#include <asm/asm-offsets.h>
#include <asm/thread_info.h>
#include <asm/processor-flags.h>
-#include <asm/pgtable.h>
/*G:020
- * Our story starts with the kernel booting into startup_32 in
- * arch/x86/kernel/head_32.S. It expects a boot header, which is created by
- * the bootloader (the Launcher in our case).
+
+ * Our story starts with the bzImage: booting starts at startup_32 in
+ * arch/x86/boot/compressed/head_32.S. This merely uncompresses the real
+ * kernel in place and then jumps into it: startup_32 in
+ * arch/x86/kernel/head_32.S. Both routines expects a boot header in the %esi
+ * register, which is created by the bootloader (the Launcher in our case).
*
* The startup_32 function does very little: it clears the uninitialized global
* C variables which we expect to be zero (ie. BSS) and then copies the boot
- * header and kernel command line somewhere safe. Finally it checks the
- * 'hardware_subarch' field. This was introduced in 2.6.24 for lguest and Xen:
- * if it's set to '1' (lguest's assigned number), then it calls us here.
+ * header and kernel command line somewhere safe, and populates some initial
+ * page tables. Finally it checks the 'hardware_subarch' field. This was
+ * introduced in 2.6.24 for lguest and Xen: if it's set to '1' (lguest's
+ * assigned number), then it calls us here.
*
* WARNING: be very careful here! We're running at addresses equal to physical
- * addesses (around 0), not above PAGE_OFFSET as most code expectes
+ * addresses (around 0), not above PAGE_OFFSET as most code expects
* (eg. 0xC0000000). Jumps are relative, so they're OK, but we can't touch any
* data without remembering to subtract __PAGE_OFFSET!
*
.section .init.text, "ax", @progbits
ENTRY(lguest_entry)
/*
- * We make the "initialization" hypercall now to tell the Host about
- * us, and also find out where it put our page tables.
+ * We make the "initialization" hypercall now to tell the Host where
+ * our lguest_data struct is.
*/
movl $LHCALL_LGUEST_INIT, %eax
movl $lguest_data - __PAGE_OFFSET, %ebx
int $LGUEST_TRAP_ENTRY
+ /* Now turn our pagetables on; setup by arch/x86/kernel/head_32.S. */
+ movl $LHCALL_NEW_PGTABLE, %eax
+ movl $(initial_page_table - __PAGE_OFFSET), %ebx
+ int $LGUEST_TRAP_ENTRY
+
/* Set up the initial stack so we can run C code. */
movl $(init_thread_union+THREAD_SIZE),%esp
- call init_pagetables
-
/* Jumps are relative: we're running __PAGE_OFFSET too low. */
jmp lguest_init+__PAGE_OFFSET
-/*
- * Initialize page tables. This creates a PDE and a set of page
- * tables, which are located immediately beyond __brk_base. The variable
- * _brk_end is set up to point to the first "safe" location.
- * Mappings are created both at virtual address 0 (identity mapping)
- * and PAGE_OFFSET for up to _end.
- *
- * FIXME: This code is taken verbatim from arch/x86/kernel/head_32.S: they
- * don't have a stack at this point, so we can't just use call and ret.
- */
-init_pagetables:
-#if PTRS_PER_PMD > 1
-#define PAGE_TABLE_SIZE(pages) (((pages) / PTRS_PER_PMD) + PTRS_PER_PGD)
-#else
-#define PAGE_TABLE_SIZE(pages) ((pages) / PTRS_PER_PGD)
-#endif
-#define pa(X) ((X) - __PAGE_OFFSET)
-
-/* Enough space to fit pagetables for the low memory linear map */
-MAPPING_BEYOND_END = \
- PAGE_TABLE_SIZE(((1<<32) - __PAGE_OFFSET) >> PAGE_SHIFT) << PAGE_SHIFT
-#ifdef CONFIG_X86_PAE
-
- /*
- * In PAE mode initial_page_table is statically defined to contain
- * enough entries to cover the VMSPLIT option (that is the top 1, 2 or 3
- * entries). The identity mapping is handled by pointing two PGD entries
- * to the first kernel PMD.
- *
- * Note the upper half of each PMD or PTE are always zero at this stage.
- */
-
-#define KPMDS (((-__PAGE_OFFSET) >> 30) & 3) /* Number of kernel PMDs */
-
- xorl %ebx,%ebx /* %ebx is kept at zero */
-
- movl $pa(__brk_base), %edi
- movl $pa(initial_pg_pmd), %edx
- movl $PTE_IDENT_ATTR, %eax
-10:
- leal PDE_IDENT_ATTR(%edi),%ecx /* Create PMD entry */
- movl %ecx,(%edx) /* Store PMD entry */
- /* Upper half already zero */
- addl $8,%edx
- movl $512,%ecx
-11:
- stosl
- xchgl %eax,%ebx
- stosl
- xchgl %eax,%ebx
- addl $0x1000,%eax
- loop 11b
-
- /*
- * End condition: we must map up to the end + MAPPING_BEYOND_END.
- */
- movl $pa(_end) + MAPPING_BEYOND_END + PTE_IDENT_ATTR, %ebp
- cmpl %ebp,%eax
- jb 10b
-1:
- addl $__PAGE_OFFSET, %edi
- movl %edi, pa(_brk_end)
- shrl $12, %eax
- movl %eax, pa(max_pfn_mapped)
-
- /* Do early initialization of the fixmap area */
- movl $pa(initial_pg_fixmap)+PDE_IDENT_ATTR,%eax
- movl %eax,pa(initial_pg_pmd+0x1000*KPMDS-8)
-#else /* Not PAE */
-
-page_pde_offset = (__PAGE_OFFSET >> 20);
-
- movl $pa(__brk_base), %edi
- movl $pa(initial_page_table), %edx
- movl $PTE_IDENT_ATTR, %eax
-10:
- leal PDE_IDENT_ATTR(%edi),%ecx /* Create PDE entry */
- movl %ecx,(%edx) /* Store identity PDE entry */
- movl %ecx,page_pde_offset(%edx) /* Store kernel PDE entry */
- addl $4,%edx
- movl $1024, %ecx
-11:
- stosl
- addl $0x1000,%eax
- loop 11b
- /*
- * End condition: we must map up to the end + MAPPING_BEYOND_END.
- */
- movl $pa(_end) + MAPPING_BEYOND_END + PTE_IDENT_ATTR, %ebp
- cmpl %ebp,%eax
- jb 10b
- addl $__PAGE_OFFSET, %edi
- movl %edi, pa(_brk_end)
- shrl $12, %eax
- movl %eax, pa(max_pfn_mapped)
-
- /* Do early initialization of the fixmap area */
- movl $pa(initial_pg_fixmap)+PDE_IDENT_ATTR,%eax
- movl %eax,pa(initial_page_table+0xffc)
-#endif
- ret
-
/*G:055
* We create a macro which puts the assembler code between lgstart_ and lgend_
* markers. These templates are put in the .text section: they can't be
*/
pushl %eax
movl $LHCALL_SEND_INTERRUPTS, %eax
- /*
- * This is a vmcall instruction (same thing that KVM uses). Older
- * assembler versions might not know the "vmcall" instruction, so we
- * create one manually here.
- */
- .byte 0x0f,0x01,0xc1 /* KVM_HYPERCALL */
+ /* This is the actual hypercall trap. */
+ int $LGUEST_TRAP_ENTRY
/* Put eax back the way we found it. */
popl %eax
ret
git.openpandora.org / pandora-kernel.git / blobdiff