#include <asm/arch/gpio.h>
#include <asm/arch/at91sam9261.h>
#include <asm/arch/at91sam9261_matrix.h>
-#include <asm/arch/at91sam926x_mc.h>
+#include <asm/arch/at91sam9_smc.h>
#include "generic.h"
at91_sys_write(AT91_MATRIX_EBICSA, csa | AT91_MATRIX_CS3A_SMC_SMARTMEDIA);
/* set the bus interface characteristics */
- at91_sys_write(AT91_SMC_SETUP(3), AT91_SMC_NWESETUP_(0) | AT91_SMC_NCS_WRSETUP_(0)
- | AT91_SMC_NRDSETUP_(0) | AT91_SMC_NCS_RDSETUP_(0));
+ at91_sys_write(AT91_SMC_SETUP(3), AT91_SMC_NWESETUP_(1) | AT91_SMC_NCS_WRSETUP_(0)
+ | AT91_SMC_NRDSETUP_(1) | AT91_SMC_NCS_RDSETUP_(0));
- at91_sys_write(AT91_SMC_PULSE(3), AT91_SMC_NWEPULSE_(2) | AT91_SMC_NCS_WRPULSE_(5)
- | AT91_SMC_NRDPULSE_(2) | AT91_SMC_NCS_RDPULSE_(5));
+ at91_sys_write(AT91_SMC_PULSE(3), AT91_SMC_NWEPULSE_(3) | AT91_SMC_NCS_WRPULSE_(3)
+ | AT91_SMC_NRDPULSE_(3) | AT91_SMC_NCS_RDPULSE_(3));
- at91_sys_write(AT91_SMC_CYCLE(3), AT91_SMC_NWECYCLE_(7) | AT91_SMC_NRDCYCLE_(7));
+ at91_sys_write(AT91_SMC_CYCLE(3), AT91_SMC_NWECYCLE_(5) | AT91_SMC_NRDCYCLE_(5));
if (data->bus_width_16)
mode = AT91_SMC_DBW_16;
else
mode = AT91_SMC_DBW_8;
- at91_sys_write(AT91_SMC_MODE(3), mode | AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE | AT91_SMC_TDF_(1));
+ at91_sys_write(AT91_SMC_MODE(3), mode | AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE | AT91_SMC_TDF_(2));
/* enable pin */
if (data->enable_pin)
at91_set_B_periph(AT91_PIN_PB28, 0); /* LCDD23 */
#endif
+ if (ARRAY_SIZE(lcdc_resources) > 2) {
+ void __iomem *fb;
+ struct resource *fb_res = &lcdc_resources[2];
+ size_t fb_len = fb_res->end - fb_res->start + 1;
+
+ fb = ioremap(fb_res->start, fb_len);
+ if (fb) {
+ memset(fb, 0, fb_len);
+ iounmap(fb);
+ }
+ }
lcdc_data = *data;
platform_device_register(&at91_lcdc_device);
}
#endif
+/* --------------------------------------------------------------------
+ * Timer/Counter block
+ * -------------------------------------------------------------------- */
+
+#ifdef CONFIG_ATMEL_TCLIB
+
+static struct resource tcb_resources[] = {
+ [0] = {
+ .start = AT91SAM9261_BASE_TCB0,
+ .end = AT91SAM9261_BASE_TCB0 + SZ_16K - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = AT91SAM9261_ID_TC0,
+ .end = AT91SAM9261_ID_TC0,
+ .flags = IORESOURCE_IRQ,
+ },
+ [2] = {
+ .start = AT91SAM9261_ID_TC1,
+ .end = AT91SAM9261_ID_TC1,
+ .flags = IORESOURCE_IRQ,
+ },
+ [3] = {
+ .start = AT91SAM9261_ID_TC2,
+ .end = AT91SAM9261_ID_TC2,
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct platform_device at91sam9261_tcb_device = {
+ .name = "atmel_tcb",
+ .id = 0,
+ .resource = tcb_resources,
+ .num_resources = ARRAY_SIZE(tcb_resources),
+};
+
+static void __init at91_add_device_tc(void)
+{
+ /* this chip has a separate clock and irq for each TC channel */
+ at91_clock_associate("tc0_clk", &at91sam9261_tcb_device.dev, "t0_clk");
+ at91_clock_associate("tc1_clk", &at91sam9261_tcb_device.dev, "t1_clk");
+ at91_clock_associate("tc2_clk", &at91sam9261_tcb_device.dev, "t2_clk");
