* bit 9..10 - Alternate Function Selection
* bit 11..12 - Pull up/down state
* bit 13 - Sleep mode behaviour
+ * bit 14 - (sleep mode) Direction
+ * bit 15 - (sleep mode) Value (if output)
*
* to facilitate the definition, the following macros are provided
*
* PIN_CFG_DEFAULT - default config (0):
* pull up/down = disabled
- * sleep mode = input
+ * sleep mode = input/wakeup
+ * (sleep mode) direction = input
+ * (sleep mode) value = low
*
* PIN_CFG - default config with alternate function
* PIN_CFG_PULL - default config with alternate function and pull up/down
#define PIN_SLPM_SHIFT 13
#define PIN_SLPM_MASK (0x1 << PIN_SLPM_SHIFT)
#define PIN_SLPM(x) (((x) & PIN_SLPM_MASK) >> PIN_SLPM_SHIFT)
-#define PIN_SLPM_INPUT (NMK_GPIO_SLPM_INPUT << PIN_SLPM_SHIFT)
+#define PIN_SLPM_MAKE_INPUT (NMK_GPIO_SLPM_INPUT << PIN_SLPM_SHIFT)
#define PIN_SLPM_NOCHANGE (NMK_GPIO_SLPM_NOCHANGE << PIN_SLPM_SHIFT)
+/* These two replace the above in DB8500v2+ */
+#define PIN_SLPM_WAKEUP_ENABLE (NMK_GPIO_SLPM_WAKEUP_ENABLE << PIN_SLPM_SHIFT)
+#define PIN_SLPM_WAKEUP_DISABLE (NMK_GPIO_SLPM_WAKEUP_DISABLE << PIN_SLPM_SHIFT)
+
+#define PIN_DIR_SHIFT 14
+#define PIN_DIR_MASK (0x1 << PIN_DIR_SHIFT)
+#define PIN_DIR(x) (((x) & PIN_DIR_MASK) >> PIN_DIR_SHIFT)
+#define PIN_DIR_INPUT (0 << PIN_DIR_SHIFT)
+#define PIN_DIR_OUTPUT (1 << PIN_DIR_SHIFT)
+
+#define PIN_VAL_SHIFT 15
+#define PIN_VAL_MASK (0x1 << PIN_VAL_SHIFT)
+#define PIN_VAL(x) (((x) & PIN_VAL_MASK) >> PIN_VAL_SHIFT)
+#define PIN_VAL_LOW (0 << PIN_VAL_SHIFT)
+#define PIN_VAL_HIGH (1 << PIN_VAL_SHIFT)
+
+/* Shortcuts. Use these instead of separate DIR and VAL. */
+#define PIN_INPUT PIN_DIR_INPUT
+#define PIN_OUTPUT_LOW (PIN_DIR_OUTPUT | PIN_VAL_LOW)
+#define PIN_OUTPUT_HIGH (PIN_DIR_OUTPUT | PIN_VAL_HIGH)
+
+/*
+ * These are the same as the ones above, but should make more sense to the
+ * reader when seen along with a setting a pin to AF mode.
+ */
+#define PIN_SLPM_INPUT PIN_INPUT
+#define PIN_SLPM_OUTPUT_LOW PIN_OUTPUT_LOW
+#define PIN_SLPM_OUTPUT_HIGH PIN_OUTPUT_HIGH
#define PIN_CFG_DEFAULT (PIN_PULL_NONE | PIN_SLPM_INPUT)