#define DRV_NAME "pata_it821x"
-#define DRV_VERSION "0.3.3"
+#define DRV_VERSION "0.3.4"
struct it821x_dev
{
/* We do need the right mode information for DMA or PIO
and this comes from the current configuration flags */
if (dma_enabled & (1 << (5 + i))) {
+ ata_dev_printk(dev, KERN_INFO, "configured for DMA\n");
dev->xfer_mode = XFER_MW_DMA_0;
dev->xfer_shift = ATA_SHIFT_MWDMA;
dev->flags &= ~ATA_DFLAG_PIO;
} else {
+ ata_dev_printk(dev, KERN_INFO, "configured for PIO\n");
dev->xfer_mode = XFER_PIO_0;
dev->xfer_shift = ATA_SHIFT_PIO;
dev->flags |= ATA_DFLAG_PIO;
/**
* it821x_dev_config - Called each device identify
- * @ap: ATA port
* @adev: Device that has just been identified
*
* Perform the initial setup needed for each device that is chip
* basically we need to filter commands for this chip.
*/
-static void it821x_dev_config(struct ata_port *ap, struct ata_device *adev)
+static void it821x_dev_config(struct ata_device *adev)
{
unsigned char model_num[ATA_ID_PROD_LEN + 1];
.slave_configure = ata_scsi_slave_config,
.slave_destroy = ata_scsi_slave_destroy,
.bios_param = ata_std_bios_param,
+#ifdef CONFIG_PM
.resume = ata_scsi_device_resume,
.suspend = ata_scsi_device_suspend,
+#endif
};
static struct ata_port_operations it821x_smart_port_ops = {
return ata_pci_init_one(pdev, port_info, 2);
}
+#ifdef CONFIG_PM
static int it821x_reinit_one(struct pci_dev *pdev)
{
/* Resume - turn raid back off if need be */
it821x_disable_raid(pdev);
return ata_pci_device_resume(pdev);
}
+#endif
static const struct pci_device_id it821x[] = {
{ PCI_VDEVICE(ITE, PCI_DEVICE_ID_ITE_8211), },
.id_table = it821x,
.probe = it821x_init_one,
.remove = ata_pci_remove_one,
+#ifdef CONFIG_PM
.suspend = ata_pci_device_suspend,
.resume = it821x_reinit_one,
+#endif
};
static int __init it821x_init(void)