#define OMAP_UHH_DEBUG_CSR (0x44)
/* EHCI Register Set */
+#define EHCI_INSNREG04 (0xA0)
+#define EHCI_INSNREG04_DISABLE_UNSUSPEND (1 << 5)
#define EHCI_INSNREG05_ULPI (0xA4)
#define EHCI_INSNREG05_ULPI_CONTROL_SHIFT 31
#define EHCI_INSNREG05_ULPI_PORTSEL_SHIFT 24
reg &= ~OMAP_UHH_HOSTCONFIG_P3_CONNECT_STATUS;
/* Bypass the TLL module for PHY mode operation */
- if (omap_rev() <= OMAP3430_REV_ES2_1) {
- dev_dbg(omap->dev, "OMAP3 ES version <= ES2.1 \n");
+ if (cpu_is_omap3430() && (omap_rev() <= OMAP3430_REV_ES2_1)) {
+ dev_dbg(omap->dev, "OMAP3 ES version <= ES2.1\n");
if ((omap->port_mode[0] == EHCI_HCD_OMAP_MODE_PHY) ||
(omap->port_mode[1] == EHCI_HCD_OMAP_MODE_PHY) ||
(omap->port_mode[2] == EHCI_HCD_OMAP_MODE_PHY))
dev_dbg(omap->dev, "UHH setup done, uhh_hostconfig=%x\n", reg);
+ /*
+ * An undocumented "feature" in the OMAP3 EHCI controller,
+ * causes suspended ports to be taken out of suspend when
+ * the USBCMD.Run/Stop bit is cleared (for example when
+ * we do ehci_bus_suspend).
+ * This breaks suspend-resume if the root-hub is allowed
+ * to suspend. Writing 1 to this undocumented register bit
+ * disables this feature and restores normal behavior.
+ */
+ ehci_omap_writel(omap->ehci_base, EHCI_INSNREG04,
+ EHCI_INSNREG04_DISABLE_UNSUSPEND);
+
if ((omap->port_mode[0] == EHCI_HCD_OMAP_MODE_TLL) ||
(omap->port_mode[1] == EHCI_HCD_OMAP_MODE_TLL) ||
(omap->port_mode[2] == EHCI_HCD_OMAP_MODE_TLL)) {
goto err_add_hcd;
}
+ /* root ports should always stay powered */
+ ehci_port_power(omap->ehci, 1);
+
return 0;
err_add_hcd: