wl1251: Add IRQ looping support

[pandora-kernel.git] / drivers / spi / amba-pl022.c

diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c
index c0f950a..958a3ff 100644 (file)
--- a/drivers/spi/amba-pl022.c
+++ b/drivers/spi/amba-pl022.c
@@ -532,7 +532,7 @@ static void restore_state(struct pl022 *pl022)
        GEN_MASK_BITS(SSP_DATA_BITS_12, SSP_CR0_MASK_DSS, 0)    | \
        GEN_MASK_BITS(SSP_MICROWIRE_CHANNEL_FULL_DUPLEX, SSP_CR0_MASK_HALFDUP, 5) | \
        GEN_MASK_BITS(SSP_CLK_POL_IDLE_LOW, SSP_CR0_MASK_SPO, 6) | \
-       GEN_MASK_BITS(SSP_CLK_FALLING_EDGE, SSP_CR0_MASK_SPH, 7) | \
+       GEN_MASK_BITS(SSP_CLK_SECOND_EDGE, SSP_CR0_MASK_SPH, 7) | \
        GEN_MASK_BITS(NMDK_SSP_DEFAULT_CLKRATE, SSP_CR0_MASK_SCR, 8) | \
        GEN_MASK_BITS(SSP_BITS_8, SSP_CR0_MASK_CSS, 16) | \
        GEN_MASK_BITS(SSP_INTERFACE_MOTOROLA_SPI, SSP_CR0_MASK_FRF, 21) \
@@ -1247,8 +1247,8 @@ static int verify_controller_parameters(struct pl022 *pl022,
                return -EINVAL;
        }
        if (chip_info->iface == SSP_INTERFACE_MOTOROLA_SPI) {
-               if ((chip_info->clk_phase != SSP_CLK_RISING_EDGE)
-                   && (chip_info->clk_phase != SSP_CLK_FALLING_EDGE)) {
+               if ((chip_info->clk_phase != SSP_CLK_FIRST_EDGE)
+                   && (chip_info->clk_phase != SSP_CLK_SECOND_EDGE)) {
                        dev_err(chip_info->dev,
                                "Clock Phase is configured incorrectly\n");
                        return -EINVAL;
@@ -1485,7 +1485,7 @@ static int pl022_setup(struct spi_device *spi)
                chip_info->data_size = SSP_DATA_BITS_12;
                chip_info->rx_lev_trig = SSP_RX_1_OR_MORE_ELEM;
                chip_info->tx_lev_trig = SSP_TX_1_OR_MORE_EMPTY_LOC;
-               chip_info->clk_phase = SSP_CLK_FALLING_EDGE;
+               chip_info->clk_phase = SSP_CLK_SECOND_EDGE;
                chip_info->clk_pol = SSP_CLK_POL_IDLE_LOW;
                chip_info->ctrl_len = SSP_BITS_8;
                chip_info->wait_state = SSP_MWIRE_WAIT_ZERO;