#include <linux/ioport.h>
#include <linux/i2c.h>
#include <linux/init.h>
-#include <linux/apm_bios.h>
#include <linux/dmi.h>
#include <asm/io.h>
-struct sd {
- const unsigned short mfr;
- const unsigned short dev;
- const unsigned char fn;
- const char *name;
-};
-
/* PIIX4 SMBus address offsets */
#define SMBHSTSTS (0 + piix4_smba)
#define SMBHSLVSTS (1 + piix4_smba)
"Forcibly enable the PIIX4 at the given address. "
"EXTREMELY DANGEROUS!");
-static int piix4_transaction(void);
-
static unsigned short piix4_smba;
+static int srvrworks_csb5_delay;
static struct pci_driver piix4_driver;
static struct i2c_adapter piix4_adapter;
-static struct dmi_system_id __devinitdata piix4_dmi_table[] = {
+static struct dmi_system_id __devinitdata piix4_dmi_blacklist[] = {
+ {
+ .ident = "Sapphire AM2RD790",
+ .matches = {
+ DMI_MATCH(DMI_BOARD_VENDOR, "SAPPHIRE Inc."),
+ DMI_MATCH(DMI_BOARD_NAME, "PC-AM2RD790"),
+ },
+ },
+ {
+ .ident = "DFI Lanparty UT 790FX",
+ .matches = {
+ DMI_MATCH(DMI_BOARD_VENDOR, "DFI Inc."),
+ DMI_MATCH(DMI_BOARD_NAME, "LP UT 790FX"),
+ },
+ },
+ { }
+};
+
+/* The IBM entry is in a separate table because we only check it
+ on Intel-based systems */
+static struct dmi_system_id __devinitdata piix4_dmi_ibm[] = {
{
.ident = "IBM",
.matches = { DMI_MATCH(DMI_SYS_VENDOR, "IBM"), },
{
unsigned char temp;
- dev_info(&PIIX4_dev->dev, "Found %s device\n", pci_name(PIIX4_dev));
+ if ((PIIX4_dev->vendor == PCI_VENDOR_ID_SERVERWORKS) &&
+ (PIIX4_dev->device == PCI_DEVICE_ID_SERVERWORKS_CSB5))
+ srvrworks_csb5_delay = 1;
+
+ /* On some motherboards, it was reported that accessing the SMBus
+ caused severe hardware problems */
+ if (dmi_check_system(piix4_dmi_blacklist)) {
+ dev_err(&PIIX4_dev->dev,
+ "Accessing the SMBus on this system is unsafe!\n");
+ return -EPERM;
+ }
/* Don't access SMBus on IBM systems which get corrupted eeproms */
- if (dmi_check_system(piix4_dmi_table) &&
+ if (dmi_check_system(piix4_dmi_ibm) &&
PIIX4_dev->vendor == PCI_VENDOR_ID_INTEL) {
dev_err(&PIIX4_dev->dev, "IBM system detected; this module "
"may corrupt your serial eeprom! Refusing to load "
pci_read_config_word(PIIX4_dev, SMBBA, &piix4_smba);
piix4_smba &= 0xfff0;
if(piix4_smba == 0) {
- dev_err(&PIIX4_dev->dev, "SMB base address "
+ dev_err(&PIIX4_dev->dev, "SMBus base address "
"uninitialized - upgrade BIOS or use "
"force_addr=0xaddr\n");
return -ENODEV;
}
if (!request_region(piix4_smba, SMBIOSIZE, piix4_driver.name)) {
- dev_err(&PIIX4_dev->dev, "SMB region 0x%x already in use!\n",
+ dev_err(&PIIX4_dev->dev, "SMBus region 0x%x already in use!\n",
piix4_smba);
- return -ENODEV;
+ return -EBUSY;
}
pci_read_config_byte(PIIX4_dev, SMBHSTCFG, &temp);
"(or code out of date)!\n");
pci_read_config_byte(PIIX4_dev, SMBREV, &temp);
- dev_dbg(&PIIX4_dev->dev, "SMBREV = 0x%X\n", temp);
- dev_dbg(&PIIX4_dev->dev, "SMBA = 0x%X\n", piix4_smba);
+ dev_info(&PIIX4_dev->dev,
+ "SMBus Host Controller at 0x%x, revision %d\n",
+ piix4_smba, temp);
return 0;
}
-/* Another internally used function */
static int piix4_transaction(void)
{
int temp;
outb_p(temp, SMBHSTSTS);
if ((temp = inb_p(SMBHSTSTS)) != 0x00) {
dev_err(&piix4_adapter.dev, "Failed! (%02x)\n", temp);
- return -1;
+ return -EBUSY;
} else {
- dev_dbg(&piix4_adapter.dev, "Successfull!\n");
+ dev_dbg(&piix4_adapter.dev, "Successful!\n");
}
}
outb_p(inb(SMBHSTCNT) | 0x040, SMBHSTCNT);
/* We will always wait for a fraction of a second! (See PIIX4 docs errata) */
- do {
+ if (srvrworks_csb5_delay) /* Extra delay for SERVERWORKS_CSB5 */
+ msleep(2);
+ else
+ msleep(1);
+
