erp.short_preamble = bss_conf->use_short_preamble;
erp.cts_protection = bss_conf->use_cts_prot;
- erp.ack_timeout = PLCP + get_duration(ACK_SIZE, 10);
- erp.ack_consume_time = SIFS + PLCP + get_duration(ACK_SIZE, 10);
+ erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME;
+ erp.sifs = SIFS;
+ erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS;
+ erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS;
+ erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS;
- if (rt2x00dev->hw->conf.flags & IEEE80211_CONF_SHORT_SLOT_TIME)
- erp.ack_timeout += SHORT_DIFS;
- else
- erp.ack_timeout += DIFS;
+ erp.ack_timeout = PLCP + erp.difs + GET_DURATION(ACK_SIZE, 10);
+ erp.ack_consume_time = SIFS + PLCP + GET_DURATION(ACK_SIZE, 10);
if (bss_conf->use_short_preamble) {
erp.ack_timeout += SHORT_PREAMBLE;
erp.ack_consume_time += PREAMBLE;
}
+ erp.basic_rates = bss_conf->basic_rates;
+
rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp);
}
void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
- enum antenna rx, enum antenna tx)
+ struct antenna_setup *ant)
{
- struct rt2x00lib_conf libconf;
-
- libconf.ant.rx = rx;
- libconf.ant.tx = tx;
+ /*
+ * Failsafe: Make sure we are not sending the
+ * ANTENNA_SW_DIVERSITY state to the driver.
+ * If that happes fallback to hardware default,
+ * or our own default.
+ */
+ if (ant->rx == ANTENNA_SW_DIVERSITY) {
+ if (rt2x00dev->default_ant.rx == ANTENNA_SW_DIVERSITY)
+ ant->rx = ANTENNA_B;
+ else
+ ant->rx = rt2x00dev->default_ant.rx;
+ }
+ if (ant->tx == ANTENNA_SW_DIVERSITY) {
+ if (rt2x00dev->default_ant.tx == ANTENNA_SW_DIVERSITY)
+ ant->tx = ANTENNA_B;
+ else
+ ant->tx = rt2x00dev->default_ant.tx;
+ }
- if (rx == rt2x00dev->link.ant.active.rx &&
- tx == rt2x00dev->link.ant.active.tx)
+ /*
+ * Only reconfigure when something has changed.
+ */
+ if (ant->rx == rt2x00dev->link.ant.active.rx &&
+ ant->tx == rt2x00dev->link.ant.active.tx)
return;
/*
* The latter is required since we need to recalibrate the
* noise-sensitivity ratio for the new setup.
*/
- rt2x00dev->ops->lib->config(rt2x00dev, &libconf, CONFIG_UPDATE_ANTENNA);
+ rt2x00dev->ops->lib->config_ant(rt2x00dev, ant);
+
rt2x00lib_reset_link_tuner(rt2x00dev);
rt2x00_reset_link_ant_rssi(&rt2x00dev->link);
- rt2x00dev->link.ant.active.rx = libconf.ant.rx;
- rt2x00dev->link.ant.active.tx = libconf.ant.tx;
+ memcpy(&rt2x00dev->link.ant.active, ant, sizeof(*ant));
if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON_LINK);
}
-static u32 rt2x00lib_get_basic_rates(struct ieee80211_supported_band *band)
-{
- const struct rt2x00_rate *rate;
- unsigned int i;
- u32 mask = 0;
-
- for (i = 0; i < band->n_bitrates; i++) {
- rate = rt2x00_get_rate(band->bitrates[i].hw_value);
- if (rate->flags & DEV_RATE_BASIC)
- mask |= rate->ratemask;
- }
-
- return mask;
-}
-
void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
- struct ieee80211_conf *conf, const int force_config)
+ struct ieee80211_conf *conf,
+ unsigned int ieee80211_flags)
{
struct rt2x00lib_conf libconf;
- struct ieee80211_supported_band *band;
- struct antenna_setup *default_ant = &rt2x00dev->default_ant;
- struct antenna_setup *active_ant = &rt2x00dev->link.ant.active;
- int flags = 0;
- int short_slot_time;
-
- /*
- * In some situations we want to force all configurations
- * to be reloaded (When resuming for instance).
- */
- if (force_config) {
- flags = CONFIG_UPDATE_ALL;
- goto config;
- }
-
- /*
- * Check which configuration options have been
- * updated and should be send to the device.
- */
- if (rt2x00dev->rx_status.band != conf->channel->band)
- flags |= CONFIG_UPDATE_PHYMODE;
- if (rt2x00dev->rx_status.freq != conf->channel->center_freq)
- flags |= CONFIG_UPDATE_CHANNEL;
- if (rt2x00dev->tx_power != conf->power_level)
- flags |= CONFIG_UPDATE_TXPOWER;
- /*
- * Determining changes in the antenna setups request several checks:
- * antenna_sel_{r,t}x = 0
- * -> Does active_{r,t}x match default_{r,t}x
- * -> Is default_{r,t}x SW_DIVERSITY
- * antenna_sel_{r,t}x = 1/2
- * -> Does active_{r,t}x match antenna_sel_{r,t}x
- * The reason for not updating the antenna while SW diversity
- * should be used is simple: Software diversity means that
- * we should switch between the antenna's based on the
- * quality. This means that the current antenna is good enough
- * to work with untill the link tuner decides that an antenna
- * switch should be performed.
