/*
* include/linux/mg_disk.c
*
- * Support for the mGine m[g]flash IO mode.
- * Based on legacy hd.c
+ * Private data for mflash platform driver
*
* (c) 2008 mGine Co.,LTD
* (c) 2008 unsik Kim <donari75@gmail.com>
#ifndef __MG_DISK_H__
#define __MG_DISK_H__
-#include <linux/blkdev.h>
-#include <linux/ata.h>
-
-/* name for block device */
-#define MG_DISK_NAME "mgd"
/* name for platform device */
#define MG_DEV_NAME "mg_disk"
-#define MG_DISK_MAJ 0
-#define MG_DISK_MAX_PART 16
-#define MG_SECTOR_SIZE 512
-#define MG_MAX_SECTS 256
-
-/* Register offsets */
-#define MG_BUFF_OFFSET 0x8000
-#define MG_STORAGE_BUFFER_SIZE 0x200
-#define MG_REG_OFFSET 0xC000
-#define MG_REG_FEATURE (MG_REG_OFFSET + 2) /* write case */
-#define MG_REG_ERROR (MG_REG_OFFSET + 2) /* read case */
-#define MG_REG_SECT_CNT (MG_REG_OFFSET + 4)
-#define MG_REG_SECT_NUM (MG_REG_OFFSET + 6)
-#define MG_REG_CYL_LOW (MG_REG_OFFSET + 8)
-#define MG_REG_CYL_HIGH (MG_REG_OFFSET + 0xA)
-#define MG_REG_DRV_HEAD (MG_REG_OFFSET + 0xC)
-#define MG_REG_COMMAND (MG_REG_OFFSET + 0xE) /* write case */
-#define MG_REG_STATUS (MG_REG_OFFSET + 0xE) /* read case */
-#define MG_REG_DRV_CTRL (MG_REG_OFFSET + 0x10)
-#define MG_REG_BURST_CTRL (MG_REG_OFFSET + 0x12)
-
-/* "Drive Select/Head Register" bit values */
-#define MG_REG_HEAD_MUST_BE_ON 0xA0 /* These 2 bits are always on */
-#define MG_REG_HEAD_DRIVE_MASTER (0x00 | MG_REG_HEAD_MUST_BE_ON)
-#define MG_REG_HEAD_DRIVE_SLAVE (0x10 | MG_REG_HEAD_MUST_BE_ON)
-#define MG_REG_HEAD_LBA_MODE (0x40 | MG_REG_HEAD_MUST_BE_ON)
-
-
-/* "Device Control Register" bit values */
-#define MG_REG_CTRL_INTR_ENABLE 0x0
-#define MG_REG_CTRL_INTR_DISABLE (0x1<<1)
-#define MG_REG_CTRL_RESET (0x1<<2)
-#define MG_REG_CTRL_INTR_POLA_ACTIVE_HIGH 0x0
-#define MG_REG_CTRL_INTR_POLA_ACTIVE_LOW (0x1<<4)
-#define MG_REG_CTRL_DPD_POLA_ACTIVE_LOW 0x0
-#define MG_REG_CTRL_DPD_POLA_ACTIVE_HIGH (0x1<<5)
-#define MG_REG_CTRL_DPD_DISABLE 0x0
-#define MG_REG_CTRL_DPD_ENABLE (0x1<<6)
-
-/* Status register bit */
-/* error bit in status register */
-#define MG_REG_STATUS_BIT_ERROR 0x01
-/* corrected error in status register */
-#define MG_REG_STATUS_BIT_CORRECTED_ERROR 0x04
-/* data request bit in status register */
-#define MG_REG_STATUS_BIT_DATA_REQ 0x08
-/* DSC - Drive Seek Complete */
-#define MG_REG_STATUS_BIT_SEEK_DONE 0x10
-/* DWF - Drive Write Fault */
-#define MG_REG_STATUS_BIT_WRITE_FAULT 0x20
-#define MG_REG_STATUS_BIT_READY 0x40
-#define MG_REG_STATUS_BIT_BUSY 0x80
-
-/* handy status */
-#define MG_STAT_READY (MG_REG_STATUS_BIT_READY | MG_REG_STATUS_BIT_SEEK_DONE)
-#define MG_READY_OK(s) (((s) & (MG_STAT_READY | \
- (MG_REG_STATUS_BIT_BUSY | \
- MG_REG_STATUS_BIT_WRITE_FAULT | \
- MG_REG_STATUS_BIT_ERROR))) == MG_STAT_READY)
-
-/* Error register */
-#define MG_REG_ERR_AMNF 0x01
-#define MG_REG_ERR_ABRT 0x04
-#define MG_REG_ERR_IDNF 0x10
