mmc: quirks: wl1271 is MMC_QUIRK_DISABLE_CD

The wl12xx device supports disconnecting the pull-up resistor on
CD/DAT[3] (pin 1) of the card.

Tell SDIO core to disconnect that resistor during card init,
since we don't need it at that point (and anyway all
hosts shall provide pull-up resistors on all data lines DAT[3:0]
as described in section 6 of the SD physical specification).

As a result, this may save some power, but it's also generally healthy
since it prevents both ends from pulling up that pin, which
results in undesirable asymmetric physical bus.

Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

diff --git a/drivers/mmc/core/quirks.c b/drivers/mmc/core/quirks.c
index 1957398..a4c42ed 100644 (file)
--- a/drivers/mmc/core/quirks.c
+++ b/drivers/mmc/core/quirks.c
@@ -66,6 +66,8 @@ static const struct mmc_fixup mmc_fixup_methods[] = {
                remove_quirk, MMC_QUIRK_BROKEN_CLK_GATING },
        { SDIO_VENDOR_ID_TI, SDIO_DEVICE_ID_TI_WL1271,
                add_quirk, MMC_QUIRK_NONSTD_FUNC_IF },
+       { SDIO_VENDOR_ID_TI, SDIO_DEVICE_ID_TI_WL1271,
+               add_quirk, MMC_QUIRK_DISABLE_CD },
        { 0 }
 };