/* Device for a quirk */
#define PCI_VENDOR_ID_FRESCO_LOGIC 0x1b73
#define PCI_DEVICE_ID_FRESCO_LOGIC_PDK 0x1000
+#define PCI_DEVICE_ID_FRESCO_LOGIC_FL1400 0x1400
#define PCI_VENDOR_ID_ETRON 0x1b6f
#define PCI_DEVICE_ID_ASROCK_P67 0x7023
+#define PCI_DEVICE_ID_INTEL_LYNXPOINT_XHCI 0x8c31
+#define PCI_DEVICE_ID_INTEL_LYNXPOINT_LP_XHCI 0x9c31
+#define PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI 0x22b5
+#define PCI_DEVICE_ID_INTEL_SUNRISEPOINT_H_XHCI 0xa12f
+#define PCI_DEVICE_ID_INTEL_SUNRISEPOINT_LP_XHCI 0x9d2f
+#define PCI_DEVICE_ID_INTEL_BROXTON_M_XHCI 0x0aa8
+#define PCI_DEVICE_ID_INTEL_BROXTON_B_XHCI 0x1aa8
+
static const char hcd_name[] = "xhci_hcd";
/* called after powerup, by probe or system-pm "wakeup" */
/* Look for vendor-specific quirks */
if (pdev->vendor == PCI_VENDOR_ID_FRESCO_LOGIC &&
- pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK) {
- if (pdev->revision == 0x0) {
+ (pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK ||
+ pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_FL1400)) {
+ if (pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK &&
+ pdev->revision == 0x0) {
xhci->quirks |= XHCI_RESET_EP_QUIRK;
xhci_dbg(xhci, "QUIRK: Fresco Logic xHC needs configure"
" endpoint cmd after reset endpoint\n");
}
+ if (pdev->device == PCI_DEVICE_ID_FRESCO_LOGIC_PDK &&
+ pdev->revision == 0x4) {
+ xhci->quirks |= XHCI_SLOW_SUSPEND;
+ xhci_dbg(xhci,
+ "QUIRK: Fresco Logic xHC revision %u"
+ "must be suspended extra slowly",
+ pdev->revision);
+ }
/* Fresco Logic confirms: all revisions of this chip do not
* support MSI, even though some of them claim to in their PCI
* capabilities.
xhci_dbg(xhci, "QUIRK: Fresco Logic revision %u "
"has broken MSI implementation\n",
pdev->revision);
+ xhci->quirks |= XHCI_TRUST_TX_LENGTH;
}
if (pdev->vendor == PCI_VENDOR_ID_NEC)
/* AMD PLL quirk */
if (pdev->vendor == PCI_VENDOR_ID_AMD && usb_amd_find_chipset_info())
xhci->quirks |= XHCI_AMD_PLL_FIX;
+
+ if (pdev->vendor == PCI_VENDOR_ID_AMD)
+ xhci->quirks |= XHCI_TRUST_TX_LENGTH;
+
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL)
+ xhci->quirks |= XHCI_INTEL_HOST;
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL)
+ xhci->quirks |= XHCI_AVOID_BEI;
if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
pdev->device == PCI_DEVICE_ID_INTEL_PANTHERPOINT_XHCI) {
- xhci->quirks |= XHCI_SPURIOUS_SUCCESS;
xhci->quirks |= XHCI_EP_LIMIT_QUIRK;
xhci->limit_active_eps = 64;
xhci->quirks |= XHCI_SW_BW_CHECKING;
+ /*
+ * PPT desktop boards DH77EB and DH77DF will power back on after
+ * a few seconds of being shutdown. The fix for this is to
+ * switch the ports from xHCI to EHCI on shutdown. We can't use
+ * DMI information to find those particular boards (since each
+ * vendor will change the board name), so we have to key off all
+ * PPT chipsets.
+ */
+ xhci->quirks |= XHCI_SPURIOUS_REBOOT;
+ }
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
+ pdev->device == PCI_DEVICE_ID_INTEL_LYNXPOINT_LP_XHCI) {
+ xhci->quirks |= XHCI_SPURIOUS_REBOOT;
+ xhci->quirks |= XHCI_SPURIOUS_WAKEUP;
+ }
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
+ (pdev->device == PCI_DEVICE_ID_INTEL_SUNRISEPOINT_LP_XHCI ||
+ pdev->device == PCI_DEVICE_ID_INTEL_SUNRISEPOINT_H_XHCI ||
+ pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI ||
+ pdev->device == PCI_DEVICE_ID_INTEL_BROXTON_M_XHCI ||
+ pdev->device == PCI_DEVICE_ID_INTEL_BROXTON_B_XHCI)) {
+ xhci->quirks |= XHCI_PME_STUCK_QUIRK;
}
if (pdev->vendor == PCI_VENDOR_ID_ETRON &&
pdev->device == PCI_DEVICE_ID_ASROCK_P67) {
xhci->quirks |= XHCI_RESET_ON_RESUME;
xhci_dbg(xhci, "QUIRK: Resetting on resume\n");
+ xhci->quirks |= XHCI_TRUST_TX_LENGTH;
}
+ if (pdev->vendor == PCI_VENDOR_ID_VIA)
+ xhci->quirks |= XHCI_RESET_ON_RESUME;
+}
+
+/*
+ * Make sure PME works on some Intel xHCI controllers by writing 1 to clear
+ * the Internal PME flag bit in vendor specific PMCTRL register at offset 0x80a4
+ */
+static void xhci_pme_quirk(struct xhci_hcd *xhci)
+{
+ u32 val;
+ void __iomem *reg;
+
+ reg = (void __iomem *) xhci->cap_regs + 0x80a4;
+ val = readl(reg);
+ writel(val | BIT(28), reg);
+ readl(reg);
}
/* called during probe() after chip reset completes */
usb_remove_hcd(xhci->shared_hcd);
usb_put_hcd(xhci->shared_hcd);
}
+
+ /* Workaround for spurious wakeups at shutdown with HSW */
+ if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
+ pci_set_power_state(dev, PCI_D3hot);
+
usb_hcd_pci_remove(dev);
+
kfree(xhci);
}
xhci->shared_hcd->state != HC_STATE_SUSPENDED)
return -EINVAL;
- retval = xhci_suspend(xhci);
+ if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
+ xhci_pme_quirk(xhci);
+
+ retval = xhci_suspend(xhci, do_wakeup);
return retval;
}
if (usb_is_intel_switchable_xhci(pdev))
usb_enable_xhci_ports(pdev);
+ if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
+ xhci_pme_quirk(xhci);
+
retval = xhci_resume(xhci, hibernated);
return retval;
}
/* suspend and resume implemented later */
.shutdown = usb_hcd_pci_shutdown,
-#ifdef CONFIG_PM_SLEEP
+#ifdef CONFIG_PM
.driver = {
.pm = &usb_hcd_pci_pm_ops
},