#include <linux/serial_core.h>
#include <linux/serial.h>
#include <linux/delay.h>
+#include <linux/clk.h>
#include <asm/io.h>
#include <asm/irq.h>
#include <asm/hardware.h>
-#include <asm/hardware/clock.h>
#include <asm/arch/regs-serial.h>
#include <asm/arch/regs-gpio.h>
/* we can support 3 uarts, but not always use them */
+#ifdef CONFIG_CPU_S3C2400
+#define NR_PORTS (2)
+#else
#define NR_PORTS (3)
+#endif
/* port irq numbers */
if (s3c24xx_serial_rx_fifocnt(ourport, ufstat) == 0)
break;
- if (tty->flip.count >= TTY_FLIPBUF_SIZE) {
- if (tty->low_latency)
- tty_flip_buffer_push(tty);
-
- /*
- * If this failed then we will throw away the
- * bytes but must do so to clear interrupts
- */
- }
-
uerstat = rd_regl(port, S3C2410_UERSTAT);
ch = rd_regb(port, S3C2410_URXH);
if (ourport->baudclk != NULL && !IS_ERR(ourport->baudclk)) {
clk_disable(ourport->baudclk);
- clk_unuse(ourport->baudclk);
ourport->baudclk = NULL;
}
- clk_use(clk);
clk_enable(clk);
ourport->clksrc = clksrc;
dbg("resource %p (%lx..%lx)\n", res, res->start, res->end);
port->mapbase = res->start;
- port->membase = S3C24XX_VA_UART + (res->start - S3C2410_PA_UART);
+ port->membase = S3C24XX_VA_UART + (res->start - S3C24XX_PA_UART);
port->irq = platform_get_irq(platdev, 0);
ourport->clk = clk_get(&platdev->dev, "uart");
- if (ourport->clk != NULL && !IS_ERR(ourport->clk))
- clk_use(ourport->clk);
-
dbg("port: map=%08x, mem=%08x, irq=%d, clock=%ld\n",
port->mapbase, port->membase, port->irq, port->uartclk);