#include <linux/delay.h>
#include <linux/serial_8250.h>
#include <linux/mtd/mtd.h>
+#include <linux/mtd/physmap.h>
#include <linux/mtd/partitions.h>
#include <asm/types.h>
#include <asm/arch/ohci.h>
#include "generic.h"
+#include "devices.h"
/********************************************************************************************
* ONBOARD FLASH
static struct mtd_partition trizeps4_partitions[] = {
{
.name = "Bootloader",
+ .offset = 0x00000000,
.size = 0x00040000,
- .offset = 0,
.mask_flags = MTD_WRITEABLE /* force read-only */
},{
- .name = "Kernel",
- .size = 0x00400000,
- .offset = 0x00040000
+ .name = "Backup",
+ .offset = 0x00040000,
+ .size = 0x00040000,
+ },{
+ .name = "Image",
+ .offset = 0x00080000,
+ .size = 0x01080000,
+ },{
+ .name = "IPSM",
+ .offset = 0x01100000,
+ .size = 0x00e00000,
},{
- .name = "Filesystem",
+ .name = "Registry",
+ .offset = 0x01f00000,
.size = MTDPART_SIZ_FULL,
- .offset = 0x00440000
}
};
-static struct flash_platform_data trizeps4_flash_data[] = {
+static struct physmap_flash_data trizeps4_flash_data[] = {
{
- .map_name = "cfi_probe",
+ .width = 4, /* bankwidth in bytes */
.parts = trizeps4_partitions,
.nr_parts = ARRAY_SIZE(trizeps4_partitions)
}
static struct resource flash_resource = {
.start = PXA_CS0_PHYS,
- .end = PXA_CS0_PHYS + SZ_64M - 1,
+ .end = PXA_CS0_PHYS + SZ_32M - 1,
.flags = IORESOURCE_MEM,
};
static struct platform_device flash_device = {
- .name = "pxa2xx-flash",
+ .name = "physmap-flash",
.id = 0,
.dev = {
- .platform_data = &trizeps4_flash_data,
+ .platform_data = trizeps4_flash_data,
},
.resource = &flash_resource,
.num_resources = 1,
err = request_irq(TRIZEPS4_MMC_IRQ, mci_detect_int,
IRQF_DISABLED | IRQF_TRIGGER_RISING,
"MMC card detect", data);
- if (err) {
+ if (err)
printk(KERN_ERR "trizeps4_mci_init: MMC/SD: can't request MMC card detect IRQ\n");
- return -1;
- }
- return 0;
+
+ return err;
}
static void trizeps4_mci_exit(struct device *dev, void *data)
.pxafb_backlight_power = board_backlight_power,
};
+static struct pxafb_mode_info toshiba_lcd_mode = {
+ .pixclock = 39720,
+ .xres = 640,
+ .yres = 480,
+ .bpp = 8,
+ .hsync_len = 63,
+ .left_margin = 12,
+ .right_margin = 12,
+ .vsync_len = 4,
+ .upper_margin = 32,
+ .lower_margin = 10,
+ .sync = 0,
+ .cmap_greyscale = 0,
+};
+
+static struct pxafb_mach_info toshiba_lcd = {
+ .modes = &toshiba_lcd_mode,
+ .num_modes = 1,
+ .cmap_inverse = 0,
+ .cmap_static = 0,
+ .lccr0 = LCCR0_Color | LCCR0_Act,
+ .lccr3 = 0x03400002,
+ .pxafb_backlight_power = board_backlight_power,
+};
+
static void __init trizeps4_init(void)
{
platform_add_devices(trizeps4_devices, ARRAY_SIZE(trizeps4_devices));
- set_pxa_fb_info(&sharp_lcd);
+/* set_pxa_fb_info(&sharp_lcd); */
+ set_pxa_fb_info(&toshiba_lcd);
pxa_set_mci_info(&trizeps4_mci_platform_data);
pxa_set_ficp_info(&trizeps4_ficp_platform_data);
/* whats that for ??? */
pxa_gpio_mode(GPIO79_nCS_3_MD);
+#ifdef CONFIG_LEDS
pxa_gpio_mode( GPIO_SYS_BUSY_LED | GPIO_OUT); /* LED1 */
pxa_gpio_mode( GPIO_HEARTBEAT_LED | GPIO_OUT); /* LED2 */
-
+#endif
#ifdef CONFIG_MACH_TRIZEPS4_CONXS
#ifdef CONFIG_IDE_PXA_CF
/* if boot direct from compact flash dont disable power */
.boot_params = TRIZEPS4_SDRAM_BASE + 0x100,
.init_machine = trizeps4_init,
.map_io = trizeps4_map_io,
- .init_irq = pxa_init_irq,
+ .init_irq = pxa27x_init_irq,
.timer = &pxa_timer,
MACHINE_END