Merge branch 'for_linus' of git://git.infradead.org/~dedekind/ubifs-2.6

[pandora-kernel.git] / Documentation / i2c / chips / pcf8574

diff --git a/Documentation/i2c/chips/pcf8574 b/Documentation/i2c/chips/pcf8574
index 2752c8c..235815c 100644 (file)
--- a/Documentation/i2c/chips/pcf8574
+++ b/Documentation/i2c/chips/pcf8574
@@ -4,13 +4,13 @@ Kernel driver pcf8574
 Supported chips:
   * Philips PCF8574
     Prefix: 'pcf8574'
-    Addresses scanned: I2C 0x20 - 0x27
+    Addresses scanned: none
     Datasheet: Publicly available at the Philips Semiconductors website
                http://www.semiconductors.philips.com/pip/PCF8574P.html
 
  * Philips PCF8574A
     Prefix: 'pcf8574a'
-    Addresses scanned: I2C 0x38 - 0x3f
+    Addresses scanned: none
     Datasheet: Publicly available at the Philips Semiconductors website
                http://www.semiconductors.philips.com/pip/PCF8574P.html
 
@@ -38,12 +38,10 @@ For more informations see the datasheet.
 Accessing PCF8574(A) via /sys interface
 -------------------------------------
 
-! Be careful !
 The PCF8574(A) is plainly impossible to detect ! Stupid chip.
-So every chip with address in the interval [20..27] and [38..3f] are
-detected as PCF8574(A). If you have other chips in this address
-range, the workaround is to load this module after the one
-for your others chips.
+So, you have to pass the I2C bus and address of the installed PCF857A
+and PCF8574A devices explicitly to the driver at load time via the
+force=... parameter.
 
 On detection (i.e. insmod, modprobe et al.), directories are being
 created for each detected PCF8574(A):
@@ -62,8 +60,6 @@ if the corresponding output is set as 1, otherwise the current output
 value, that is to say 0.
 
 The write file is read/write. Writing a value outputs it on the I/O
-port. Reading returns the last written value.
-
-On module initialization the chip is configured as eight inputs (all
-outputs to 1), so you can connect any circuit to the PCF8574(A) without
-being afraid of short-circuit.
+port. Reading returns the last written value. As it is not possible
+to read this value from the chip, you need to write at least once to
+this file before you can read back from it.