UART at the specified I/O port or MMIO address,
switching to the matching ttyS device later. The
options are the same as for ttyS, above.
+ hvc<n> Use the hypervisor console device <n>. This is for
+ both Xen and PowerPC hypervisors.
If the device connected to the port is not a TTY but a braille
device, prepend "brl," before the device type, for instance
edd= [EDD]
Format: {"off" | "on" | "skip[mbr]"}
+ efi_no_storage_paranoia [EFI; X86]
+ Using this parameter you can use more than 50% of
+ your efi variable storage. Use this parameter only if
+ you are really sure that your UEFI does sane gc and
+ fulfills the spec otherwise your board may brick.
+
eisa_irq_edge= [PARISC,HW]
See header of drivers/parisc/eisa.c.
i8042.notimeout [HW] Ignore timeout condition signalled by conroller
i8042.reset [HW] Reset the controller during init and cleanup
i8042.unlock [HW] Unlock (ignore) the keylock
+ i8042.kbdreset [HW] Reset device connected to KBD port
i810= [HW,DRM]
i8k.restricted [HW] Allow controlling fans only if SYS_ADMIN
capability is set.
+ i915.invert_brightness=
+ [DRM] Invert the sense of the variable that is used to
+ set the brightness of the panel backlight. Normally a
+ brightness value of 0 indicates backlight switched off,
+ and the maximum of the brightness value sets the backlight
+ to maximum brightness. If this parameter is set to 0
+ (default) and the machine requires it, or this parameter
+ is set to 1, a brightness value of 0 sets the backlight
+ to maximum brightness, and the maximum of the brightness
+ value switches the backlight off.
+ -1 -- never invert brightness
+ 0 -- machine default
+ 1 -- force brightness inversion
+
icn= [HW,ISDN]
Format: <io>[,<membase>[,<icn_id>[,<icn_id2>]]]
* dump_id: dump IDENTIFY data.
+ * disable: Disable this device.
+
If there are multiple matching configurations changing
the same attribute, the last one is used.
sector if the number is odd);
i = IGNORE_DEVICE (don't bind to this
device);
+ j = NO_REPORT_LUNS (don't use report luns
+ command, uas only);
l = NOT_LOCKABLE (don't try to lock and
unlock ejectable media);
m = MAX_SECTORS_64 (don't transfer more