#include <asm/arch/orion5x.h>
#include <asm/plat-orion/orion_nand.h>
#include "common.h"
+#include "mpp.h"
/*****************************************************************************
* DB-88F5281 on board devices
.name = "physmap-flash",
.id = 0,
.dev = {
- .platform_data = &db88f5281_boot_flash_data,
+ .platform_data = &db88f5281_boot_flash_data,
},
.num_resources = 1,
.resource = &db88f5281_boot_flash_resource,
.name = "physmap-flash",
.id = 1,
.dev = {
- .platform_data = &db88f5281_nor_flash_data,
+ .platform_data = &db88f5281_nor_flash_data,
},
.num_resources = 1,
.resource = &db88f5281_nor_flash_resource,
.name = "kernel",
.offset = 0,
.size = SZ_2M,
- },
- {
+ }, {
.name = "root",
.offset = SZ_2M,
.size = (SZ_16M - SZ_2M),
- },
- {
+ }, {
.name = "user",
.offset = SZ_16M,
.size = SZ_8M,
- },
- {
+ }, {
.name = "recovery",
.offset = (SZ_16M + SZ_8M),
.size = SZ_8M,
static int __init db88f5281_pci_map_irq(struct pci_dev *dev, u8 slot, u8 pin)
{
+ int irq;
+
/*
- * PCIE IRQ is connected internally (not GPIO)
+ * Check for devices with hard-wired IRQs.
*/
- if (dev->bus->number == orion5x_pcie_local_bus_nr())
- return IRQ_ORION5X_PCIE0_INT;
+ irq = orion5x_pci_map_irq(dev, slot, pin);
+ if (irq != -1)
+ return irq;
/*
- * PCI IRQs are connected via GPIOs
+ * PCI IRQs are connected via GPIOs.
*/
switch (slot - DB88F5281_PCI_SLOT0_OFFS) {
case 0:
****************************************************************************/
static struct mv643xx_eth_platform_data db88f5281_eth_data = {
.phy_addr = 8,
- .force_phy_addr = 1,
};
/*****************************************************************************
* RTC DS1339 on I2C bus
****************************************************************************/
static struct i2c_board_info __initdata db88f5281_i2c_rtc = {
- .driver_name = "rtc-ds1307",
- .type = "ds1339",
- .addr = 0x68,
+ I2C_BOARD_INFO("ds1339", 0x68),
};
/*****************************************************************************
* General Setup
****************************************************************************/
-
-static struct platform_device *db88f5281_devs[] __initdata = {
- &db88f5281_boot_flash,
- &db88f5281_nor_flash,
- &db88f5281_nand_flash,
+static struct orion5x_mpp_mode db88f5281_mpp_modes[] __initdata = {
+ { 0, MPP_GPIO }, /* USB Over Current */
+ { 1, MPP_GPIO }, /* USB Vbat input */
+ { 2, MPP_PCI_ARB }, /* PCI_REQn[2] */
+ { 3, MPP_PCI_ARB }, /* PCI_GNTn[2] */
+ { 4, MPP_PCI_ARB }, /* PCI_REQn[3] */
+ { 5, MPP_PCI_ARB }, /* PCI_GNTn[3] */
+ { 6, MPP_GPIO }, /* JP0, CON17.2 */
+ { 7, MPP_GPIO }, /* JP1, CON17.1 */
+ { 8, MPP_GPIO }, /* JP2, CON11.2 */
+ { 9, MPP_GPIO }, /* JP3, CON11.3 */
+ { 10, MPP_GPIO }, /* RTC int */
+ { 11, MPP_GPIO }, /* Baud Rate Generator */
+ { 12, MPP_GPIO }, /* PCI int 1 */
+ { 13, MPP_GPIO }, /* PCI int 2 */
+ { 14, MPP_NAND }, /* NAND_REn[2] */
+ { 15, MPP_NAND }, /* NAND_WEn[2] */
+ { 16, MPP_UART }, /* UART1_RX */
+ { 17, MPP_UART }, /* UART1_TX */
+ { 18, MPP_UART }, /* UART1_CTSn */
+ { 19, MPP_UART }, /* UART1_RTSn */
+ { -1 },
};
static void __init db88f5281_init(void)
*/
orion5x_init();
+ orion5x_mpp_conf(db88f5281_mpp_modes);
+ writel(0, MPP_DEV_CTRL); /* DEV_D[31:16] */
+
/*
- * Setup the CPU address decode windows for our on-board devices
+ * Configure peripherals.
*/
+ orion5x_ehci0_init();
+ orion5x_eth_init(&db88f5281_eth_data);
+ orion5x_i2c_init();
+ orion5x_uart0_init();
+ orion5x_uart1_init();
+
orion5x_setup_dev_boot_win(DB88F5281_NOR_BOOT_BASE,
DB88F5281_NOR_BOOT_SIZE);
+ platform_device_register(&db88f5281_boot_flash);
+
orion5x_setup_dev0_win(DB88F5281_7SEG_BASE, DB88F5281_7SEG_SIZE);
- orion5x_setup_dev1_win(DB88F5281_NOR_BASE, DB88F5281_NOR_SIZE);
- orion5x_setup_dev2_win(DB88F5281_NAND_BASE, DB88F5281_NAND_SIZE);
- /*
- * Setup Multiplexing Pins:
- * MPP0: GPIO (USB Over Current) MPP1: GPIO (USB Vbat input)
- * MPP2: PCI_REQn[2] MPP3: PCI_GNTn[2]
- * MPP4: PCI_REQn[3] MPP5: PCI_GNTn[3]
- * MPP6: GPIO (JP0, CON17.2) MPP7: GPIO (JP1, CON17.1)
- * MPP8: GPIO (JP2, CON11.2) MPP9: GPIO (JP3, CON11.3)
- * MPP10: GPIO (RTC int) MPP11: GPIO (Baud Rate Generator)
- * MPP12: GPIO (PCI int 1) MPP13: GPIO (PCI int 2)
- * MPP14: NAND_REn[2] MPP15: NAND_WEn[2]
- * MPP16: UART1_RX MPP17: UART1_TX
- * MPP18: UART1_CTS MPP19: UART1_RTS
- * MPP-DEV: DEV_D[16:31]
- */
- orion5x_write(MPP_0_7_CTRL, 0x00222203);
- orion5x_write(MPP_8_15_CTRL, 0x44000000);
- orion5x_write(MPP_16_19_CTRL, 0);
- orion5x_write(MPP_DEV_CTRL, 0);
+ orion5x_setup_dev1_win(DB88F5281_NOR_BASE, DB88F5281_NOR_SIZE);
+ platform_device_register(&db88f5281_nor_flash);
- orion5x_gpio_set_valid_pins(0x00003fc3);
+ orion5x_setup_dev2_win(DB88F5281_NAND_BASE, DB88F5281_NAND_SIZE);
+ platform_device_register(&db88f5281_nand_flash);
- platform_add_devices(db88f5281_devs, ARRAY_SIZE(db88f5281_devs));
i2c_register_board_info(0, &db88f5281_i2c_rtc, 1);
- orion5x_eth_init(&db88f5281_eth_data);
}
MACHINE_START(DB88F5281, "Marvell Orion-2 Development Board")
git.openpandora.org / pandora-kernel.git / blobdiff