* @__NL80211_CMD_AFTER_LAST: internal use
*/
enum nl80211_commands {
-/* don't change the order or add anything inbetween, this is ABI! */
+/* don't change the order or add anything between, this is ABI! */
NL80211_CMD_UNSPEC,
NL80211_CMD_GET_WIPHY, /* can dump */
* This can be used to mask out antennas which are not attached or should
* not be used for receiving. If an antenna is not selected in this bitmap
* the hardware should not be configured to receive on this antenna.
- * For a more detailed descripton see @NL80211_ATTR_WIPHY_ANTENNA_TX.
+ * For a more detailed description see @NL80211_ATTR_WIPHY_ANTENNA_TX.
*
* @NL80211_ATTR_WIPHY_ANTENNA_AVAIL_TX: Bitmap of antennas which are available
* for configuration as TX antennas via the above parameters.
* @__NL80211_ATTR_AFTER_LAST: internal use
*/
enum nl80211_attrs {
-/* don't change the order or add anything inbetween, this is ABI! */
+/* don't change the order or add anything between, this is ABI! */
NL80211_ATTR_UNSPEC,
NL80211_ATTR_WIPHY,
* 802.11 country information element with regulatory information it
* thinks we should consider. cfg80211 only processes the country
* code from the IE, and relies on the regulatory domain information
- * structure pased by userspace (CRDA) from our wireless-regdb.
+ * structure passed by userspace (CRDA) from our wireless-regdb.
* If a channel is enabled but the country code indicates it should
* be disabled we disable the channel and re-enable it upon disassociation.
*/
* @NL80211_MESHCONF_RETRY_TIMEOUT: specifies the initial retry timeout in
* millisecond units, used by the Peer Link Open message
*
- * @NL80211_MESHCONF_CONFIRM_TIMEOUT: specifies the inital confirm timeout, in
+ * @NL80211_MESHCONF_CONFIRM_TIMEOUT: specifies the initial confirm timeout, in
* millisecond units, used by the peer link management to close a peer link
*
* @NL80211_MESHCONF_HOLDING_TIMEOUT: specifies the holding timeout, in