Merge branches 'doc', 'multitouch', 'upstream' and 'upstream-fixes' into for-linus

[pandora-kernel.git] / arch / arm / plat-samsung / include / plat / gpio-cfg.h

diff --git a/arch/arm/plat-samsung/include/plat/gpio-cfg.h b/arch/arm/plat-samsung/include/plat/gpio-cfg.h
index 5e04fa6..1762dcb 100644 (file)
--- a/arch/arm/plat-samsung/include/plat/gpio-cfg.h
+++ b/arch/arm/plat-samsung/include/plat/gpio-cfg.h
@@ -125,7 +125,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
  *
  * These values control the state of the weak pull-{up,down} resistors
  * available on most pins on the S3C series. Not all chips support both
- * up or down settings, and it may be dependant on the chip that is being
+ * up or down settings, and it may be dependent on the chip that is being
  * used to whether the particular mode is available.
  */
 #define S3C_GPIO_PULL_NONE     ((__force s3c_gpio_pull_t)0x00)
@@ -138,7 +138,7 @@ extern int s3c_gpio_cfgpin_range(unsigned int start, unsigned int nr,
  * @pull: The configuration for the pull resistor.
  *
  * This function sets the state of the pull-{up,down} resistor for the
- * specified pin. It will return 0 if successfull, or a negative error
+ * specified pin. It will return 0 if successful, or a negative error
  * code if the pin cannot support the requested pull setting.
  *
  * @pull is one of S3C_GPIO_PULL_NONE, S3C_GPIO_PULL_DOWN or S3C_GPIO_PULL_UP.
@@ -202,7 +202,7 @@ extern s5p_gpio_drvstr_t s5p_gpio_get_drvstr(unsigned int pin);
  * @drvstr: The new value of the driver strength
  *
  * This function sets the driver strength value for the specified pin.
- * It will return 0 if successfull, or a negative error code if the pin
+ * It will return 0 if successful, or a negative error code if the pin
  * cannot support the requested setting.
 */
 extern int s5p_gpio_set_drvstr(unsigned int pin, s5p_gpio_drvstr_t drvstr);