#define LSD(x) ((uint32_t)((uint64_t)(x)))
#define MSD(x) ((uint32_t)((((uint64_t)(x)) >> 16) >> 16))
+#define MAKE_HANDLE(x, y) ((uint32_t)((((uint32_t)(x)) << 16) | (uint32_t)(y)))
/*
* I/O register
/* ISP request and response entry counts (37-65535) */
#define REQUEST_ENTRY_CNT_2100 128 /* Number of request entries. */
#define REQUEST_ENTRY_CNT_2200 2048 /* Number of request entries. */
-#define REQUEST_ENTRY_CNT_2XXX_EXT_MEM 4096 /* Number of request entries. */
-#define REQUEST_ENTRY_CNT_24XX 4096 /* Number of request entries. */
+#define REQUEST_ENTRY_CNT_24XX 2048 /* Number of request entries. */
#define RESPONSE_ENTRY_CNT_2100 64 /* Number of response entries.*/
#define RESPONSE_ENTRY_CNT_2300 512 /* Number of response entries.*/
+#define RESPONSE_ENTRY_CNT_MQ 128 /* Number of response entries.*/
struct req_que;
* SCSI Request Block
*/
typedef struct srb {
- struct req_que *que;
struct fc_port *fcport;
struct scsi_cmnd *cmd; /* Linux SCSI command pkt */
#define MBC_GET_TIMEOUT_PARAMS 0x22 /* Get FW timeouts. */
#define MBC_TRACE_CONTROL 0x27 /* Trace control command. */
#define MBC_GEN_SYSTEM_ERROR 0x2a /* Generate System Error. */
+#define MBC_WRITE_SFP 0x30 /* Write SFP Data. */
#define MBC_READ_SFP 0x31 /* Read SFP Data. */
#define MBC_SET_TIMEOUT_PARAMS 0x32 /* Set FW timeouts. */
#define MBC_MID_INITIALIZE_FIRMWARE 0x48 /* MID Initialize firmware. */
#define VP_RET_CODE_NOT_FOUND 6
struct qla_hw_data;
-
+struct rsp_que;
/*
* ISP operations
*/
void (*enable_intrs) (struct qla_hw_data *);
void (*disable_intrs) (struct qla_hw_data *);
- int (*abort_command) (struct scsi_qla_host *, srb_t *,
- struct req_que *);
- int (*target_reset) (struct fc_port *, unsigned int);
- int (*lun_reset) (struct fc_port *, unsigned int);
+ int (*abort_command) (srb_t *);
+ int (*target_reset) (struct fc_port *, unsigned int, int);
+ int (*lun_reset) (struct fc_port *, unsigned int, int);
int (*fabric_login) (struct scsi_qla_host *, uint16_t, uint8_t,
uint8_t, uint8_t, uint16_t *, uint8_t);
int (*fabric_logout) (struct scsi_qla_host *, uint16_t, uint8_t,
#define QLA_PCI_MSIX_CONTROL 0xa2
struct scsi_qla_host;
-struct rsp_que;
struct qla_msix_entry {
int have_irq;
#define MBC_INITIALIZE_MULTIQ 0x1f
#define QLA_QUE_PAGE 0X1000
#define QLA_MQ_SIZE 32
-#define QLA_MAX_HOST_QUES 16
#define QLA_MAX_QUEUES 256
#define ISP_QUE_REG(ha, id) \
((ha->mqenable) ? \
struct qla_hw_data *hw;
struct qla_msix_entry *msix;
struct req_que *req;
+ srb_t *status_srb; /* status continuation entry */
+ struct work_struct q_work;
};
/* Request queue data structure */
uint32_t fce_enabled :1;
uint32_t fac_supported :1;
uint32_t chip_reset_done :1;
+ uint32_t port0 :1;
