struct pci_dev *pdev = to_pci_dev(hwif->dev);
int controller = drive->dn > 1 ? 1 : 0;
- /* FIXME: if DMA = 1 do we need to set the DMA bit here ? */
-
/* 8bit CAT/CRT - 8bit command timing for channel */
pci_write_config_byte(pdev, 0x62 + controller,
(cs5520_pio_clocks[pio].recovery << 4) |
cs5520_set_pio_mode(drive, 0);
}
-/*
- * We wrap the DMA activate to set the vdma flag. This is needed
- * so that the IDE DMA layer issues PIO not DMA commands over the
- * DMA channel
- *
- * ATAPI is harder so disable it for now using IDE_HFLAG_NO_ATAPI_DMA
- */
-
-static void cs5520_dma_host_set(ide_drive_t *drive, int on)
-{
- drive->vdma = on;
- ide_dma_host_set(drive, on);
-}
-
static const struct ide_port_ops cs5520_port_ops = {
.set_pio_mode = cs5520_set_pio_mode,
.set_dma_mode = cs5520_set_dma_mode,
};
-static const struct ide_dma_ops cs5520_dma_ops = {
- .dma_host_set = cs5520_dma_host_set,
- .dma_setup = ide_dma_setup,
- .dma_exec_cmd = ide_dma_exec_cmd,
- .dma_start = ide_dma_start,
- .dma_end = __ide_dma_end,
- .dma_test_irq = ide_dma_test_irq,
- .dma_lost_irq = ide_dma_lost_irq,
- .dma_timeout = ide_dma_timeout,
-};
-
#define DECLARE_CS_DEV(name_str) \
{ \
.name = name_str, \
.port_ops = &cs5520_port_ops, \
- .dma_ops = &cs5520_dma_ops, \
.host_flags = IDE_HFLAG_ISA_PORTS | \
- IDE_HFLAG_CS5520 | \
- IDE_HFLAG_VDMA | \
- IDE_HFLAG_NO_ATAPI_DMA | \
- IDE_HFLAG_ABUSE_SET_DMA_MODE, \
+ IDE_HFLAG_CS5520, \
.pio_mask = ATA_PIO4, \
}
static int __devinit cs5520_init_one(struct pci_dev *dev, const struct pci_device_id *id)
{
const struct ide_port_info *d = &cyrix_chipsets[id->driver_data];
- u8 idx[4] = { 0xff, 0xff, 0xff, 0xff };
+ hw_regs_t hw[4], *hws[] = { NULL, NULL, NULL, NULL };
ide_setup_pci_noise(dev, d);
* do all the device setup for us
*/
- ide_pci_setup_ports(dev, d, 14, &idx[0]);
-
- ide_device_add(idx, d);
+ ide_pci_setup_ports(dev, d, 14, &hw[0], &hws[0]);
- return 0;
+ return ide_host_add(d, hws, NULL);
}
static const struct pci_device_id cs5520_pci_tbl[] = {