note: this board is shipped with a new generation boot loader that
  * remaps internal registers at 0xf1000000. Therefore, if earlyprintk
- * is used, the CONFIG_DEBUG_MVEBU_UART_ALTERNATE option should be
- * used.
+ * is used, the CONFIG_DEBUG_MVEBU_UART0_ALTERNATE option or the
+ * CONFIG_DEBUG_MVEBU_UART1_ALTERNATE option should be used.
  *
  * Copyright (C) 2013 Marvell
  *
@@ -60,10 +60,12 @@
                };
 
                internal-regs {
+                       /* UART0 */
                        serial@12000 {
                                status = "okay";
                        };
 
+                       /* UART1 */
                        serial@12100 {
                                status = "okay";
                        };