#include <pcmcia/cisreg.h>
#include <pcmcia/ds.h>
+#include <linux/completion.h>
+
/* Maximum number of separate DAQP devices we'll allow */
#define MAX_DEV 4
struct local_info_t {
struct pcmcia_device *link;
- dev_node_t node;
int stop;
int table_index;
char board_name[32];
enum { semaphore, buffer } interrupt_mode;
- struct semaphore eos;
+ struct completion eos;
struct comedi_device *dev;
struct comedi_subdevice *s;
/* Interrupt handler
*
* Operates in one of two modes. If local->interrupt_mode is
- * 'semaphore', just signal the local->eos semaphore and return
+ * 'semaphore', just signal the local->eos completion and return
* (one-shot mode). Otherwise (continuous mode), read data in from
* the card, transfer it to the buffer provided by the higher-level
* comedi kernel module, and signal various comedi callback routines,
* which run pretty quick.
*/
-
-static void daqp_interrupt(int irq, void *dev_id)
+static enum irqreturn daqp_interrupt(int irq, void *dev_id)
{
struct local_info_t *local = (struct local_info_t *)dev_id;
struct comedi_device *dev;
if (local == NULL) {
printk(KERN_WARNING
"daqp_interrupt(): irq %d for unknown device.\n", irq);
- return;
+ return IRQ_NONE;
}
dev = local->dev;
if (dev == NULL) {
printk(KERN_WARNING "daqp_interrupt(): NULL comedi_device.\n");
- return;
+ return IRQ_NONE;
}
if (!dev->attached) {
printk(KERN_WARNING
"daqp_interrupt(): struct comedi_device not yet attached.\n");
- return;
+ return IRQ_NONE;
}
s = local->s;
if (s == NULL) {
printk(KERN_WARNING
"daqp_interrupt(): NULL comedi_subdevice.\n");
- return;
+ return IRQ_NONE;
}
if ((struct local_info_t *)s->private != local) {
printk(KERN_WARNING
"daqp_interrupt(): invalid comedi_subdevice.\n");
- return;
+ return IRQ_NONE;
}
switch (local->interrupt_mode) {
case semaphore:
- up(&local->eos);
+ complete(&local->eos);
break;
case buffer:
comedi_event(dev, s);
}
+ return IRQ_HANDLED;
}
/* One-shot analog data acquisition routine */
return -1;
}
- /* Make sure semaphore is blocked */
- sema_init(&local->eos, 0);
+ init_completion(&local->eos);
local->interrupt_mode = semaphore;
local->dev = dev;
local->s = s;
outb(DAQP_COMMAND_ARM | DAQP_COMMAND_FIFO_DATA,
dev->iobase + DAQP_COMMAND);
- /* Wait for interrupt service routine to unblock semaphore */
+ /* Wait for interrupt service routine to unblock completion */
/* Maybe could use a timeout here, but it's interruptible */
- if (down_interruptible(&local->eos))
+ if (wait_for_completion_interruptible(&local->eos))
return -EINTR;
data[i] = inb(dev->iobase + DAQP_FIFO);
{
struct local_info_t *local = (struct local_info_t *)s->private;
struct comedi_cmd *cmd = &s->async->cmd;
- int counter = 100;
+ int counter;
int scanlist_start_on_every_entry;
int threshold;
*/
if (cmd->convert_src == TRIG_TIMER) {
- int counter = daqp_ns_to_timer(&cmd->convert_arg,
+ counter = daqp_ns_to_timer(&cmd->convert_arg,
cmd->flags & TRIG_ROUND_MASK);
outb(counter & 0xff, dev->iobase + DAQP_PACER_LOW);
outb((counter >> 8) & 0xff, dev->iobase + DAQP_PACER_MID);
outb((counter >> 16) & 0xff, dev->iobase + DAQP_PACER_HIGH);
scanlist_start_on_every_entry = 1;
} else {
