cxgb3: fix build error when INET=n

[pandora-kernel.git] / drivers / net / Kconfig

diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
index f90a86b..d415d81 100644 (file)
--- a/drivers/net/Kconfig
+++ b/drivers/net/Kconfig
@@ -1273,20 +1273,6 @@ config PCNET32
          To compile this driver as a module, choose M here. The module
          will be called pcnet32.
 
-config PCNET32_NAPI
-       bool "Use RX polling (NAPI)"
-       depends on PCNET32
-       help
-         NAPI is a new driver API designed to reduce CPU and interrupt load
-         when the driver is receiving lots of packets from the card. It is
-         still somewhat experimental and thus not yet enabled by default.
-
-         If your estimated Rx load is 10kpps or more, or if the card will be
-         deployed on potentially unfriendly networks (e.g. in a firewall),
-         then say Y here.
-
-         If in doubt, say N.
-
 config AMD8111_ETH
        tristate "AMD 8111 (new PCI lance) support"
        depends on NET_PCI && PCI
@@ -1684,7 +1670,7 @@ config SUNDANCE_MMIO
 
 config TLAN
        tristate "TI ThunderLAN support"
-       depends on NET_PCI && (PCI || EISA) && !64BIT
+       depends on NET_PCI && (PCI || EISA)
        ---help---
          If you have a PCI Ethernet network card based on the ThunderLAN chip
          which is supported by this driver, say Y and read the
@@ -2242,6 +2228,7 @@ config VIA_VELOCITY
 config TIGON3
        tristate "Broadcom Tigon3 support"
        depends on PCI
+       select PHYLIB
        help
          This driver supports Broadcom Tigon3 based gigabit Ethernet cards.
 
@@ -2421,8 +2408,9 @@ config CHELSIO_T1_NAPI
 
 config CHELSIO_T3
        tristate "Chelsio Communications T3 10Gb Ethernet support"
-       depends on PCI
+       depends on PCI && INET
        select FW_LOADER
+       select INET_LRO
        help
          This driver supports Chelsio T3-based gigabit and 10Gb Ethernet
          adapters.
@@ -2440,7 +2428,7 @@ config CHELSIO_T3
 
 config EHEA
        tristate "eHEA Ethernet support"
-       depends on IBMEBUS && INET && SPARSEMEM
+       depends on IBMEBUS && INET && SPARSEMEM && MEMORY_HOTPLUG
        select INET_LRO
        ---help---
          This driver supports the IBM pSeries eHEA ethernet adapter.
@@ -2593,6 +2581,7 @@ config BNX2X
          To compile this driver as a module, choose M here: the module
          will be called bnx2x.  This is recommended.
 
+source "drivers/net/sfc/Kconfig"
 
 endif # NETDEV_10000