each regulator.
struct regulator_consumer_supply {
- struct device *dev; /* consumer */
+ const char *dev_name; /* consumer dev_name() */
const char *supply; /* consumer supply - e.g. "vcc" */
};
static struct regulator_consumer_supply regulator1_consumers[] = {
{
- .dev = &platform_consumerB_device.dev,
- .supply = "Vcc",
+ .dev_name = "dev_name(consumer B)",
+ .supply = "Vcc",
},};
static struct regulator_consumer_supply regulator2_consumers[] = {
{
- .dev = &platform_consumerA_device.dev,
+ .dev = "dev_name(consumer A"),
.supply = "Vcc",
},};
static struct regulator_init_data regulator1_data = {
.constraints = {
+ .name = "Regulator-1",
.min_uV = 3300000,
.max_uV = 3300000,
.valid_modes_mask = REGULATOR_MODE_NORMAL,
.consumer_supplies = regulator1_consumers,
};
+The name field should be set to something that is usefully descriptive
+for the board for configuration of supplies for other regulators and
+for use in logging and other diagnostic output. Normally the name
+used for the supply rail in the schematic is a good choice. If no
+name is provided then the subsystem will choose one.
+
Regulator-1 supplies power to Regulator-2. This relationship must be registered
with the core so that Regulator-1 is also enabled when Consumer A enables its
supply (Regulator-2). The supply regulator is set by the supply_regulator
-field below:-
+field below and co:-
static struct regulator_init_data regulator2_data = {
- .supply_regulator = "regulator_name",
+ .supply_regulator = "Regulator-1",
.constraints = {
.min_uV = 1800000,
.max_uV = 2000000,