#include "trx.h"
#include "led.h"
+static void rtl92c_init_aspm_vars(struct ieee80211_hw *hw)
+{
+ struct rtl_pci *rtlpci = rtl_pcidev(rtl_pcipriv(hw));
+
+ /*close ASPM for AMD defaultly */
+ rtlpci->const_amdpci_aspm = 0;
+
+ /*
+ * ASPM PS mode.
+ * 0 - Disable ASPM,
+ * 1 - Enable ASPM without Clock Req,
+ * 2 - Enable ASPM with Clock Req,
+ * 3 - Alwyas Enable ASPM with Clock Req,
+ * 4 - Always Enable ASPM without Clock Req.
+ * set defult to RTL8192CE:3 RTL8192E:2
+ * */
+ rtlpci->const_pci_aspm = 3;
+
+ /*Setting for PCI-E device */
+ rtlpci->const_devicepci_aspm_setting = 0x03;
+
+ /*Setting for PCI-E bridge */
+ rtlpci->const_hostpci_aspm_setting = 0x02;
+
+ /*
+ * In Hw/Sw Radio Off situation.
+ * 0 - Default,
+ * 1 - From ASPM setting without low Mac Pwr,
+ * 2 - From ASPM setting with low Mac Pwr,
+ * 3 - Bus D3
+ * set default to RTL8192CE:0 RTL8192SE:2
+ */
+ rtlpci->const_hwsw_rfoff_d3 = 0;
+
+ /*
+ * This setting works for those device with
+ * backdoor ASPM setting such as EPHY setting.
+ * 0 - Not support ASPM,
+ * 1 - Support ASPM,
+ * 2 - According to chipset.
+ */
+ rtlpci->const_support_pciaspm = 1;
+}
+
int rtl92c_init_sw_vars(struct ieee80211_hw *hw)
{
+ int err;
struct rtl_priv *rtlpriv = rtl_priv(hw);
struct rtl_pci *rtlpci = rtl_pcidev(rtl_pcipriv(hw));
+ const struct firmware *firmware;
+
+ rtl8192ce_bt_reg_init(hw);
rtlpriv->dm.dm_initialgain_enable = 1;
rtlpriv->dm.dm_flag = 0;
rtlpriv->dm.thermalvalue = 0;
rtlpci->transmit_config = CFENDFORM | BIT(12) | BIT(13);
- rtlpci->receive_config = (RCR_APP_FCS |
+ /* compatible 5G band 88ce just 2.4G band & smsp */
+ rtlpriv->rtlhal.current_bandtype = BAND_ON_2_4G;
+ rtlpriv->rtlhal.bandset = BAND_ON_2_4G;
+ rtlpriv->rtlhal.macphymode = SINGLEMAC_SINGLEPHY;
+
+ rtlpci->receive_config = (RCR_APPFCS |
RCR_AMF |
RCR_ADF |
RCR_APP_MIC |
rtlpci->irq_mask[1] = (u32) (IMR_CPWM | IMR_C2HCMD | 0);
- rtlpriv->rtlhal.pfirmware = (u8 *) vmalloc(0x4000);
+ /* for LPS & IPS */
+ rtlpriv->psc.inactiveps = rtlpriv->cfg->mod_params->inactiveps;
+ rtlpriv->psc.swctrl_lps = rtlpriv->cfg->mod_params->swctrl_lps;
+ rtlpriv->psc.fwctrl_lps = rtlpriv->cfg->mod_params->fwctrl_lps;
+ rtlpriv->psc.reg_fwctrl_lps = 3;
+ rtlpriv->psc.reg_max_lps_awakeintvl = 5;
+ /* for ASPM, you can close aspm through
+ * set const_support_pciaspm = 0 */
+ rtl92c_init_aspm_vars(hw);
+
+ if (rtlpriv->psc.reg_fwctrl_lps == 1)
+ rtlpriv->psc.fwctrl_psmode = FW_PS_MIN_MODE;
+ else if (rtlpriv->psc.reg_fwctrl_lps == 2)
+ rtlpriv->psc.fwctrl_psmode = FW_PS_MAX_MODE;
+ else if (rtlpriv->psc.reg_fwctrl_lps == 3)
+ rtlpriv->psc.fwctrl_psmode = FW_PS_DTIM_MODE;
+
+ /* for firmware buf */
+ rtlpriv->rtlhal.pfirmware = vzalloc(0x4000);
if (!rtlpriv->rtlhal.pfirmware) {
RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
("Can't alloc buffer for fw.\n"));
return 1;
}
+ /* request fw */
+ err = request_firmware(&firmware, rtlpriv->cfg->fw_name,
+ rtlpriv->io.dev);
+ if (err) {
+ RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
+ ("Failed to request firmware!\n"));
+ return 1;
+ }
+ if (firmware->size > 0x4000) {
+ RT_TRACE(rtlpriv, COMP_ERR, DBG_EMERG,
+ ("Firmware is too big!\n"));
+ release_firmware(firmware);
+ return 1;
+ }
+ memcpy(rtlpriv->rtlhal.pfirmware, firmware->data, firmware->size);
+ rtlpriv->rtlhal.fwsize = firmware->size;
+ release_firmware(firmware);
+
return 0;
}
