#include <linux/regulator/consumer.h>
#include <linux/pm_runtime.h>
#include <linux/suspend.h>
+#include <linux/fault-inject.h>
+#include <linux/random.h>
#include <linux/mmc/card.h>
#include <linux/mmc/host.h>
flush_workqueue(workqueue);
}
+#ifdef CONFIG_FAIL_MMC_REQUEST
+
+/*
+ * Internal function. Inject random data errors.
+ * If mmc_data is NULL no errors are injected.
+ */
+static void mmc_should_fail_request(struct mmc_host *host,
+ struct mmc_request *mrq)
+{
+ struct mmc_command *cmd = mrq->cmd;
+ struct mmc_data *data = mrq->data;
+ static const int data_errors[] = {
+ -ETIMEDOUT,
+ -EILSEQ,
+ -EIO,
+ };
+
+ if (!data)
+ return;
+
+ if (cmd->error || data->error ||
+ !should_fail(&host->fail_mmc_request, data->blksz * data->blocks))
+ return;
+
+ data->error = data_errors[random32() % ARRAY_SIZE(data_errors)];
+ data->bytes_xfered = (random32() % (data->bytes_xfered >> 9)) << 9;
+}
+
+#else /* CONFIG_FAIL_MMC_REQUEST */
+
+static inline void mmc_should_fail_request(struct mmc_host *host,
+ struct mmc_request *mrq)
+{
+}
+
+#endif /* CONFIG_FAIL_MMC_REQUEST */
+
/**
* mmc_request_done - finish processing an MMC request
* @host: MMC host which completed request
cmd->error = 0;
host->ops->request(host, mrq);
} else {
+ mmc_should_fail_request(host, mrq);
+
led_trigger_event(host->led, LED_OFF);
pr_debug("%s: req done (CMD%u): %d: %08x %08x %08x %08x\n",
if (mrq->done)
mrq->done(mrq);
- mmc_host_clk_gate(host);
+ mmc_host_clk_release(host);
}
}
mrq->stop->mrq = mrq;
}
}
- mmc_host_clk_ungate(host);
+ mmc_host_clk_hold(host);
led_trigger_event(host->led, LED_FULL);
host->ops->request(host, mrq);
}
mmc_wait_for_req_done(host, host->areq->mrq);
err = host->areq->err_check(host->card, host->areq);
if (err) {
+ /* post process the completed failed request */
mmc_post_req(host, host->areq->mrq, 0);
if (areq)
+ /*
+ * Cancel the new prepared request, because
+ * it can't run until the failed
+ * request has been properly handled.
+ */
mmc_post_req(host, areq->mrq, -EINVAL);
host->areq = NULL;
*/
int mmc_wait_for_cmd(struct mmc_host *host, struct mmc_command *cmd, int retries)
{
- struct mmc_request mrq = {0};
+ struct mmc_request mrq = {NULL};
WARN_ON(!host->claimed);
*/
void mmc_set_chip_select(struct mmc_host *host, int mode)
{
+ mmc_host_clk_hold(host);
host->ios.chip_select = mode;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
}
/*
* Sets the host clock to the highest possible frequency that
* is below "hz".
*/
-void mmc_set_clock(struct mmc_host *host, unsigned int hz)
+static void __mmc_set_clock(struct mmc_host *host, unsigned int hz)
{
WARN_ON(hz < host->f_min);
mmc_set_ios(host);
}
+void mmc_set_clock(struct mmc_host *host, unsigned int hz)
+{
+ mmc_host_clk_hold(host);
+ __mmc_set_clock(host, hz);
+ mmc_host_clk_release(host);
+}
+
#ifdef CONFIG_MMC_CLKGATE
/*
* This gates the clock by setting it to 0 Hz.
if (host->clk_old) {
BUG_ON(host->ios.clock);
/* This call will also set host->clk_gated to false */
- mmc_set_clock(host, host->clk_old);
+ __mmc_set_clock(host, host->clk_old);
}
}
*/
void mmc_set_bus_mode(struct mmc_host *host, unsigned int mode)
{
+ mmc_host_clk_hold(host);
host->ios.bus_mode = mode;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
}
/*
*/
void mmc_set_bus_width(struct mmc_host *host, unsigned int width)
{
+ mmc_host_clk_hold(host);
host->ios.bus_width = width;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
}
/**
ocr &= 3 << bit;
+ mmc_host_clk_hold(host);
host->ios.vdd = bit;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
} else {
pr_warning("%s: host doesn't support card's voltages\n",
mmc_hostname(host));
*/
void mmc_set_timing(struct mmc_host *host, unsigned int timing)
{
+ mmc_host_clk_hold(host);
host->ios.timing = timing;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
}
/*
*/
void mmc_set_driver_type(struct mmc_host *host, unsigned int drv_type)
{
+ mmc_host_clk_hold(host);
host->ios.drv_type = drv_type;
mmc_set_ios(host);
+ mmc_host_clk_release(host);
}
/*
{
int bit;
+ mmc_host_clk_hold(host);
+
/* If ocr is set, we use it */
if (host->ocr)
bit = ffs(host->ocr) - 1;
bit = fls(host->ocr_avail) - 1;
host->ios.vdd = bit;
- if (mmc_host_is_spi(host)) {
+ if (mmc_host_is_spi(host))
host->ios.chip_select = MMC_CS_HIGH;
- host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
- } else {
+ else
host->ios.chip_select = MMC_CS_DONTCARE;
- host->ios.bus_mode = MMC_BUSMODE_OPENDRAIN;
- }
+ host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
host->ios.power_mode = MMC_POWER_UP;
host->ios.bus_width = MMC_BUS_WIDTH_1;
host->ios.timing = MMC_TIMING_LEGACY;
* time required to reach a stable voltage.
