extern unsigned long ldt_eoi_space;
#endif
-#ifdef CONFIG_KGDB
-static int kgdb_irq;
-
-/* Default to UART1 */
-int kgdb_port = 1;
-#ifdef CONFIG_SERIAL_SB1250_DUART
-extern char sb1250_duart_present[];
-#endif
-#endif
-
static struct irq_chip sb1250_irq_type = {
.name = "SB1250-IMR",
.ack = ack_sb1250_irq,
}
-static irqreturn_t sb1250_dummy_handler(int irq, void *dev_id)
-{
- return IRQ_NONE;
-}
-
-static struct irqaction sb1250_dummy_action = {
- .handler = sb1250_dummy_handler,
- .flags = 0,
- .mask = CPU_MASK_NONE,
- .name = "sb1250-private",
- .next = NULL,
- .dev_id = 0
-};
-
-int sb1250_steal_irq(int irq)
-{
- struct irq_desc *desc = irq_desc + irq;
- unsigned long flags;
- int retval = 0;
-
- if (irq >= SB1250_NR_IRQS)
- return -EINVAL;
-
- spin_lock_irqsave(&desc->lock, flags);
- /* Don't allow sharing at all for these */
- if (desc->action != NULL)
- retval = -EBUSY;
- else {
- desc->action = &sb1250_dummy_action;
- desc->depth = 0;
- }
- spin_unlock_irqrestore(&desc->lock, flags);
- return 0;
-}
-
/*
* arch_init_irq is called early in the boot sequence from init/main.c via
* init_IRQ. It is responsible for setting up the interrupt mapper and
__raw_writeq(tmp, IOADDR(A_IMR_REGISTER(0, R_IMR_INTERRUPT_MASK)));
__raw_writeq(tmp, IOADDR(A_IMR_REGISTER(1, R_IMR_INTERRUPT_MASK)));
- sb1250_steal_irq(K_INT_MBOX_0);
-
/*
* Note that the timer interrupts are also mapped, but this is
* done in sb1250_time_init(). Also, the profiling driver
* does its own management of IP7.
*/
-#ifdef CONFIG_KGDB
- imask |= STATUSF_IP6;
-#endif
/* Enable necessary IPs, disable the rest */
change_c0_status(ST0_IM, imask);
-
-#ifdef CONFIG_KGDB
- if (kgdb_flag) {
- kgdb_irq = K_INT_UART_0 + kgdb_port;
-
-#ifdef CONFIG_SERIAL_SB1250_DUART
- sb1250_duart_present[kgdb_port] = 0;
-#endif
- /* Setup uart 1 settings, mapper */
- __raw_writeq(M_DUART_IMR_BRK,
- IOADDR(A_DUART_IMRREG(kgdb_port)));
-
- sb1250_steal_irq(kgdb_irq);
- __raw_writeq(IMR_IP6_VAL,
- IOADDR(A_IMR_REGISTER(0,
- R_IMR_INTERRUPT_MAP_BASE) +
- (kgdb_irq << 3)));
- sb1250_unmask_irq(0, kgdb_irq);
- }
-#endif
}
-#ifdef CONFIG_KGDB
-
-#include <linux/delay.h>
-
-#define duart_out(reg, val) csr_out32(val, IOADDR(A_DUART_CHANREG(kgdb_port, reg)))
-#define duart_in(reg) csr_in32(IOADDR(A_DUART_CHANREG(kgdb_port, reg)))
-
-static void sb1250_kgdb_interrupt(void)
-{
- /*
- * Clear break-change status (allow some time for the remote
- * host to stop the break, since we would see another
- * interrupt on the end-of-break too)
- */
- kstat_this_cpu.irqs[kgdb_irq]++;
- mdelay(500);
- duart_out(R_DUART_CMD, V_DUART_MISC_CMD_RESET_BREAK_INT |
- M_DUART_RX_EN | M_DUART_TX_EN);
- set_async_breakpoint(&get_irq_regs()->cp0_epc);
-}
-
-#endif /* CONFIG_KGDB */
+extern void sb1250_mailbox_interrupt(void);
-static inline void sb1250_timer_interrupt(void)
+static inline void dispatch_ip2(void)
{
- int cpu = smp_processor_id();
- int irq = K_INT_TIMER_0 + cpu;
-
- irq_enter();
- kstat_this_cpu.irqs[irq]++;
-
- write_seqlock(&xtime_lock);
-
- /* ACK interrupt */
- ____raw_writeq(M_SCD_TIMER_ENABLE | M_SCD_TIMER_MODE_CONTINUOUS,
- IOADDR(A_SCD_TIMER_REGISTER(cpu, R_SCD_TIMER_CFG)));
+ unsigned int cpu = smp_processor_id();
+ unsigned long long mask;
/*
- * call the generic timer interrupt handling
+ * Default...we've hit an IP[2] interrupt, which means we've got to
+ * check the 1250 interrupt registers to figure out what to do. Need
+ * to detect which CPU we're on, now that smp_affinity is supported.
*/
- do_timer(1);
-
- write_sequnlock(&xtime_lock);
-
- /*
- * In UP mode, we call local_timer_interrupt() to do profiling
- * and process accouting.
- *
- * In SMP mode, local_timer_interrupt() is invoked by appropriate
- * low-level local timer interrupt handler.
- */
- local_timer_interrupt(irq);
-
- irq_exit();
+ mask = __raw_readq(IOADDR(A_IMR_REGISTER(cpu,
+ R_IMR_INTERRUPT_STATUS_BASE)));
+ if (mask)
+ do_IRQ(fls64(mask) - 1);
}
-extern void sb1250_mailbox_interrupt(void);
-
asmlinkage void plat_irq_dispatch(void)
{
+ unsigned int cpu = smp_processor_id();
unsigned int pending;
/*
if (pending & CAUSEF_IP7) /* CPU performance counter interrupt */
do_IRQ(MIPS_CPU_IRQ_BASE + 7);
else if (pending & CAUSEF_IP4)
- sb1250_timer_interrupt();
+ do_IRQ(K_INT_TIMER_0 + cpu); /* sb1250_timer_interrupt() */
#ifdef CONFIG_SMP
else if (pending & CAUSEF_IP3)
sb1250_mailbox_interrupt();
#endif
-#ifdef CONFIG_KGDB
- else if (pending & CAUSEF_IP6) /* KGDB (uart 1) */
- sb1250_kgdb_interrupt();
-#endif
-
- else if (pending & CAUSEF_IP2) {
- unsigned long long mask;
-
- /*
- * Default...we've hit an IP[2] interrupt, which means we've
- * got to check the 1250 interrupt registers to figure out what
- * to do. Need to detect which CPU we're on, now that
- * smp_affinity is supported.
- */
- mask = __raw_readq(IOADDR(A_IMR_REGISTER(smp_processor_id(),
- R_IMR_INTERRUPT_STATUS_BASE)));
- if (mask)
- do_IRQ(fls64(mask) - 1);
- else
- spurious_interrupt();
- } else
+ else if (pending & CAUSEF_IP2)
+ dispatch_ip2();
+ else
spurious_interrupt();
}
git.openpandora.org / pandora-kernel.git / blobdiff