+ platform_device_register(&at91sam9261_tcb_device);
+}
+#else
+static void __init at91_add_device_tc(void) { }
+#endif
+
+
/* --------------------------------------------------------------------
* RTT
* -------------------------------------------------------------------- */
static struct platform_device at91sam9261_rtt_device = {
.name = "at91_rtt",
- .id = -1,
+ .id = 0,
.resource = rtt_resources,
.num_resources = ARRAY_SIZE(rtt_resources),
};
at91_set_B_periph(AT91_PIN_PA16, 0); /* CTS2 */
}
-static struct platform_device *at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
+static struct platform_device *__initdata at91_uarts[ATMEL_MAX_UART]; /* the UARTs to use */
struct platform_device *atmel_default_console_device; /* the serial console device */
-void __init __deprecated at91_init_serial(struct at91_uart_config *config)
-{
- int i;
-
- /* Fill in list of supported UARTs */
- for (i = 0; i < config->nr_tty; i++) {
- switch (config->tty_map[i]) {
- case 0:
- configure_usart0_pins(ATMEL_UART_CTS | ATMEL_UART_RTS);
- at91_uarts[i] = &at91sam9261_uart0_device;
- at91_clock_associate("usart0_clk", &at91sam9261_uart0_device.dev, "usart");
- break;
- case 1:
- configure_usart1_pins(0);
- at91_uarts[i] = &at91sam9261_uart1_device;
- at91_clock_associate("usart1_clk", &at91sam9261_uart1_device.dev, "usart");
- break;
- case 2:
- configure_usart2_pins(0);
- at91_uarts[i] = &at91sam9261_uart2_device;
- at91_clock_associate("usart2_clk", &at91sam9261_uart2_device.dev, "usart");
- break;
- case 3:
- configure_dbgu_pins();
- at91_uarts[i] = &at91sam9261_dbgu_device;
- at91_clock_associate("mck", &at91sam9261_dbgu_device.dev, "usart");
- break;
- default:
- continue;
- }
- at91_uarts[i]->id = i; /* update ID number to mapped ID */
- }
-
- /* Set serial console device */
- if (config->console_tty < ATMEL_MAX_UART)
- atmel_default_console_device = at91_uarts[config->console_tty];
- if (!atmel_default_console_device)
- printk(KERN_INFO "AT91: No default serial console defined.\n");
-}
-
void __init at91_register_uart(unsigned id, unsigned portnr, unsigned pins)
{
struct platform_device *pdev;
{
if (portnr < ATMEL_MAX_UART)
atmel_default_console_device = at91_uarts[portnr];
- if (!atmel_default_console_device)
- printk(KERN_INFO "AT91: No default serial console defined.\n");
}
void __init at91_add_device_serial(void)
if (at91_uarts[i])
platform_device_register(at91_uarts[i]);
}
+
+ if (!atmel_default_console_device)
+ printk(KERN_INFO "AT91: No default serial console defined.\n");
}
#else
-void __init __deprecated at91_init_serial(struct at91_uart_config *config) {}
void __init at91_register_uart(unsigned id, unsigned portnr, unsigned pins) {}
void __init at91_set_serial_console(unsigned portnr) {}
void __init at91_add_device_serial(void) {}
{
at91_add_device_rtt();
at91_add_device_watchdog();
+ at91_add_device_tc();
return 0;
}
git.openpandora.org / pandora-kernel.git / blobdiff