*
* This is normally called from the decompressor code. The requirements
* are: MMU = off, D-cache = off, I-cache = dont care, r0 = 0,
- * r1 = machine nr, r2 = atags pointer.
+ * r1 = machine nr, r2 = atags or dtb pointer.
*
* This code is mostly position independent, so if you link the kernel at
* 0xc0008000, you call this at __pa(0xc0008000).
#endif
/*
- * r1 = machine no, r2 = atags,
+ * r1 = machine no, r2 = atags or dtb,
* r8 = phys_offset, r9 = cpuid, r10 = procinfo
*/
bl __vet_atags
ldr r13, =__mmap_switched @ address to jump to after
@ mmu has been enabled
adr lr, BSYM(1f) @ return (PIC) address
+ mov r8, r4 @ set TTBR1 to swapper_pg_dir
ARM( add pc, r10, #PROCINFO_INITFUNC )
THUMB( add r12, r10, #PROCINFO_INITFUNC )
THUMB( mov pc, r12 )
*/
adr r4, __secondary_data
ldmia r4, {r5, r7, r12} @ address to jump to after
- sub r4, r4, r5 @ mmu has been enabled
- ldr r4, [r7, r4] @ get secondary_data.pgdir
+ sub lr, r4, r5 @ mmu has been enabled
+ ldr r4, [r7, lr] @ get secondary_data.pgdir
+ add r7, r7, #4
+ ldr r8, [r7, lr] @ get secondary_data.swapper_pg_dir
adr lr, BSYM(__enable_mmu) @ return address
mov r13, r12 @ __secondary_switched address
ARM( add pc, r10, #PROCINFO_INITFUNC ) @ initialise processor
*
* r0 = cp#15 control register
* r1 = machine ID
- * r2 = atags pointer
+ * r2 = atags or dtb pointer
* r4 = page table pointer
* r9 = processor ID
* r13 = *virtual* address to jump to upon completion
*
* r0 = cp#15 control register
* r1 = machine ID
- * r2 = atags pointer
+ * r2 = atags or dtb pointer
* r9 = processor ID
* r13 = *virtual* address to jump to upon completion
*