+ while ((timeout++ < MAX_TIMEOUT) &&
+ ((temp = inb_p(SMBHSTSTS)) & 0x01))
msleep(1);
- temp = inb_p(SMBHSTSTS);
- } while ((temp & 0x01) && (timeout++ < MAX_TIMEOUT));
/* If the SMBus is still busy, we give up */
if (timeout >= MAX_TIMEOUT) {
dev_err(&piix4_adapter.dev, "SMBus Timeout!\n");
- result = -1;
+ result = -ETIMEDOUT;
}
if (temp & 0x10) {
- result = -1;
+ result = -EIO;
dev_err(&piix4_adapter.dev, "Error: Failed bus transaction\n");
}
if (temp & 0x08) {
- result = -1;
+ result = -EIO;
dev_dbg(&piix4_adapter.dev, "Bus collision! SMBus may be "
"locked until next hard reset. (sorry!)\n");
/* Clock stops and slave is stuck in mid-transmission */
}
if (temp & 0x04) {
- result = -1;
+ result = -ENXIO;
dev_dbg(&piix4_adapter.dev, "Error: no response!\n");
}
return result;
}
-/* Return -1 on error. */
+/* Return negative errno on error. */
static s32 piix4_access(struct i2c_adapter * adap, u16 addr,
unsigned short flags, char read_write,
u8 command, int size, union i2c_smbus_data * data)
{
int i, len;
+ int status;
switch (size) {
- case I2C_SMBUS_PROC_CALL:
- dev_err(&adap->dev, "I2C_SMBUS_PROC_CALL not supported!\n");
- return -1;
case I2C_SMBUS_QUICK:
- outb_p(((addr & 0x7f) << 1) | (read_write & 0x01),
+ outb_p((addr << 1) | read_write,
SMBHSTADD);
size = PIIX4_QUICK;
break;
case I2C_SMBUS_BYTE:
- outb_p(((addr & 0x7f) << 1) | (read_write & 0x01),
+ outb_p((addr << 1) | read_write,
SMBHSTADD);
if (read_write == I2C_SMBUS_WRITE)
outb_p(command, SMBHSTCMD);
size = PIIX4_BYTE;
break;
case I2C_SMBUS_BYTE_DATA:
- outb_p(((addr & 0x7f) << 1) | (read_write & 0x01),
+ outb_p((addr << 1) | read_write,
SMBHSTADD);
outb_p(command, SMBHSTCMD);
if (read_write == I2C_SMBUS_WRITE)
size = PIIX4_BYTE_DATA;
break;
case I2C_SMBUS_WORD_DATA:
- outb_p(((addr & 0x7f) << 1) | (read_write & 0x01),
+ outb_p((addr << 1) | read_write,
SMBHSTADD);
outb_p(command, SMBHSTCMD);
if (read_write == I2C_SMBUS_WRITE) {
size = PIIX4_WORD_DATA;
break;
case I2C_SMBUS_BLOCK_DATA:
- outb_p(((addr & 0x7f) << 1) | (read_write & 0x01),
+ outb_p((addr << 1) | read_write,
SMBHSTADD);
outb_p(command, SMBHSTCMD);
if (read_write == I2C_SMBUS_WRITE) {
len = data->block[0];
- if (len < 0)
- len = 0;
- if (len > 32)
- len = 32;
+ if (len == 0 || len > I2C_SMBUS_BLOCK_MAX)
+ return -EINVAL;
outb_p(len, SMBHSTDAT0);
i = inb_p(SMBHSTCNT); /* Reset SMBBLKDAT */
for (i = 1; i <= len; i++)
}
size = PIIX4_BLOCK_DATA;
break;
+ default:
+ dev_warn(&adap->dev, "Unsupported transaction %d\n", size);
+ return -EOPNOTSUPP;
}
outb_p((size & 0x1C) + (ENABLE_INT9 & 1), SMBHSTCNT);
- if (piix4_transaction()) /* Error in transaction */
- return -1;
+ status = piix4_transaction();
+ if (status)
+ return status;
if ((read_write == I2C_SMBUS_WRITE) || (size == PIIX4_QUICK))
return 0;
switch (size) {
- case PIIX4_BYTE: /* Where is the result put? I assume here it is in
- SMBHSTDAT0 but it might just as well be in the
- SMBHSTCMD. No clue in the docs */
-
- data->byte = inb_p(SMBHSTDAT0);
- break;
+ case PIIX4_BYTE:
case PIIX4_BYTE_DATA:
data->byte = inb_p(SMBHSTDAT0);
break;
break;
case PIIX4_BLOCK_DATA:
data->block[0] = inb_p(SMBHSTDAT0);
+ if (data->block[0] == 0 || data->block[0] > I2C_SMBUS_BLOCK_MAX)
+ return -EPROTO;
i = inb_p(SMBHSTCNT); /* Reset SMBBLKDAT */
for (i = 1; i <= data->block[0]; i++)
data->block[i] = inb_p(SMBBLKDAT);
static struct i2c_adapter piix4_adapter = {
.owner = THIS_MODULE,
.id = I2C_HW_SMBUS_PIIX4,
- .class = I2C_CLASS_HWMON,
+ .class = I2C_CLASS_HWMON | I2C_CLASS_SPD,
.algo = &smbus_algorithm,
};
git.openpandora.org / pandora-kernel.git / blobdiff