#include <linux/apm_bios.h>
#include <linux/initrd.h>
#include <linux/bootmem.h>
+#include <linux/memblock.h>
#include <linux/seq_file.h>
#include <linux/console.h>
#include <linux/mca.h>
static void __init reserve_brk(void)
{
if (_brk_end > _brk_start)
- reserve_early(__pa(_brk_start), __pa(_brk_end), "BRK");
+ memblock_x86_reserve_range(__pa(_brk_start), __pa(_brk_end), "BRK");
/* Mark brk area as locked down and no longer taking any
new allocations */
char *p, *q;
/* We need to move the initrd down into lowmem */
- ramdisk_here = find_e820_area(0, end_of_lowmem, area_size,
+ ramdisk_here = memblock_find_in_range(0, end_of_lowmem, area_size,
PAGE_SIZE);
- if (ramdisk_here == -1ULL)
+ if (ramdisk_here == MEMBLOCK_ERROR)
panic("Cannot find place for new RAMDISK of size %lld\n",
ramdisk_size);
/* Note: this includes all the lowmem currently occupied by
the initrd, we rely on that fact to keep the data intact. */
- reserve_early(ramdisk_here, ramdisk_here + area_size,
- "NEW RAMDISK");
+ memblock_x86_reserve_range(ramdisk_here, ramdisk_here + area_size, "NEW RAMDISK");
initrd_start = ramdisk_here + PAGE_OFFSET;
initrd_end = initrd_start + ramdisk_size;
printk(KERN_INFO "Allocated new RAMDISK: %08llx - %08llx\n",
initrd_start = 0;
if (ramdisk_size >= (end_of_lowmem>>1)) {
- free_early(ramdisk_image, ramdisk_end);
+ memblock_x86_free_range(ramdisk_image, ramdisk_end);
printk(KERN_ERR "initrd too large to handle, "
"disabling initrd\n");
return;
relocate_initrd();
- free_early(ramdisk_image, ramdisk_end);
+ memblock_x86_free_range(ramdisk_image, ramdisk_end);
}
#else
static void __init reserve_initrd(void)
e820_print_map("reserve setup_data");
}
-static void __init reserve_early_setup_data(void)
+static void __init memblock_x86_reserve_range_setup_data(void)
{
struct setup_data *data;
u64 pa_data;
while (pa_data) {
data = early_memremap(pa_data, sizeof(*data));
sprintf(buf, "setup data %x", data->type);
- reserve_early(pa_data, pa_data+sizeof(*data)+data->len, buf);
+ memblock_x86_reserve_range(pa_data, pa_data+sizeof(*data)+data->len, buf);
pa_data = data->next;
early_iounmap(data, sizeof(*data));
}
return total << PAGE_SHIFT;
}
+#define DEFAULT_BZIMAGE_ADDR_MAX 0x37FFFFFF
static void __init reserve_crashkernel(void)
{
unsigned long long total_mem;
if (crash_base <= 0) {
const unsigned long long alignment = 16<<20; /* 16M */
- crash_base = find_e820_area(alignment, ULONG_MAX, crash_size,
- alignment);
- if (crash_base == -1ULL) {
+ /*
+ * kexec want bzImage is below DEFAULT_BZIMAGE_ADDR_MAX
+ */
+ crash_base = memblock_find_in_range(alignment,
+ DEFAULT_BZIMAGE_ADDR_MAX, crash_size, alignment);
+
+ if (crash_base == MEMBLOCK_ERROR) {
pr_info("crashkernel reservation failed - No suitable area found.\n");
return;
}
} else {
unsigned long long start;
- start = find_e820_area(crash_base, ULONG_MAX, crash_size,
- 1<<20);
+ start = memblock_find_in_range(crash_base,
+ crash_base + crash_size, crash_size, 1<<20);
if (start != crash_base) {
pr_info("crashkernel reservation failed - memory is in use.\n");
return;
}
}
- reserve_early(crash_base, crash_base + crash_size, "CRASH KERNEL");
+ memblock_x86_reserve_range(crash_base, crash_base + crash_size, "CRASH KERNEL");
printk(KERN_INFO "Reserving %ldMB of memory at %ldMB "
