+#else
+ /*
+ * The interrupt numbering scheme is defined in the
+ * interrupt controller spec. To wit:
+ *
+ * Interrupts 0-15 are IPI
+ * 16-28 are reserved
+ * 29-31 are local. We allow 30 to be used for the watchdog.
+ * 32-1020 are global
+ * 1021-1022 are reserved
+ * 1023 is "spurious" (no interrupt)
+ *
+ * For now, we ignore all local interrupts so only return an
+ * interrupt if it's between 30 and 1020. The test_for_ipi
+ * routine below will pick up on IPIs.
+ * A simple read from the controller will tell us the number
+ * of the highest priority enabled interrupt.
+ * We then just need to check whether it is in the
+ * valid range for an IRQ (30-1020 inclusive).
+ */
+ .macro get_irqnr_and_base, irqnr, irqstat, base, tmp
+ ldr \base, =OMAP44XX_VA_GIC_CPU_BASE
+ ldr \irqstat, [\base, #GIC_CPU_INTACK]
+
+ ldr \tmp, =1021
+
+ bic \irqnr, \irqstat, #0x1c00
+
+ cmp \irqnr, #29
+ cmpcc \irqnr, \irqnr
+ cmpne \irqnr, \tmp
+ cmpcs \irqnr, \irqnr
+ .endm
+
+ /* We assume that irqstat (the raw value of the IRQ acknowledge
+ * register) is preserved from the macro above.
+ * If there is an IPI, we immediately signal end of interrupt
+ * on the controller, since this requires the original irqstat
+ * value which we won't easily be able to recreate later.
+ */
+
+ .macro test_for_ipi, irqnr, irqstat, base, tmp
+ bic \irqnr, \irqstat, #0x1c00
+ cmp \irqnr, #16
+ it cc
+ strcc \irqstat, [\base, #GIC_CPU_EOI]
+ it cs
+ cmpcs \irqnr, \irqnr
+ .endm
+
+ /* As above, this assumes that irqstat and base are preserved */
+
+ .macro test_for_ltirq, irqnr, irqstat, base, tmp
+ bic \irqnr, \irqstat, #0x1c00
+ mov \tmp, #0
+ cmp \irqnr, #29
+ itt eq
+ moveq \tmp, #1
+ streq \irqstat, [\base, #GIC_CPU_EOI]
+ cmp \tmp, #0
+ .endm
+#endif