- int counter = daqp_ns_to_timer(&cmd->scan_begin_arg,
+ counter = daqp_ns_to_timer(&cmd->scan_begin_arg,
cmd->flags & TRIG_ROUND_MASK);
outb(counter & 0xff, dev->iobase + DAQP_PACER_LOW);
outb((counter >> 8) & 0xff, dev->iobase + DAQP_PACER_MID);
/* Reset any pending interrupts (my card has a tendancy to require
* require multiple reads on the status register to achieve this)
*/
-
+ counter = 100;
while (--counter
&& (inb(dev->iobase + DAQP_STATUS) & DAQP_STATUS_EVENTS)) ;
if (!counter) {
local->link = link;
link->priv = local;
- /* Interrupt setup */
- link->irq.Attributes = IRQ_TYPE_DYNAMIC_SHARING;
- link->irq.Handler = daqp_interrupt;
-
/*
General socket configuration defaults can go here. In this
client, we assume very little, and rely on the CIS for almost
dev_dbg(&link->dev, "daqp_cs_detach\n");
- if (link->dev_node) {
- dev->stop = 1;
- daqp_cs_release(link);
- }
+ dev->stop = 1;
+ daqp_cs_release(link);
/* Unlink device structure, and free it */
dev_table[dev->table_index] = NULL;
return -ENODEV;
/* Do we need to allocate an interrupt? */
- if (cfg->irq.IRQInfo1 || dflt->irq.IRQInfo1)
- p_dev->conf.Attributes |= CONF_ENABLE_IRQ;
+ p_dev->conf.Attributes |= CONF_ENABLE_IRQ;
/* IO window settings */
p_dev->io.NumPorts1 = p_dev->io.NumPorts2 = 0;
static void daqp_cs_config(struct pcmcia_device *link)
{
- struct local_info_t *dev = link->priv;
int ret;
dev_dbg(&link->dev, "daqp_cs_config\n");
goto failed;
}
- /*
- Allocate an interrupt line. Note that this does not assign a
- handler to the interrupt, unless the 'Handler' member of the
- irq structure is initialized.
- */
- if (link->conf.Attributes & CONF_ENABLE_IRQ) {
- ret = pcmcia_request_irq(link, &link->irq);
- if (ret)
- goto failed;
- }
+ ret = pcmcia_request_irq(link, daqp_interrupt);
+ if (ret)
+ goto failed;
/*
This actually configures the PCMCIA socket -- setting up
if (ret)
goto failed;
- /*
- At this point, the dev_node_t structure(s) need to be
- initialized and arranged in a linked list at link->dev.
- */
- /* Comedi's PCMCIA script uses this device name (extracted
- * from /var/lib/pcmcia/stab) to pass to comedi_config
- */
- /* sprintf(dev->node.dev_name, "daqp%d", dev->table_index); */
- sprintf(dev->node.dev_name, "quatech_daqp_cs");
- dev->node.major = dev->node.minor = 0;
- link->dev_node = &dev->node;
-
/* Finally, report what we've done */
- printk(KERN_INFO "%s: index 0x%02x",
- dev->node.dev_name, link->conf.ConfigIndex);
+ dev_info(&link->dev, "index 0x%02x", link->conf.ConfigIndex);
if (link->conf.Attributes & CONF_ENABLE_IRQ)
- printk(", irq %u", link->irq.AssignedIRQ);
+ printk(", irq %u", link->irq);
if (link->io.NumPorts1)
printk(", io 0x%04x-0x%04x", link->io.BasePort1,
link->io.BasePort1 + link->io.NumPorts1 - 1);
};
MODULE_DEVICE_TABLE(pcmcia, daqp_cs_id_table);
+MODULE_AUTHOR("Brent Baccala <baccala@freesoft.org>");
+MODULE_DESCRIPTION("Comedi driver for Quatech DAQP PCMCIA data capture cards");
+MODULE_LICENSE("GPL");
-struct pcmcia_driver daqp_cs_driver = {
+static struct pcmcia_driver daqp_cs_driver = {
.probe = daqp_cs_attach,
.remove = daqp_cs_detach,
.suspend = daqp_cs_suspend,
git.openpandora.org / pandora-kernel.git / blobdiff