*/
mmc_delay(10);
+
+ mmc_host_clk_release(host);
}
-static void mmc_power_off(struct mmc_host *host)
+void mmc_power_off(struct mmc_host *host)
{
+ mmc_host_clk_hold(host);
+
host->ios.clock = 0;
host->ios.vdd = 0;
host->ios.bus_width = MMC_BUS_WIDTH_1;
host->ios.timing = MMC_TIMING_LEGACY;
mmc_set_ios(host);
+
+ /*
+ * Some configurations, such as the 802.11 SDIO card in the OLPC
+ * XO-1.5, require a short delay after poweroff before the card
+ * can be successfully turned on again.
+ */
+ mmc_delay(1);
+
+ mmc_host_clk_release(host);
}
/*
}
/*
- * Remove the current bus handler from a host. Assumes that there are
- * no interesting cards left, so the bus is powered down.
+ * Remove the current bus handler from a host.
*/
void mmc_detach_bus(struct mmc_host *host)
{
spin_unlock_irqrestore(&host->lock, flags);
- mmc_power_off(host);
-
mmc_bus_put(host);
}
}
EXPORT_SYMBOL(mmc_set_blocklen);
+static void mmc_hw_reset_for_init(struct mmc_host *host)
+{
+ if (!(host->caps & MMC_CAP_HW_RESET) || !host->ops->hw_reset)
+ return;
+ mmc_host_clk_hold(host);
+ host->ops->hw_reset(host);
+ mmc_host_clk_release(host);
+}
+
+int mmc_can_reset(struct mmc_card *card)
+{
+ u8 rst_n_function;
+
+ if (!mmc_card_mmc(card))
+ return 0;
+ rst_n_function = card->ext_csd.rst_n_function;
+ if ((rst_n_function & EXT_CSD_RST_N_EN_MASK) != EXT_CSD_RST_N_ENABLED)
+ return 0;
+ return 1;
+}
+EXPORT_SYMBOL(mmc_can_reset);
+
+static int mmc_do_hw_reset(struct mmc_host *host, int check)
+{
+ struct mmc_card *card = host->card;
+
+ if (!host->bus_ops->power_restore)
+ return -EOPNOTSUPP;
+
+ if (!(host->caps & MMC_CAP_HW_RESET) || !host->ops->hw_reset)
+ return -EOPNOTSUPP;
+
+ if (!card)
+ return -EINVAL;
+
+ if (!mmc_can_reset(card))
+ return -EOPNOTSUPP;
+
+ mmc_host_clk_hold(host);
+ mmc_set_clock(host, host->f_init);
+
+ host->ops->hw_reset(host);
+
+ /* If the reset has happened, then a status command will fail */
+ if (check) {
+ struct mmc_command cmd = {0};
+ int err;
+
+ cmd.opcode = MMC_SEND_STATUS;
+ if (!mmc_host_is_spi(card->host))
+ cmd.arg = card->rca << 16;
+ cmd.flags = MMC_RSP_SPI_R2 | MMC_RSP_R1 | MMC_CMD_AC;
+ err = mmc_wait_for_cmd(card->host, &cmd, 0);
+ if (!err) {
+ mmc_host_clk_release(host);
+ return -ENOSYS;
+ }
+ }
+
+ host->card->state &= ~(MMC_STATE_HIGHSPEED | MMC_STATE_HIGHSPEED_DDR);
+ if (mmc_host_is_spi(host)) {
+ host->ios.chip_select = MMC_CS_HIGH;
+ host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
+ } else {
+ host->ios.chip_select = MMC_CS_DONTCARE;
+ host->ios.bus_mode = MMC_BUSMODE_OPENDRAIN;
+ }
+ host->ios.bus_width = MMC_BUS_WIDTH_1;
+ host->ios.timing = MMC_TIMING_LEGACY;
+ mmc_set_ios(host);
+
+ mmc_host_clk_release(host);
+
+ return host->bus_ops->power_restore(host);
+}
+
+int mmc_hw_reset(struct mmc_host *host)
+{
+ return mmc_do_hw_reset(host, 0);
+}
+EXPORT_SYMBOL(mmc_hw_reset);
+
+int mmc_hw_reset_check(struct mmc_host *host)
+{
+ return mmc_do_hw_reset(host, 1);
+}
+EXPORT_SYMBOL(mmc_hw_reset_check);
+
static int mmc_rescan_try_freq(struct mmc_host *host, unsigned freq)
{
host->f_init = freq;
#endif
mmc_power_up(host);
+ /*
+ * Some eMMCs (with VCCQ always on) may not be reset after power up, so
+ * do a hardware reset if possible.
+ */
+ mmc_hw_reset_for_init(host);
+
/*
* sdio_reset sends CMD52 to reset card. Since we do not know
* if the card is being re-initialized, just send it. CMD52
mmc_claim_host(host);
mmc_detach_bus(host);
+ mmc_power_off(host);
mmc_release_host(host);
mmc_bus_put(host);
return;
host->bus_ops->remove(host);
mmc_claim_host(host);
mmc_detach_bus(host);
+ mmc_power_off(host);
mmc_release_host(host);
host->pm_flags = 0;
err = 0;
host->bus_ops->remove(host);
mmc_detach_bus(host);
+ mmc_power_off(host);
mmc_release_host(host);
host->pm_flags = 0;
break;