.interrupt_recognized = rtl92ce_interrupt_recognized,
.hw_init = rtl92ce_hw_init,
.hw_disable = rtl92ce_card_disable,
+ .hw_suspend = rtl92ce_suspend,
+ .hw_resume = rtl92ce_resume,
.enable_interrupt = rtl92ce_enable_interrupt,
.disable_interrupt = rtl92ce_disable_interrupt,
.set_network_type = rtl92ce_set_network_type,
+ .set_chk_bssid = rtl92ce_set_check_bssid,
.set_qos = rtl92ce_set_qos,
.set_bcn_reg = rtl92ce_set_beacon_related_registers,
.set_bcn_intv = rtl92ce_set_beacon_interval,
.update_interrupt_mask = rtl92ce_update_interrupt_mask,
.get_hw_reg = rtl92ce_get_hw_reg,
.set_hw_reg = rtl92ce_set_hw_reg,
- .update_rate_table = rtl92ce_update_hal_rate_table,
- .update_rate_mask = rtl92ce_update_hal_rate_mask,
+ .update_rate_tbl = rtl92ce_update_hal_rate_tbl,
.fill_tx_desc = rtl92ce_tx_fill_desc,
.fill_tx_cmddesc = rtl92ce_tx_fill_cmddesc,
.query_rx_desc = rtl92ce_rx_query_desc,
.switch_channel = rtl92c_phy_sw_chnl,
.dm_watchdog = rtl92c_dm_watchdog,
.scan_operation_backup = rtl92c_phy_scan_operation_backup,
- .set_rf_power_state = rtl92ce_phy_set_rf_power_state,
+ .set_rf_power_state = rtl92c_phy_set_rf_power_state,
.led_control = rtl92ce_led_control,
.set_desc = rtl92ce_set_desc,
.get_desc = rtl92ce_get_desc,
.init_sw_leds = rtl92ce_init_sw_leds,
.get_bbreg = rtl92c_phy_query_bb_reg,
.set_bbreg = rtl92c_phy_set_bb_reg,
- .get_rfreg = rtl92ce_phy_query_rf_reg,
.set_rfreg = rtl92ce_phy_set_rf_reg,
- .cmd_send_packet = _rtl92c_cmd_send_packet,
+ .get_rfreg = rtl92c_phy_query_rf_reg,
.phy_rf6052_config = rtl92ce_phy_rf6052_config,
.phy_rf6052_set_cck_txpower = rtl92ce_phy_rf6052_set_cck_txpower,
.phy_rf6052_set_ofdm_txpower = rtl92ce_phy_rf6052_set_ofdm_txpower,
};
static struct rtl_mod_params rtl92ce_mod_params = {
- .sw_crypto = 0,
+ .sw_crypto = false,
+ .inactiveps = true,
+ .swctrl_lps = false,
+ .fwctrl_lps = true,
};
static struct rtl_hal_cfg rtl92ce_hal_cfg = {
+ .bar_id = 2,
+ .write_readback = true,
.name = "rtl92c_pci",
.fw_name = "rtlwifi/rtl8192cfw.bin",
.ops = &rtl8192ce_hal_ops,
.maps[EFUSE_LOADER_CLK_EN] = LOADER_CLK_EN,
.maps[EFUSE_ANA8M] = EFUSE_ANA8M,
.maps[EFUSE_HWSET_MAX_SIZE] = HWSET_MAX_SIZE,
+ .maps[EFUSE_MAX_SECTION_MAP] = EFUSE_MAX_SECTION,
+ .maps[EFUSE_REAL_CONTENT_SIZE] = EFUSE_REAL_CONTENT_LEN,
.maps[RWCAM] = REG_CAMCMD,
.maps[WCAMI] = REG_CAMWRITE,
.maps[RTL_RC_HT_RATEMCS15] = DESC92C_RATEMCS15,
};
-static struct pci_device_id rtl92ce_pci_ids[] __devinitdata = {
+DEFINE_PCI_DEVICE_TABLE(rtl92ce_pci_ids) = {
{RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8191, rtl92ce_hal_cfg)},
{RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8178, rtl92ce_hal_cfg)},
{RTL_PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0x8177, rtl92ce_hal_cfg)},
MODULE_FIRMWARE("rtlwifi/rtl8192cfw.bin");
module_param_named(swenc, rtl92ce_mod_params.sw_crypto, bool, 0444);
+module_param_named(ips, rtl92ce_mod_params.inactiveps, bool, 0444);
+module_param_named(swlps, rtl92ce_mod_params.swctrl_lps, bool, 0444);
+module_param_named(fwlps, rtl92ce_mod_params.fwctrl_lps, bool, 0444);
MODULE_PARM_DESC(swenc, "using hardware crypto (default 0 [hardware])\n");
+MODULE_PARM_DESC(ips, "using no link power save (default 1 is open)\n");
+MODULE_PARM_DESC(fwlps, "using linked fw control power save "
+ "(default 1 is open)\n");
static struct pci_driver rtl92ce_driver = {
.name = KBUILD_MODNAME,
git.openpandora.org / pandora-kernel.git / blobdiff