*
* Configure a drive for DMA operation. If DMA is not possible we
* drop the drive into PIO mode instead.
- *
- * FIXME: exactly what are we trying to return here
*/
-
+
static int ali15x3_config_drive_for_dma(ide_drive_t *drive)
{
ide_hwif_t *hwif = HWIF(drive);
struct hd_driveid *id = drive->id;
if ((m5229_revision<=0x20) && (drive->media!=ide_disk))
- return hwif->ide_dma_off_quietly(drive);
+ goto no_dma_set;
drive->init_speed = 0;
ata_pio:
hwif->tuneproc(drive, 255);
no_dma_set:
- return hwif->ide_dma_off_quietly(drive);
+ return -1;
}
- return hwif->ide_dma_on(drive);
+
+ return 0;
}
/**
{
unsigned long flags;
u8 tmpbyte;
- struct pci_dev *north = pci_find_slot(0, PCI_DEVFN(0,0));
+ struct pci_dev *north = pci_get_slot(dev->bus, PCI_DEVFN(0,0));
pci_read_config_byte(dev, PCI_REVISION_ID, &m5229_revision);
- isa_dev = pci_find_device(PCI_VENDOR_ID_AL, PCI_DEVICE_ID_AL_M1533, NULL);
+ isa_dev = pci_get_device(PCI_VENDOR_ID_AL, PCI_DEVICE_ID_AL_M1533, NULL);
#if defined(DISPLAY_ALI_TIMINGS) && defined(CONFIG_PROC_FS)
if (!ali_proc) {
* clear bit 7
*/
pci_write_config_byte(dev, 0x4b, tmpbyte & 0x7F);
- local_irq_restore(flags);
- return 0;
+ goto out;
}
/*
* box without a device at 0:0.0. The ALi bridge will be at
* 0:0.0 so if we didn't find one we know what is cooking.
*/
- if (north && north->vendor != PCI_VENDOR_ID_AL) {
- local_irq_restore(flags);
- return 0;
- }
+ if (north && north->vendor != PCI_VENDOR_ID_AL)
+ goto out;
if (m5229_revision < 0xC5 && isa_dev)
{
pci_write_config_byte(isa_dev, 0x79, tmpbyte | 0x02);
}
}
+out:
+ pci_dev_put(north);
+ pci_dev_put(isa_dev);
local_irq_restore(flags);
return 0;
}
{
if (m5229_revision < 0x20)
return;
- if (!(hwif->channel))
- hwif->OUTB(hwif->INB(dmabase+2) & 0x60, dmabase+2);
+ if (!hwif->channel)
+ outb(inb(dmabase + 2) & 0x60, dmabase + 2);
ide_setup_dma(hwif, dmabase, 8);
}
.probe = alim15x3_init_one,
};
-static int ali15x3_ide_init(void)
+static int __init ali15x3_ide_init(void)
{
return ide_pci_register_driver(&driver);
}