If you don't need L2TP, say N. To compile all L2TP code as
modules, choose M here.
+config L2TP_DEBUGFS
+ tristate "L2TP debugfs support"
+ depends on L2TP && DEBUG_FS
+ help
+ Support for l2tp directory in debugfs filesystem. This may be
+ used to dump internal state of the l2tp drivers for problem
+ analysis.
+
+ If unsure, say 'Y'.
+
+ To compile this driver as a module, choose M here. The module
+ will be called l2tp_debugfs.
+
config L2TP_V3
bool "L2TPv3 support (EXPERIMENTAL)"
depends on EXPERIMENTAL && L2TP
To compile this driver as a module, choose M here. The module
will be called l2tp_ip.
+
+config L2TP_ETH
+ tristate "L2TP ethernet pseudowire support for L2TPv3"
+ depends on L2TP_V3
+ help
+ Support for carrying raw ethernet frames over L2TPv3.
+
+ From RFC 4719 <http://www.ietf.org/rfc/rfc4719.txt>.
+
+ The Layer 2 Tunneling Protocol, Version 3 (L2TPv3) can be
+ used as a control protocol and for data encapsulation to set
+ up Pseudowires for transporting layer 2 Packet Data Units
+ across an IP network [RFC3931].
+
+ This driver provides an ethernet virtual interface for each
+ L2TP ethernet pseudowire instance. Standard Linux tools may
+ be used to assign an IP address to the local virtual
+ interface, or add the interface to a bridge.
+
+ If you are using L2TPv3, you will almost certainly want to
+ enable this option.
+
+ To compile this driver as a module, choose M here. The module
+ will be called l2tp_eth.