-#define MG_REG_ERR_UNC 0x40
-#define MG_REG_ERR_BBK 0x80
-
-/* error code for others */
-#define MG_ERR_NONE 0
-#define MG_ERR_TIMEOUT 0x100
-#define MG_ERR_INIT_STAT 0x101
-#define MG_ERR_TRANSLATION 0x102
-#define MG_ERR_CTRL_RST 0x103
-#define MG_ERR_INV_STAT 0x104
-#define MG_ERR_RSTOUT 0x105
-
-#define MG_MAX_ERRORS 6 /* Max read/write errors */
-
-/* command */
-#define MG_CMD_RD 0x20
-#define MG_CMD_WR 0x30
-#define MG_CMD_SLEEP 0x99
-#define MG_CMD_WAKEUP 0xC3
-#define MG_CMD_ID 0xEC
-#define MG_CMD_WR_CONF 0x3C
-#define MG_CMD_RD_CONF 0x40
-
-/* operation mode */
-#define MG_OP_CASCADE (1 << 0)
-#define MG_OP_CASCADE_SYNC_RD (1 << 1)
-#define MG_OP_CASCADE_SYNC_WR (1 << 2)
-#define MG_OP_INTERLEAVE (1 << 3)
-
-/* synchronous */
-#define MG_BURST_LAT_4 (3 << 4)
-#define MG_BURST_LAT_5 (4 << 4)
-#define MG_BURST_LAT_6 (5 << 4)
-#define MG_BURST_LAT_7 (6 << 4)
-#define MG_BURST_LAT_8 (7 << 4)
-#define MG_BURST_LEN_4 (1 << 1)
-#define MG_BURST_LEN_8 (2 << 1)
-#define MG_BURST_LEN_16 (3 << 1)
-#define MG_BURST_LEN_32 (4 << 1)
-#define MG_BURST_LEN_CONT (0 << 1)
-
-/* timeout value (unit: ms) */
-#define MG_TMAX_CONF_TO_CMD 1
-#define MG_TMAX_WAIT_RD_DRQ 10
-#define MG_TMAX_WAIT_WR_DRQ 500
-#define MG_TMAX_RST_TO_BUSY 10
-#define MG_TMAX_HDRST_TO_RDY 500
-#define MG_TMAX_SWRST_TO_RDY 500
-#define MG_TMAX_RSTOUT 3000
+/* names of GPIO resource */
+#define MG_RST_PIN "mg_rst"
+/* except MG_BOOT_DEV, reset-out pin should be assigned */
+#define MG_RSTOUT_PIN "mg_rstout"
/* device attribution */
/* use mflash as boot device */
/* same as MG_STORAGE_DEV, but bootloader already done reset sequence */
#define MG_STORAGE_DEV_SKIP_RST (1 << 2)
-#define MG_DEV_MASK (MG_BOOT_DEV | MG_STORAGE_DEV | MG_STORAGE_DEV_SKIP_RST)
-
-/* names of GPIO resource */
-#define MG_RST_PIN "mg_rst"
-/* except MG_BOOT_DEV, reset-out pin should be assigned */
-#define MG_RSTOUT_PIN "mg_rstout"
-
/* private driver data */
struct mg_drv_data {
/* disk resource */
u32 dev_attr;
/* internally used */
- struct mg_host *host;
+ void *host;
};
-/* main structure for mflash driver */
-struct mg_host {
- struct device *dev;
-
- struct request_queue *breq;
- spinlock_t lock;
- struct gendisk *gd;
-
- struct timer_list timer;
- void (*mg_do_intr) (struct mg_host *);
-
- u16 id[ATA_ID_WORDS];
-
- u16 cyls;
- u16 heads;
- u16 sectors;
- u32 n_sectors;
- u32 nres_sectors;
-
- void __iomem *dev_base;
- unsigned int irq;
- unsigned int rst;
- unsigned int rstout;
-
- u32 major;
- u32 error;
-};
-
-/*
- * Debugging macro and defines
- */
-#undef DO_MG_DEBUG
-#ifdef DO_MG_DEBUG
-# define MG_DBG(fmt, args...) \
- printk(KERN_DEBUG "%s:%d "fmt, __func__, __LINE__, ##args)
-#else /* CONFIG_MG_DEBUG */
-# define MG_DBG(fmt, args...) do { } while (0)
-#endif /* CONFIG_MG_DEBUG */
-
#endif
git.openpandora.org / pandora-kernel.git / blobdiff