- */
- if (!conf->antenna_sel_rx &&
- default_ant->rx != ANTENNA_SW_DIVERSITY &&
- default_ant->rx != active_ant->rx)
- flags |= CONFIG_UPDATE_ANTENNA;
- else if (conf->antenna_sel_rx &&
- conf->antenna_sel_rx != active_ant->rx)
- flags |= CONFIG_UPDATE_ANTENNA;
- else if (active_ant->rx == ANTENNA_SW_DIVERSITY)
- flags |= CONFIG_UPDATE_ANTENNA;
-
- if (!conf->antenna_sel_tx &&
- default_ant->tx != ANTENNA_SW_DIVERSITY &&
- default_ant->tx != active_ant->tx)
- flags |= CONFIG_UPDATE_ANTENNA;
- else if (conf->antenna_sel_tx &&
- conf->antenna_sel_tx != active_ant->tx)
- flags |= CONFIG_UPDATE_ANTENNA;
- else if (active_ant->tx == ANTENNA_SW_DIVERSITY)
- flags |= CONFIG_UPDATE_ANTENNA;
-
- /*
- * The following configuration options are never
- * stored anywhere and will always be updated.
- */
- flags |= CONFIG_UPDATE_SLOT_TIME;
- flags |= CONFIG_UPDATE_BEACON_INT;
-
- /*
- * We have determined what options should be updated,
- * now precalculate device configuration values depending
- * on what configuration options need to be updated.
- */
-config:
memset(&libconf, 0, sizeof(libconf));
- if (flags & CONFIG_UPDATE_PHYMODE) {
- band = &rt2x00dev->bands[conf->channel->band];
-
- libconf.band = conf->channel->band;
- libconf.basic_rates = rt2x00lib_get_basic_rates(band);
- }
+ libconf.conf = conf;
- if (flags & CONFIG_UPDATE_CHANNEL) {
+ if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) {
memcpy(&libconf.rf,
&rt2x00dev->spec.channels[conf->channel->hw_value],
sizeof(libconf.rf));
sizeof(libconf.channel));
}
- if (flags & CONFIG_UPDATE_ANTENNA) {
- if (conf->antenna_sel_rx)
- libconf.ant.rx = conf->antenna_sel_rx;
- else if (default_ant->rx != ANTENNA_SW_DIVERSITY)
- libconf.ant.rx = default_ant->rx;
- else if (active_ant->rx == ANTENNA_SW_DIVERSITY)
- libconf.ant.rx = ANTENNA_B;
- else
- libconf.ant.rx = active_ant->rx;
-
- if (conf->antenna_sel_tx)
- libconf.ant.tx = conf->antenna_sel_tx;
- else if (default_ant->tx != ANTENNA_SW_DIVERSITY)
- libconf.ant.tx = default_ant->tx;
- else if (active_ant->tx == ANTENNA_SW_DIVERSITY)
- libconf.ant.tx = ANTENNA_B;
- else
- libconf.ant.tx = active_ant->tx;
- }
-
- if (flags & CONFIG_UPDATE_SLOT_TIME) {
- short_slot_time = conf->flags & IEEE80211_CONF_SHORT_SLOT_TIME;
-
- libconf.slot_time =
- short_slot_time ? SHORT_SLOT_TIME : SLOT_TIME;
- libconf.sifs = SIFS;
- libconf.pifs = short_slot_time ? SHORT_PIFS : PIFS;
- libconf.difs = short_slot_time ? SHORT_DIFS : DIFS;
- libconf.eifs = short_slot_time ? SHORT_EIFS : EIFS;
- }
-
- libconf.conf = conf;
-
/*
* Start configuration.
*/
- rt2x00dev->ops->lib->config(rt2x00dev, &libconf, flags);
+ rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags);
/*
* Some configuration changes affect the link quality
* which means we need to reset the link tuner.
*/
- if (flags & (CONFIG_UPDATE_CHANNEL | CONFIG_UPDATE_ANTENNA))
+ if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL)
rt2x00lib_reset_link_tuner(rt2x00dev);
- if (flags & CONFIG_UPDATE_PHYMODE) {
- rt2x00dev->curr_band = conf->channel->band;
- rt2x00dev->rx_status.band = conf->channel->band;
- }
-
- rt2x00dev->rx_status.freq = conf->channel->center_freq;
+ rt2x00dev->curr_band = conf->channel->band;
rt2x00dev->tx_power = conf->power_level;
+ rt2x00dev->short_retry = conf->short_frame_max_tx_count;
+ rt2x00dev->long_retry = conf->long_frame_max_tx_count;
- if (flags & CONFIG_UPDATE_ANTENNA) {
- rt2x00dev->link.ant.active.rx = libconf.ant.rx;
- rt2x00dev->link.ant.active.tx = libconf.ant.tx;
- }
+ rt2x00dev->rx_status.band = conf->channel->band;
+ rt2x00dev->rx_status.freq = conf->channel->center_freq;
}
git.openpandora.org / pandora-kernel.git / blobdiff