* each GPIO according to various values listed in each entry
*/
- const uint32_t nv50_gpio_reg[4] = { 0xe104, 0xe108, 0xe280, 0xe284 };
+ struct drm_nouveau_private *dev_priv = bios->dev->dev_private;
const uint32_t nv50_gpio_ctl[2] = { 0xe100, 0xe28c };
- const uint8_t *gpio_table = &bios->data[bios->dcb.gpio_table_ptr];
- const uint8_t *gpio_entry;
int i;
- if (!iexec->execute)
- return 1;
-
- if (bios->dcb.version != 0x40) {
- NV_ERROR(bios->dev, "DCB table not version 4.0\n");
- return 0;
+ if (dev_priv->card_type != NV_50) {
+ NV_ERROR(bios->dev, "INIT_GPIO on unsupported chipset\n");
+ return -ENODEV;
}
- if (!bios->dcb.gpio_table_ptr) {
- NV_WARN(bios->dev, "Invalid pointer to INIT_8E table\n");
- return 0;
- }
+ if (!iexec->execute)
+ return 1;
- gpio_entry = gpio_table + gpio_table[1];
- for (i = 0; i < gpio_table[2]; i++, gpio_entry += gpio_table[3]) {
- uint32_t entry = ROM32(gpio_entry[0]), r, s, v;
- int line = (entry & 0x0000001f);
+ for (i = 0; i < bios->dcb.gpio.entries; i++) {
+ struct dcb_gpio_entry *gpio = &bios->dcb.gpio.entry[i];
+ uint32_t r, s, v;
- BIOSLOG(bios, "0x%04X: Entry: 0x%08X\n", offset, entry);
+ BIOSLOG(bios, "0x%04X: Entry: 0x%08X\n", offset, gpio->entry);
- if ((entry & 0x0000ff00) == 0x0000ff00)
- continue;
+ nv50_gpio_set(bios->dev, gpio->tag, gpio->state_default);
- r = nv50_gpio_reg[line >> 3];
- s = (line & 0x07) << 2;
- v = bios_rd32(bios, r) & ~(0x00000003 << s);
- if (entry & 0x01000000)
- v |= (((entry & 0x60000000) >> 29) ^ 2) << s;
- else
- v |= (((entry & 0x18000000) >> 27) ^ 2) << s;
- bios_wr32(bios, r, v);
-
- r = nv50_gpio_ctl[line >> 4];
- s = (line & 0x0f);
+ /* The NVIDIA binary driver doesn't appear to actually do
+ * any of this, my VBIOS does however.
+ */
+ /* Not a clue, needs de-magicing */
+ r = nv50_gpio_ctl[gpio->line >> 4];
+ s = (gpio->line & 0x0f);
v = bios_rd32(bios, r) & ~(0x00010001 << s);
- switch ((entry & 0x06000000) >> 25) {
+ switch ((gpio->entry & 0x06000000) >> 25) {
case 1:
v |= (0x00000001 << s);
break;
struct nvbios *bios = &dev_priv->vbios;
unsigned int outputset = (dcbent->or == 4) ? 1 : 0;
uint16_t scriptptr = 0, clktable;
- uint8_t clktableptr = 0;
/*
* For now we assume version 3.0 table - g80 support will need some
scriptptr = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 11 + outputset * 2]);
break;
case LVDS_RESET:
+ clktable = bios->fp.lvdsmanufacturerpointer + 15;
+ if (dcbent->or == 4)
+ clktable += 8;
+
if (dcbent->lvdsconf.use_straps_for_mode) {
if (bios->fp.dual_link)
- clktableptr += 2;
- if (bios->fp.BITbit1)
- clktableptr++;
+ clktable += 4;
+ if (bios->fp.if_is_24bit)
+ clktable += 2;
} else {
/* using EDID */
- uint8_t fallback = bios->data[bios->fp.lvdsmanufacturerpointer + 4];
- int fallbackcmpval = (dcbent->or == 4) ? 4 : 1;
+ int cmpval_24bit = (dcbent->or == 4) ? 4 : 1;
if (bios->fp.dual_link) {
- clktableptr += 2;
- fallbackcmpval *= 2;
+ clktable += 4;
+ cmpval_24bit <<= 1;
}
- if (fallbackcmpval & fallback)
- clktableptr++;
+
+ if (bios->fp.strapless_is_24bit & cmpval_24bit)
+ clktable += 2;
}
- /* adding outputset * 8 may not be correct */
- clktable = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 15 + clktableptr * 2 + outputset * 8]);
+ clktable = ROM16(bios->data[clktable]);
if (!clktable) {
NV_ERROR(dev, "Pixel clock comparison table not found\n");
return -ENOENT;
*if_is_24bit = bios->data[lvdsofs] & 16;
break;
case 0x30:
- /*
- * My money would be on there being a 24 bit interface bit in
- * this table, but I have no example of a laptop bios with a
- * 24 bit panel to confirm that. Hence we shout loudly if any
- * bit other than bit 0 is set (I've not even seen bit 1)
- */
- if (bios->data[lvdsofs] > 1)
- NV_ERROR(dev,
- "You have a very unusual laptop display; please report it\n");
+ case 0x40:
/*
* No sign of the "power off for reset" or "reset for panel
* on" bits, but it's safer to assume we should
*/
bios->fp.power_off_for_reset = true;
bios->fp.reset_after_pclk_change = true;
+
/*
* It's ok lvdsofs is wrong for nv4x edid case; dual_link is
- * over-written, and BITbit1 isn't used
+ * over-written, and if_is_24bit isn't used
*/
bios->fp.dual_link = bios->data[lvdsofs] & 1;
- bios->fp.BITbit1 = bios->data[lvdsofs] & 2;
- bios->fp.duallink_transition_clk = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 5]) * 10;
- break;
- case 0x40:
- bios->fp.dual_link = bios->data[lvdsofs] & 1;
bios->fp.if_is_24bit = bios->data[lvdsofs] & 2;
bios->fp.strapless_is_24bit = bios->data[bios->fp.lvdsmanufacturerpointer + 4];
bios->fp.duallink_transition_clk = ROM16(bios->data[bios->fp.lvdsmanufacturerpointer + 5]) * 10;
break;
}
+ /* Dell Latitude D620 reports a too-high value for the dual-link
+ * transition freq, causing us to program the panel incorrectly.
