* notification. This event is used to indicate that an unprotected
* disassociation frame was dropped when MFP is in use.
*
+ * @NL80211_CMD_NEW_PEER_CANDIDATE: Notification on the reception of a
+ * beacon or probe response from a compatible mesh peer. This is only
+ * sent while no station information (sta_info) exists for the new peer
+ * candidate and when @NL80211_MESH_SETUP_USERSPACE_AUTH is set. On
+ * reception of this notification, userspace may decide to create a new
+ * station (@NL80211_CMD_NEW_STATION). To stop this notification from
+ * reoccurring, the userspace authentication daemon may want to create the
+ * new station with the AUTHENTICATED flag unset and maybe change it later
+ * depending on the authentication result.
+ *
+ * @NL80211_CMD_GET_WOWLAN: get Wake-on-Wireless-LAN (WoWLAN) settings.
+ * @NL80211_CMD_SET_WOWLAN: set Wake-on-Wireless-LAN (WoWLAN) settings.
+ * Since wireless is more complex than wired ethernet, it supports
+ * various triggers. These triggers can be configured through this
+ * command with the %NL80211_ATTR_WOWLAN_TRIGGERS attribute. For
+ * more background information, see
+ * http://wireless.kernel.org/en/users/Documentation/WoWLAN.
+ *
* @NL80211_CMD_MAX: highest used command number
* @__NL80211_CMD_AFTER_LAST: internal use
*/
NL80211_CMD_UNPROT_DEAUTHENTICATE,
NL80211_CMD_UNPROT_DISASSOCIATE,
+ NL80211_CMD_NEW_PEER_CANDIDATE,
+
+ NL80211_CMD_GET_WOWLAN,
+ NL80211_CMD_SET_WOWLAN,
+
/* add new commands above here */
/* used to define NL80211_CMD_MAX below */
* changed once the mesh is active.
* @NL80211_ATTR_MESH_CONFIG: Mesh configuration parameters, a nested attribute
* containing attributes from &enum nl80211_meshconf_params.
+ * @NL80211_ATTR_SUPPORT_MESH_AUTH: Currently, this means the underlying driver
+ * allows auth frames in a mesh to be passed to userspace for processing via
+ * the @NL80211_MESH_SETUP_USERSPACE_AUTH flag.
+ *
+ * @NL80211_ATTR_WOWLAN_SUPPORTED: indicates, as part of the wiphy capabilities,
+ * the supported WoWLAN triggers
+ * @NL80211_ATTR_WOWLAN_TRIGGERS: used by %NL80211_CMD_SET_WOWLAN to
+ * indicate which WoW triggers should be enabled. This is also
+ * used by %NL80211_CMD_GET_WOWLAN to get the currently enabled WoWLAN
+ * triggers.
*
* @NL80211_ATTR_MAX: highest attribute number currently defined
* @__NL80211_ATTR_AFTER_LAST: internal use
NL80211_ATTR_WIPHY_ANTENNA_AVAIL_TX,
NL80211_ATTR_WIPHY_ANTENNA_AVAIL_RX,
+ NL80211_ATTR_SUPPORT_MESH_AUTH,
+
+ NL80211_ATTR_WOWLAN_TRIGGERS,
+ NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED,
+
/* add attributes here, update the policy in nl80211.c */
__NL80211_ATTR_AFTER_LAST,
* with short barker preamble
* @NL80211_STA_FLAG_WME: station is WME/QoS capable
* @NL80211_STA_FLAG_MFP: station uses management frame protection
+ * @NL80211_STA_FLAG_AUTHENTICATED: station is authenticated
* @NL80211_STA_FLAG_MAX: highest station flag number currently defined
* @__NL80211_STA_FLAG_AFTER_LAST: internal use
*/
NL80211_STA_FLAG_SHORT_PREAMBLE,
NL80211_STA_FLAG_WME,
NL80211_STA_FLAG_MFP,
+ NL80211_STA_FLAG_AUTHENTICATED,
/* keep last */
__NL80211_STA_FLAG_AFTER_LAST,
* attribute, like NL80211_STA_INFO_TX_BITRATE.
* @NL80211_STA_INFO_BSS_PARAM: current station's view of BSS, nested attribute
* containing info as possible, see &enum nl80211_sta_bss_param
+ * @NL80211_STA_INFO_CONNECTED_TIME: time since the station is last connected
* @__NL80211_STA_INFO_AFTER_LAST: internal
* @NL80211_STA_INFO_MAX: highest possible station info attribute
*/
NL80211_STA_INFO_SIGNAL_AVG,
NL80211_STA_INFO_RX_BITRATE,
NL80211_STA_INFO_BSS_PARAM,
+ NL80211_STA_INFO_CONNECTED_TIME,
/* keep last */
__NL80211_STA_INFO_AFTER_LAST,
* robust security network ie, or a vendor specific information element that
* vendors will use to identify the path selection methods and metrics in use.
*
+ * @NL80211_MESH_SETUP_USERSPACE_AUTH: Enable this option if an authentication
+ * daemon will be authenticating mesh candidates.
+ *
* @NL80211_MESH_SETUP_ATTR_MAX: highest possible mesh setup attribute number
* @__NL80211_MESH_SETUP_ATTR_AFTER_LAST: Internal use
*/
NL80211_MESH_SETUP_ENABLE_VENDOR_PATH_SEL,
NL80211_MESH_SETUP_ENABLE_VENDOR_METRIC,
NL80211_MESH_SETUP_IE,
+ NL80211_MESH_SETUP_USERSPACE_AUTH,
/* keep last */
__NL80211_MESH_SETUP_ATTR_AFTER_LAST,
NL80211_TX_POWER_FIXED,
};
+/**
+ * enum nl80211_wowlan_packet_pattern_attr - WoWLAN packet pattern attribute
+ * @__NL80211_WOWLAN_PKTPAT_INVALID: invalid number for nested attribute
+ * @NL80211_WOWLAN_PKTPAT_PATTERN: the pattern, values where the mask has
+ * a zero bit are ignored
+ * @NL80211_WOWLAN_PKTPAT_MASK: pattern mask, must be long enough to have
+ * a bit for each byte in the pattern. The lowest-order bit corresponds
+ * to the first byte of the pattern, but the bytes of the pattern are
+ * in a little-endian-like format, i.e. the 9th byte of the pattern
+ * corresponds to the lowest-order bit in the second byte of the mask.
+ * For example: The match 00:xx:00:00:xx:00:00:00:00:xx:xx:xx (where
+ * xx indicates "don't care") would be represented by a pattern of
+ * twelve zero bytes, and a mask of "0xed,0x07".
+ * Note that the pattern matching is done as though frames were not
+ * 802.11 frames but 802.3 frames, i.e. the frame is fully unpacked
+ * first (including SNAP header unpacking) and then matched.
+ * @NUM_NL80211_WOWLAN_PKTPAT: number of attributes
+ * @MAX_NL80211_WOWLAN_PKTPAT: max attribute number
+ */
+enum nl80211_wowlan_packet_pattern_attr {
+ __NL80211_WOWLAN_PKTPAT_INVALID,
+ NL80211_WOWLAN_PKTPAT_MASK,
+ NL80211_WOWLAN_PKTPAT_PATTERN,
+
+ NUM_NL80211_WOWLAN_PKTPAT,
+ MAX_NL80211_WOWLAN_PKTPAT = NUM_NL80211_WOWLAN_PKTPAT - 1,
+};
+
+/**
+ * struct nl80211_wowlan_pattern_support - pattern support information
+ * @max_patterns: maximum number of patterns supported
+ * @min_pattern_len: minimum length of each pattern
+ * @max_pattern_len: maximum length of each pattern
+ *
+ * This struct is carried in %NL80211_WOWLAN_TRIG_PKT_PATTERN when
+ * that is part of %NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED in the
+ * capability information given by the kernel to userspace.
+ */
+struct nl80211_wowlan_pattern_support {
+ __u32 max_patterns;
+ __u32 min_pattern_len;
+ __u32 max_pattern_len;
+} __attribute__((packed));
+
+/**
+ * enum nl80211_wowlan_triggers - WoWLAN trigger definitions
+ * @__NL80211_WOWLAN_TRIG_INVALID: invalid number for nested attributes
+ * @NL80211_WOWLAN_TRIG_ANY: wake up on any activity, do not really put
+ * the chip into a special state -- works best with chips that have
+ * support for low-power operation already (flag)
+ * @NL80211_WOWLAN_TRIG_DISCONNECT: wake up on disconnect, the way disconnect
+ * is detected is implementation-specific (flag)
+ * @NL80211_WOWLAN_TRIG_MAGIC_PKT: wake up on magic packet (6x 0xff, followed
+ * by 16 repetitions of MAC addr, anywhere in payload) (flag)
+ * @NL80211_WOWLAN_TRIG_PKT_PATTERN: wake up on the specified packet patterns
+ * which are passed in an array of nested attributes, each nested attribute
+ * defining a with attributes from &struct nl80211_wowlan_trig_pkt_pattern.
+ * Each pattern defines a wakeup packet. The matching is done on the MSDU,
+ * i.e. as though the packet was an 802.3 packet, so the pattern matching
+ * is done after the packet is converted to the MSDU.
+ *
+ * In %NL80211_ATTR_WOWLAN_TRIGGERS_SUPPORTED, it is a binary attribute
+ * carrying a &struct nl80211_wowlan_pattern_support.
+ * @NUM_NL80211_WOWLAN_TRIG: number of wake on wireless triggers
+ * @MAX_NL80211_WOWLAN_TRIG: highest wowlan trigger attribute number
+ */
+enum nl80211_wowlan_triggers {
+ __NL80211_WOWLAN_TRIG_INVALID,
+ NL80211_WOWLAN_TRIG_ANY,
+ NL80211_WOWLAN_TRIG_DISCONNECT,
+ NL80211_WOWLAN_TRIG_MAGIC_PKT,
+ NL80211_WOWLAN_TRIG_PKT_PATTERN,
+
+ /* keep last */
+ NUM_NL80211_WOWLAN_TRIG,
+ MAX_NL80211_WOWLAN_TRIG = NUM_NL80211_WOWLAN_TRIG - 1
+};
+
#endif /* __LINUX_NL80211_H */
git.openpandora.org / pandora-kernel.git / blobdiff