} flags;
/* This spinlock is used to protect "io transactions", you must
struct rsp_que **rsp_q_map;
unsigned long req_qid_map[(QLA_MAX_QUEUES / 8) / sizeof(unsigned long)];
unsigned long rsp_qid_map[(QLA_MAX_QUEUES / 8) / sizeof(unsigned long)];
- uint16_t max_queues;
+ uint8_t max_req_queues;
+ uint8_t max_rsp_queues;
struct qla_npiv_entry *npiv_info;
uint16_t nvram_npiv_size;
#define FLOGI_MID_SUPPORT BIT_10
#define FLOGI_VSAN_SUPPORT BIT_12
#define FLOGI_SP_SUPPORT BIT_13
+
+ uint8_t port_no; /* Physical port of adapter */
+
/* Timeout timers. */
uint8_t loop_down_abort_time; /* port down timer */
atomic_t loop_down_timer; /* loop down timer */
#define IS_NOPOLLING_TYPE(ha) ((IS_QLA25XX(ha) || IS_QLA81XX(ha)) && \
(ha)->flags.msix_enabled)
#define IS_FAC_REQUIRED(ha) (IS_QLA81XX(ha))
+#define IS_NOCACHE_VPD_TYPE(ha) (IS_QLA81XX(ha))
#define IS_IIDMA_CAPABLE(ha) ((ha)->device_type & DT_IIDMA)
#define IS_FWI2_CAPABLE(ha) ((ha)->device_type & DT_FWI2)
void *sfp_data;
dma_addr_t sfp_data_dma;
+ uint8_t *edc_data;
+ dma_addr_t edc_data_dma;
+ uint16_t edc_data_len;
+
+#define XGMAC_DATA_SIZE PAGE_SIZE
+ void *xgmac_data;
+ dma_addr_t xgmac_data_dma;
+
+#define DCBX_TLV_DATA_SIZE PAGE_SIZE
+ void *dcbx_tlv;
+ dma_addr_t dcbx_tlv_dma;
+
struct task_struct *dpc_thread;
uint8_t dpc_active; /* DPC routine is active */
#define RISC_START_ADDRESS_2100 0x1000
#define RISC_START_ADDRESS_2300 0x800
#define RISC_START_ADDRESS_2400 0x100000
+ uint16_t fw_xcb_count;
uint16_t fw_options[16]; /* slots: 1,2,3,10,11 */
uint8_t fw_seriallink_options[4];
uint32_t flt_region_boot;
uint32_t flt_region_fw;
uint32_t flt_region_vpd_nvram;
+ uint32_t flt_region_vpd;
+ uint32_t flt_region_nvram;
uint32_t flt_region_npiv_conf;
/* Needed for BEACON */
uint16_t num_vsans; /* number of vsan created */
uint16_t max_npiv_vports; /* 63 or 125 per topoloty */
int cur_vport_count;
+ uint16_t flex_port_count;
struct qla_chip_state_84xx *cs84xx;
struct qla_statistics qla_stats;
struct isp_operations *isp_ops;
+ struct workqueue_struct *wq;
};
/*
#define SWITCH_FOUND BIT_0
#define DFLG_NO_CABLE BIT_1
- srb_t *status_srb; /* Status continuation entry. */
-
/* ISP configuration data. */
uint16_t loop_id; /* Host adapter loop id */
uint8_t node_name[WWN_SIZE];
uint8_t port_name[WWN_SIZE];
uint8_t fabric_node_name[WWN_SIZE];
+
+ uint16_t fcoe_vlan_id;
+ uint16_t fcoe_fcf_idx;
+ uint8_t fcoe_vn_port_mac[6];
+
uint32_t vp_abort_cnt;
struct fc_vport *fc_vport; /* holds fc_vport * for each vport */
#define VP_ERR_FAB_LOGOUT 4
#define VP_ERR_ADAP_NORESOURCES 5
struct qla_hw_data *hw;
- int req_ques[QLA_MAX_HOST_QUES];
+ struct req_que *req;
} scsi_qla_host_t;
/*