static DEFINE_SPINLOCK(ugeth_lock);
-static void uec_configure_serdes(struct net_device *dev);
-
static struct {
u32 msg_enable;
} debug = { -1 };
u8 num_entries,
u32 thread_size,
u32 thread_alignment,
- enum qe_risc_allocation risc,
+ unsigned int risc,
int skip_page_for_first_entry)
{
u32 init_enet_offset;
static int return_init_enet_entries(struct ucc_geth_private *ugeth,
u32 *p_start,
u8 num_entries,
- enum qe_risc_allocation risc,
+ unsigned int risc,
int skip_page_for_first_entry)
{
u32 init_enet_offset;
u32 __iomem *p_start,
u8 num_entries,
u32 thread_size,
- enum qe_risc_allocation risc,
+ unsigned int risc,
int skip_page_for_first_entry)
{
u32 init_enet_offset;
spin_unlock_irqrestore(&ugeth->lock, flags);
}
+/* Initialize TBI PHY interface for communicating with the
+ * SERDES lynx PHY on the chip. We communicate with this PHY
+ * through the MDIO bus on each controller, treating it as a
+ * "normal" PHY at the address found in the UTBIPA register. We assume
+ * that the UTBIPA register is valid. Either the MDIO bus code will set
+ * it to a value that doesn't conflict with other PHYs on the bus, or the
+ * value doesn't matter, as there are no other PHYs on the bus.
+ */
+static void uec_configure_serdes(struct net_device *dev)
+{
+ struct ucc_geth_private *ugeth = netdev_priv(dev);
+ struct ucc_geth_info *ug_info = ugeth->ug_info;
+ struct phy_device *tbiphy;
+
+ if (!ug_info->tbi_node) {
+ dev_warn(&dev->dev, "SGMII mode requires that the device "
+ "tree specify a tbi-handle\n");
+ return;
+ }
+
+ tbiphy = of_phy_find_device(ug_info->tbi_node);
+ if (!tbiphy) {
+ dev_err(&dev->dev, "error: Could not get TBI device\n");
+ return;
+ }
+
+ /*
+ * If the link is already up, we must already be ok, and don't need to
+ * configure and reset the TBI<->SerDes link. Maybe U-Boot configured
+ * everything for us? Resetting it takes the link down and requires
+ * several seconds for it to come back.
+ */
+ if (phy_read(tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS)
+ return;
+
+ /* Single clk mode, mii mode off(for serdes communication) */
+ phy_write(tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS);
+
+ phy_write(tbiphy, ENET_TBI_MII_TBICON, TBICON_CLK_SELECT);
+
+ phy_write(tbiphy, ENET_TBI_MII_CR, TBICR_SETTINGS);
+}
+
/* Configure the PHY for dev.
* returns 0 if success. -1 if failure
*/
return 0;
}
-/* Initialize TBI PHY interface for communicating with the
- * SERDES lynx PHY on the chip. We communicate with this PHY
- * through the MDIO bus on each controller, treating it as a
- * "normal" PHY at the address found in the UTBIPA register. We assume
- * that the UTBIPA register is valid. Either the MDIO bus code will set
- * it to a value that doesn't conflict with other PHYs on the bus, or the
- * value doesn't matter, as there are no other PHYs on the bus.
- */
-static void uec_configure_serdes(struct net_device *dev)
-{
- struct ucc_geth_private *ugeth = netdev_priv(dev);
-
- if (!ugeth->tbiphy) {
- printk(KERN_WARNING "SGMII mode requires that the device "
- "tree specify a tbi-handle\n");
- return;
- }
-
- /*
- * If the link is already up, we must already be ok, and don't need to
- * configure and reset the TBI<->SerDes link. Maybe U-Boot configured
- * everything for us? Resetting it takes the link down and requires
- * several seconds for it to come back.
- */
- if (phy_read(ugeth->tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS)
- return;
-
- /* Single clk mode, mii mode off(for serdes communication) */
- phy_write(ugeth->tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS);
-
- phy_write(ugeth->tbiphy, ENET_TBI_MII_TBICON, TBICON_CLK_SELECT);
-
- phy_write(ugeth->tbiphy, ENET_TBI_MII_CR, TBICR_SETTINGS);
-}
static int ugeth_graceful_stop_tx(struct ucc_geth_private *ugeth)
{
return -ENOMEM;
}
+ /* read the number of risc engines, update the riscTx and riscRx
+ * if there are 4 riscs in QE
+ */
+ if (qe_get_num_of_risc() == 4) {
+ ug_info->riscTx = QE_RISC_ALLOCATION_FOUR_RISCS;
+ ug_info->riscRx = QE_RISC_ALLOCATION_FOUR_RISCS;
+ }
+
ugeth->ug_regs = ioremap(uf_info->regs, sizeof(*ugeth->ug_regs));
if (!ugeth->ug_regs) {
if (netif_msg_probe(ugeth))
}
ug_info->phy_node = phy;
+ /* Find the TBI PHY node. If it's not there, we don't support SGMII */
+ ug_info->tbi_node = of_parse_phandle(np, "tbi-handle", 0);
+
/* get the phy interface type, or default to MII */
prop = of_get_property(np, "phy-connection-type", NULL);
if (!prop) {
ug_info->uf_info.utfet = UCC_GETH_UTFET_GIGA_INIT;
ug_info->uf_info.utftt = UCC_GETH_UTFTT_GIGA_INIT;
ug_info->numThreadsTx = UCC_GETH_NUM_OF_THREADS_4;
- ug_info->numThreadsRx = UCC_GETH_NUM_OF_THREADS_4;
+
+ /* If QE's snum number is 46 which means we need to support
+ * 4 UECs at 1000Base-T simultaneously, we need to allocate
+ * more Threads to Rx.
+ */
+ if (qe_get_num_of_snums() == 46)
+ ug_info->numThreadsRx = UCC_GETH_NUM_OF_THREADS_6;
+ else
+ ug_info->numThreadsRx = UCC_GETH_NUM_OF_THREADS_4;
}
if (netif_msg_probe(&debug))
ugeth->ndev = dev;
ugeth->node = np;
- /* Find the TBI PHY. If it's not there, we don't support SGMII */
- ph = of_get_property(np, "tbi-handle", NULL);
- if (ph) {
- struct device_node *tbi = of_find_node_by_phandle(*ph);
- struct of_device *ofdev;
- struct mii_bus *bus;
- const unsigned int *id;
-
- if (!tbi)
- return 0;
-
- mdio = of_get_parent(tbi);
- if (!mdio)
- return 0;
-
- ofdev = of_find_device_by_node(mdio);
-
- of_node_put(mdio);
-
- id = of_get_property(tbi, "reg", NULL);
- if (!id)
- return 0;
- of_node_put(tbi);
-
- bus = dev_get_drvdata(&ofdev->dev);
- if (!bus)
- return 0;
-
- ugeth->tbiphy = bus->phy_map[*id];
- }
-
return 0;
}
git.openpandora.org / pandora-kernel.git / blobdiff