void pci_disable_msix(struct pci_dev *dev)
-This API should be used to undo the effect of pci_enable_msix(). It frees
+This function should be used to undo the effect of pci_enable_msix(). It frees
the previously allocated message signaled interrupts. The interrupts may
subsequently be assigned to another device, so drivers should not cache
the value of the 'vector' elements over a call to pci_disable_msix().
4.4 Handling devices implementing both MSI and MSI-X capabilities
If a device implements both MSI and MSI-X capabilities, it can
-run in either MSI mode or MSI-X mode but not both simultaneously.
+run in either MSI mode or MSI-X mode, but not both simultaneously.
This is a requirement of the PCI spec, and it is enforced by the
PCI layer. Calling pci_enable_msi() when MSI-X is already enabled or
pci_enable_msix() when MSI is already enabled results in an error.
above, MSI-X supports any number of interrupts between 1 and 2048.
In constrast, MSI is restricted to a maximum of 32 interrupts (and
must be a power of two). In addition, the MSI interrupt vectors must
-be allocated consecutively, so the system may not be able to allocate
+be allocated consecutively, so the system might not be able to allocate
as many vectors for MSI as it could for MSI-X. On some platforms, MSI
interrupts must all be targeted at the same set of CPUs whereas MSI-X
interrupts can all be targeted at different CPUs.
PCI configuration space (especially the Hypertransport chipsets such
as the nVidia nForce and Serverworks HT2000). As with host chipsets,
Linux mostly knows about them and automatically enables MSIs if it can.
-If you have a bridge which Linux doesn't yet know about, you can enable
+If you have a bridge unknown to Linux, you can enable
MSIs in configuration space using whatever method you know works, then
enable MSIs on that bridge by doing:
0000:00:0e.0).
To disable MSIs, echo 0 instead of 1. Changing this value should be
-done with caution as it can break interrupt handling for all devices
+done with caution as it could break interrupt handling for all devices
below this bridge.
Again, please notify linux-pci@vger.kernel.org of any bridges that need
5.3. Disabling MSIs on a single device
Some devices are known to have faulty MSI implementations. Usually this
-is handled in the individual device driver but occasionally it's necessary
+is handled in the individual device driver, but occasionally it's necessary
to handle this with a quirk. Some drivers have an option to disable use
of MSI. While this is a convenient workaround for the driver author,
it is not good practise, and should not be emulated.
have enabled CONFIG_PCI_MSI.
Then, 'lspci -t' gives the list of bridges above a device. Reading
-/sys/bus/pci/devices/*/msi_bus will tell you whether MSI are enabled (1)
+/sys/bus/pci/devices/*/msi_bus will tell you whether MSIs are enabled (1)
or disabled (0). If 0 is found in any of the msi_bus files belonging
to bridges between the PCI root and the device, MSIs are disabled.