.default_device = &sdp3430_lcd_device,
};
-static struct platform_device sdp3430_dss_device = {
- .name = "omapdss",
- .id = -1,
- .dev = {
- .platform_data = &sdp3430_dss_data,
- },
-};
-
-static struct regulator_consumer_supply sdp3430_vdda_dac_supply = {
- .supply = "vdda_dac",
- .dev = &sdp3430_dss_device.dev,
-};
-
-static struct platform_device *sdp3430_devices[] __initdata = {
- &sdp3430_dss_device,
-};
+static struct regulator_consumer_supply sdp3430_vdda_dac_supply =
+ REGULATOR_SUPPLY("vdda_dac", "omapdss");
static struct omap_board_config_kernel sdp3430_config[] __initdata = {
};
-static void __init omap_3430sdp_init_irq(void)
+static void __init omap_3430sdp_init_early(void)
{
- omap_board_config = sdp3430_config;
- omap_board_config_size = ARRAY_SIZE(sdp3430_config);
- omap3_pm_init_cpuidle(omap3_cpuidle_params_table);
omap2_init_common_infrastructure();
omap2_init_common_devices(hyb18m512160af6_sdrc_params, NULL);
- omap_init_irq();
}
static int sdp3430_batt_table[] = {
{} /* Terminator */
};
-static struct regulator_consumer_supply sdp3430_vmmc1_supply = {
- .supply = "vmmc",
-};
-
-static struct regulator_consumer_supply sdp3430_vsim_supply = {
- .supply = "vmmc_aux",
-};
-
-static struct regulator_consumer_supply sdp3430_vmmc2_supply = {
- .supply = "vmmc",
-};
-
static int sdp3430_twl_gpio_setup(struct device *dev,
unsigned gpio, unsigned ngpio)
{
mmc[1].gpio_cd = gpio + 1;
omap2_hsmmc_init(mmc);
- /* link regulators to MMC adapters ... we "know" the
- * regulators will be set up only *after* we return.
- */
- sdp3430_vmmc1_supply.dev = mmc[0].dev;
- sdp3430_vsim_supply.dev = mmc[0].dev;
- sdp3430_vmmc2_supply.dev = mmc[1].dev;
-
/* gpio + 7 is "sub_lcd_en_bkl" (output/PWM1) */
gpio_request(gpio + 7, "sub_lcd_en_bkl");
gpio_direction_output(gpio + 7, 0);
.irq_line = 1,
};
+/* regulator consumer mappings */
+
+/* ads7846 on SPI */
+static struct regulator_consumer_supply sdp3430_vaux3_supplies[] = {
+ REGULATOR_SUPPLY("vcc", "spi1.0"),
+};
+
+static struct regulator_consumer_supply sdp3430_vdda_dac_supplies[] = {
+ REGULATOR_SUPPLY("vdda_dac", "omapdss"),
+};
+
+/* VPLL2 for digital video outputs */
+static struct regulator_consumer_supply sdp3430_vpll2_supplies[] = {
+ REGULATOR_SUPPLY("vdds_dsi", "omapdss"),
+};
+
+static struct regulator_consumer_supply sdp3430_vmmc1_supplies[] = {
+ REGULATOR_SUPPLY("vmmc", "omap_hsmmc.0"),
+};
+
+static struct regulator_consumer_supply sdp3430_vsim_supplies[] = {
+ REGULATOR_SUPPLY("vmmc_aux", "omap_hsmmc.0"),
+};
+
+static struct regulator_consumer_supply sdp3430_vmmc2_supplies[] = {
+ REGULATOR_SUPPLY("vmmc", "omap_hsmmc.1"),
+};
+
/*
* Apply all the fixed voltages since most versions of U-Boot
* don't bother with that initialization.
.valid_ops_mask = REGULATOR_CHANGE_MODE
| REGULATOR_CHANGE_STATUS,
},
+ .num_consumer_supplies = ARRAY_SIZE(sdp3430_vaux3_supplies),
+ .consumer_supplies = sdp3430_vaux3_supplies,
};
/* VAUX4 for OMAP VDD_CSI2 (camera) */
| REGULATOR_CHANGE_MODE
| REGULATOR_CHANGE_STATUS,
},
- .num_consumer_supplies = 1,
- .consumer_supplies = &sdp3430_vmmc1_supply,
+ .num_consumer_supplies = ARRAY_SIZE(sdp3430_vmmc1_supplies),
+ .consumer_supplies = sdp3430_vmmc1_supplies,
};
/* VMMC2 for MMC2 card */
.valid_ops_mask = REGULATOR_CHANGE_MODE
| REGULATOR_CHANGE_STATUS,
},
- .num_consumer_supplies = 1,
- .consumer_supplies = &sdp3430_vmmc2_supply,
+ .num_consumer_supplies = ARRAY_SIZE(sdp3430_vmmc2_supplies),
+ .consumer_supplies = sdp3430_vmmc2_supplies,
};
/* VSIM for OMAP VDD_MMC1A (i/o for DAT4..DAT7) */
| REGULATOR_CHANGE_MODE
| REGULATOR_CHANGE_STATUS,
},
- .num_consumer_supplies = 1,
- .consumer_supplies = &sdp3430_vsim_supply,
+ .num_consumer_supplies = ARRAY_SIZE(sdp3430_vsim_supplies),
+ .consumer_supplies = sdp3430_vsim_supplies,
};
/* VDAC for DSS driving S-Video */
.valid_ops_mask = REGULATOR_CHANGE_MODE
| REGULATOR_CHANGE_STATUS,
},
- .num_consumer_supplies = 1,
- .consumer_supplies = &sdp3430_vdda_dac_supply,
-};
-
-/* VPLL2 for digital video outputs */
-static struct regulator_consumer_supply sdp3430_vpll2_supplies[] = {
