*/
#include <linux/init.h>
#include <linux/errno.h>
-#include <linux/delay.h>
-#include <linux/device.h>
-#include <linux/jiffies.h>
#include <linux/smp.h>
#include <linux/io.h>
-#include <asm/cacheflush.h>
-#include <asm/smp_scu.h>
#include <asm/unified.h>
-#include <mach/ct-ca9x4.h>
#include <mach/motherboard.h>
#define V2M_PA_CS7 0x10000000
#include "core.h"
-extern void vexpress_secondary_startup(void);
-
-/*
- * control for which core is the next to come out of the secondary
- * boot "holding pen"
- */
-volatile int __cpuinitdata pen_release = -1;
-
-/*
- * Write pen_release in a way that is guaranteed to be visible to all
- * observers, irrespective of whether they're taking part in coherency
- * or not. This is necessary for the hotplug code to work reliably.
- */
-static void __cpuinit write_pen_release(int val)
-{
- pen_release = val;
- smp_wmb();
- __cpuc_flush_dcache_area((void *)&pen_release, sizeof(pen_release));
- outer_clean_range(__pa(&pen_release), __pa(&pen_release + 1));
-}
-
-static void __iomem *scu_base_addr(void)
-{
- return MMIO_P2V(A9_MPCORE_SCU);
-}
-
-static DEFINE_SPINLOCK(boot_lock);
-
-void __cpuinit platform_secondary_init(unsigned int cpu)
-{
- /*
- * if any interrupts are already enabled for the primary
- * core (e.g. timer irq), then they will not have been enabled
- * for us: do so
- */
- gic_secondary_init(0);
-
- /*
- * let the primary processor know we're out of the
- * pen, then head off into the C entry point
- */
- write_pen_release(-1);
-
- /*
- * Synchronise with the boot thread.
- */
- spin_lock(&boot_lock);
- spin_unlock(&boot_lock);
-}
-
-int __cpuinit boot_secondary(unsigned int cpu, struct task_struct *idle)
-{
- unsigned long timeout;
-
- /*
- * Set synchronisation state between this boot processor
- * and the secondary one
- */
- spin_lock(&boot_lock);
-
- /*
- * This is really belt and braces; we hold unintended secondary
- * CPUs in the holding pen until we're ready for them. However,
- * since we haven't sent them a soft interrupt, they shouldn't
- * be there.
- */
- write_pen_release(cpu);
-
- /*
- * Send the secondary CPU a soft interrupt, thereby causing
- * the boot monitor to read the system wide flags register,
- * and branch to the address found there.
- */
- smp_cross_call(cpumask_of(cpu), 1);
-
- timeout = jiffies + (1 * HZ);
- while (time_before(jiffies, timeout)) {
- smp_rmb();
- if (pen_release == -1)
- break;
-
- udelay(10);
- }
-
- /*
- * now the secondary core is starting up let it run its
- * calibrations, then wait for it to finish
- */
- spin_unlock(&boot_lock);
-
- return pen_release != -1 ? -ENOSYS : 0;
-}
+extern void versatile_secondary_startup(void);
/*
* Initialise the CPU possible map early - this describes the CPUs
*/
void __init smp_init_cpus(void)
{
- void __iomem *scu_base = scu_base_addr();
- unsigned int i, ncores;
-
- ncores = scu_base ? scu_get_core_count(scu_base) : 1;
-
- /* sanity check */
- if (ncores > NR_CPUS) {
- printk(KERN_WARNING
- "vexpress: no. of cores (%d) greater than configured "
- "maximum of %d - clipping\n",
- ncores, NR_CPUS);
- ncores = NR_CPUS;
- }
-
- for (i = 0; i < ncores; i++)
- set_cpu_possible(i, true);
+ ct_desc->init_cpu_map();
}
void __init platform_smp_prepare_cpus(unsigned int max_cpus)
{
- int i;
-
/*
* Initialise the present map, which describes the set of CPUs
* actually populated at the present time.
*/
- for (i = 0; i < max_cpus; i++)
- set_cpu_present(i, true);
-
- scu_enable(scu_base_addr());
+ ct_desc->smp_enable(max_cpus);
/*
* Write the address of secondary startup into the
* secondary CPU branches to this address.
*/
writel(~0, MMIO_P2V(V2M_SYS_FLAGSCLR));
- writel(BSYM(virt_to_phys(vexpress_secondary_startup)),
+ writel(BSYM(virt_to_phys(versatile_secondary_startup)),
MMIO_P2V(V2M_SYS_FLAGSSET));
}
git.openpandora.org / pandora-kernel.git / blobdiff