+ *
+ * It doesn't appear the VBIOS actually uses its transition freq
+ * (90000kHz), instead it uses the "Number of LVDS channels" field
+ * out of the panel ID structure (http://www.spwg.org/).
+ *
+ * For the moment, a quirk will do :)
+ */
+ if ((dev->pdev->device == 0x01d7) &&
+ (dev->pdev->subsystem_vendor == 0x1028) &&
+ (dev->pdev->subsystem_device == 0x01c2)) {
+ bios->fp.duallink_transition_clk = 80000;
+ }
+
/* set dual_link flag for EDID case */
if (pxclk && (chip_version < 0x25 || chip_version > 0x28))
bios->fp.dual_link = (pxclk >= bios->fp.duallink_transition_clk);
gpio->tag = tag;
gpio->line = line;
gpio->invert = flags != 4;
+ gpio->entry = ent;
}
static void
parse_dcb40_gpio_entry(struct nvbios *bios, uint16_t offset)
{
+ uint32_t entry = ROM32(bios->data[offset]);
struct dcb_gpio_entry *gpio;
- uint32_t ent = ROM32(bios->data[offset]);
- uint8_t line = ent & 0x1f,
- tag = ent >> 8 & 0xff;
- if (tag == 0xff)
+ if ((entry & 0x0000ff00) == 0x0000ff00)
return;
gpio = new_gpio_entry(bios);
-
- /* Currently unused, we may need more fields parsed at some
- * point. */
- gpio->tag = tag;
- gpio->line = line;
+ gpio->tag = (entry & 0x0000ff00) >> 8;
+ gpio->line = (entry & 0x0000001f) >> 0;
+ gpio->state_default = (entry & 0x01000000) >> 24;
+ gpio->state[0] = (entry & 0x18000000) >> 27;
+ gpio->state[1] = (entry & 0x60000000) >> 29;
+ gpio->entry = entry;
}
static void
return type;
}
+static void
+apply_dcb_connector_quirks(struct nvbios *bios, int idx)
+{
+ struct dcb_connector_table_entry *cte = &bios->dcb.connector.entry[idx];
+ struct drm_device *dev = bios->dev;
+
+ /* Gigabyte NX85T */
+ if ((dev->pdev->device == 0x0421) &&
+ (dev->pdev->subsystem_vendor == 0x1458) &&
+ (dev->pdev->subsystem_device == 0x344c)) {
+ if (cte->type == DCB_CONNECTOR_HDMI_1)
+ cte->type = DCB_CONNECTOR_DVI_I;
+ }
+}
+
static void
parse_dcb_connector_table(struct nvbios *bios)
{
entry = conntab + conntab[1];
cte = &ct->entry[0];
for (i = 0; i < conntab[2]; i++, entry += conntab[3], cte++) {
+ cte->index = i;
if (conntab[3] == 2)
cte->entry = ROM16(entry[0]);
else
cte->entry = ROM32(entry[0]);
cte->type = (cte->entry & 0x000000ff) >> 0;
- cte->index = (cte->entry & 0x00000f00) >> 8;
+ cte->index2 = (cte->entry & 0x00000f00) >> 8;
switch (cte->entry & 0x00033000) {
case 0x00001000:
cte->gpio_tag = 0x07;
if (cte->type == 0xff)
continue;
+ apply_dcb_connector_quirks(bios, i);
+
NV_INFO(dev, " %d: 0x%08x: type 0x%02x idx %d tag 0x%02x\n",
i, cte->entry, cte->type, cte->index, cte->gpio_tag);
break;
default:
cte->type = divine_connector_type(bios, cte->index);
- NV_WARN(dev, "unknown type, using 0x%02x", cte->type);
+ NV_WARN(dev, "unknown type, using 0x%02x\n", cte->type);
break;
}
+ if (nouveau_override_conntype) {
+ int type = divine_connector_type(bios, cte->index);
+ if (type != cte->type)
+ NV_WARN(dev, " -> type 0x%02x\n", cte->type);
+ }
+
}
}
git.openpandora.org / pandora-kernel.git / blobdiff