- {
- .supply = "vdds_dsi",
- .dev = &sdp3430_dss_device.dev,
- }
+ .num_consumer_supplies = ARRAY_SIZE(sdp3430_vdda_dac_supplies),
+ .consumer_supplies = sdp3430_vdda_dac_supplies,
};
static struct regulator_init_data sdp3430_vpll2 = {
.consumer_supplies = sdp3430_vpll2_supplies,
};
-static struct twl4030_codec_audio_data sdp3430_audio = {
- .audio_mclk = 26000000,
-};
+static struct twl4030_codec_audio_data sdp3430_audio;
static struct twl4030_codec_data sdp3430_codec = {
.audio_mclk = 26000000,
static struct omap_board_mux board_mux[] __initdata = {
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
+
+static struct omap_device_pad serial1_pads[] __initdata = {
+ /*
+ * Note that off output enable is an active low
+ * signal. So setting this means pin is a
+ * input enabled in off mode
+ */
+ OMAP_MUX_STATIC("uart1_cts.uart1_cts",
+ OMAP_PIN_INPUT |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart1_rts.uart1_rts",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart1_rx.uart1_rx",
+ OMAP_PIN_INPUT |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart1_tx.uart1_tx",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+};
+
+static struct omap_device_pad serial2_pads[] __initdata = {
+ OMAP_MUX_STATIC("uart2_cts.uart2_cts",
+ OMAP_PIN_INPUT_PULLUP |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart2_rts.uart2_rts",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart2_rx.uart2_rx",
+ OMAP_PIN_INPUT |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart2_tx.uart2_tx",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+};
+
+static struct omap_device_pad serial3_pads[] __initdata = {
+ OMAP_MUX_STATIC("uart3_cts_rctx.uart3_cts_rctx",
+ OMAP_PIN_INPUT_PULLDOWN |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart3_rts_sd.uart3_rts_sd",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart3_rx_irrx.uart3_rx_irrx",
+ OMAP_PIN_INPUT |
+ OMAP_PIN_OFF_INPUT_PULLDOWN |
+ OMAP_OFFOUT_EN |
+ OMAP_MUX_MODE0),
+ OMAP_MUX_STATIC("uart3_tx_irtx.uart3_tx_irtx",
+ OMAP_PIN_OUTPUT |
+ OMAP_OFF_EN |
+ OMAP_MUX_MODE0),
+};
+
+static struct omap_board_data serial1_data = {
+ .id = 0,
+ .pads = serial1_pads,
+ .pads_cnt = ARRAY_SIZE(serial1_pads),
+};
+
+static struct omap_board_data serial2_data = {
+ .id = 1,
+ .pads = serial2_pads,
+ .pads_cnt = ARRAY_SIZE(serial2_pads),
+};
+
+static struct omap_board_data serial3_data = {
+ .id = 2,
+ .pads = serial3_pads,
+ .pads_cnt = ARRAY_SIZE(serial3_pads),
+};
+
+static inline void board_serial_init(void)
+{
+ omap_serial_init_port(&serial1_data);
+ omap_serial_init_port(&serial2_data);
+ omap_serial_init_port(&serial3_data);
+}
+#else
+#define board_mux NULL
+
+static inline void board_serial_init(void)
+{
+ omap_serial_init();
+}
#endif
/*
static void __init omap_3430sdp_init(void)
{
omap3_mux_init(board_mux, OMAP_PACKAGE_CBB);
+ omap_board_config = sdp3430_config;
+ omap_board_config_size = ARRAY_SIZE(sdp3430_config);
+ omap3_pm_init_cpuidle(omap3_cpuidle_params_table);
omap3430_i2c_init();
- platform_add_devices(sdp3430_devices, ARRAY_SIZE(sdp3430_devices));
+ omap_display_init(&sdp3430_dss_data);
if (omap_rev() > OMAP3430_REV_ES1_0)
ts_gpio = SDP3430_TS_GPIO_IRQ_SDPV2;
else
spi_register_board_info(sdp3430_spi_board_info,
ARRAY_SIZE(sdp3430_spi_board_info));
ads7846_dev_init();
- omap_serial_init();
+ board_serial_init();
usb_musb_init(&musb_board_data);
board_smc91x_init();
- board_flash_init(sdp_flash_partitions, chip_sel_3430);
+ board_flash_init(sdp_flash_partitions, chip_sel_3430, 0);
sdp3430_display_init();
enable_board_wakeup_source();
usbhs_init(&usbhs_bdata);
MACHINE_START(OMAP_3430SDP, "OMAP3430 3430SDP board")
/* Maintainer: Syed Khasim - Texas Instruments Inc */
.boot_params = 0x80000100,
- .map_io = omap3_map_io,
.reserve = omap_reserve,
- .init_irq = omap_3430sdp_init_irq,
+ .map_io = omap3_map_io,
+ .init_early = omap_3430sdp_init_early,
+ .init_irq = omap_init_irq,
.init_machine = omap_3430sdp_init,
.timer = &omap_timer,
MACHINE_END
git.openpandora.org / pandora-kernel.git / blobdiff