"for crashkernel (System RAM: %ldMB)\n",
addr = find_ibft_region(&size);
if (size)
- reserve_early_overlap_ok(addr, addr + size, "ibft");
+ memblock_x86_reserve_range(addr, addr + size, "* ibft");
}
static unsigned reserve_low = CONFIG_X86_RESERVE_LOW << 10;
early_param("reservelow", parse_reservelow);
+static u64 __init get_max_mapped(void)
+{
+ u64 end = max_pfn_mapped;
+
+ end <<= PAGE_SHIFT;
+
+ return end;
+}
+
/*
* Determine if we were loaded by an EFI loader. If so, then we have also been
* passed the efi memmap, systab, etc., so we should use these data structures
#ifdef CONFIG_X86_32
memcpy(&boot_cpu_data, &new_cpu_data, sizeof(new_cpu_data));
visws_early_detect();
+
+ /*
+ * copy kernel address range established so far and switch
+ * to the proper swapper page table
+ */
+ clone_pgd_range(swapper_pg_dir + KERNEL_PGD_BOUNDARY,
+ initial_page_table + KERNEL_PGD_BOUNDARY,
+ KERNEL_PGD_PTRS);
+
+ load_cr3(swapper_pg_dir);
+ __flush_tlb_all();
#else
printk(KERN_INFO "Command line: %s\n", boot_command_line);
#endif
#endif
4)) {
efi_enabled = 1;
- efi_reserve_early();
+ efi_memblock_x86_reserve_range();
}
#endif
x86_report_nx();
/* after early param, so could get panic from serial */
- reserve_early_setup_data();
+ memblock_x86_reserve_range_setup_data();
if (acpi_mps_check()) {
#ifdef CONFIG_X86_LOCAL_APIC
*/
max_pfn = e820_end_of_ram_pfn();
- /* preallocate 4k for mptable mpc */
- early_reserve_e820_mpc_new();
/* update e820 for memory not covered by WB MTRRs */
mtrr_bp_init();
if (mtrr_trim_uncached_memory(max_pfn))
max_low_pfn = max_pfn;
high_memory = (void *)__va(max_pfn * PAGE_SIZE - 1) + 1;
- max_pfn_mapped = KERNEL_IMAGE_SIZE >> PAGE_SHIFT;
-#endif
-
-#ifdef CONFIG_X86_CHECK_BIOS_CORRUPTION
- setup_bios_corruption_check();
#endif
- printk(KERN_DEBUG "initial memory mapped : 0 - %08lx\n",
- max_pfn_mapped<<PAGE_SHIFT);
-
- reserve_brk();
-
/*
* Find and reserve possible boot-time SMP configuration:
*/
reserve_ibft_region();
+ /*
+ * Need to conclude brk, before memblock_x86_fill()
+ * it could use memblock_find_in_range, could overlap with
+ * brk area.
+ */
+ reserve_brk();
+
+ memblock.current_limit = get_max_mapped();
+ memblock_x86_fill();
+
+ /* preallocate 4k for mptable mpc */
+ early_reserve_e820_mpc_new();
+
+#ifdef CONFIG_X86_CHECK_BIOS_CORRUPTION
+ setup_bios_corruption_check();
+#endif
+
+ printk(KERN_DEBUG "initial memory mapped : 0 - %08lx\n",
+ max_pfn_mapped<<PAGE_SHIFT);
+
reserve_trampoline_memory();
#ifdef CONFIG_ACPI_SLEEP
max_low_pfn = max_pfn;
}
#endif
+ memblock.current_limit = get_max_mapped();
/*
* NOTE: On x86-32, only from this point on, fixmaps are ready for use.
#endif
initmem_init(0, max_pfn, acpi, k8);
-#ifndef CONFIG_NO_BOOTMEM
- early_res_to_bootmem(0, max_low_pfn<<PAGE_SHIFT);
-#endif
-
+ memblock_find_dma_reserve();
dma32_reserve_bootmem();
#ifdef CONFIG_KVM_CLOCK
paging_init();
x86_init.paging.pagetable_setup_done(swapper_pg_dir);
- setup_trampoline_page_table();
+#ifdef CONFIG_X86_32
+ /* sync back kernel address range */
+ clone_pgd_range(initial_page_table + KERNEL_PGD_BOUNDARY,
+ swapper_pg_dir + KERNEL_PGD_BOUNDARY,
+ KERNEL_PGD_PTRS);
+#endif
tboot_probe();
git.openpandora.org / pandora-kernel.git / blobdiff