dev_dbg(&p_dev->dev, "atmel_attach()\n");
- /* Interrupt setup */
- p_dev->irq.Attributes = IRQ_TYPE_DYNAMIC_SHARING;
- p_dev->irq.Handler = NULL;
-
/*
General socket configuration defaults can go here. In this
client, we assume very little, and rely on the CIS for almost
else if (dflt->vpp1.present & (1<<CISTPL_POWER_VNOM))
p_dev->conf.Vpp = dflt->vpp1.param[CISTPL_POWER_VNOM]/10000;
- /* Do we need to allocate an interrupt? */
- if (cfg->irq.IRQInfo1 || dflt->irq.IRQInfo1)
- p_dev->conf.Attributes |= CONF_ENABLE_IRQ;
+ p_dev->conf.Attributes |= CONF_ENABLE_IRQ;
/* IO window settings */
p_dev->io.NumPorts1 = p_dev->io.NumPorts2 = 0;
if (pcmcia_loop_config(link, atmel_config_check, NULL))
goto failed;
- /*
- Allocate an interrupt line. Note that this does not assign a
- handler to the interrupt, unless the 'Handler' member of the
- irq structure is initialized.
- */
- if (link->conf.Attributes & CONF_ENABLE_IRQ) {
- ret = pcmcia_request_irq(link, &link->irq);
- if (ret)
- goto failed;
+ if (!link->irq) {
+ dev_err(&link->dev, "atmel: cannot assign IRQ: check that CONFIG_ISA is set in kernel config.");
+ goto failed;
}
/*
if (ret)
goto failed;
- if (link->irq.AssignedIRQ == 0) {
- printk(KERN_ALERT
- "atmel: cannot assign IRQ: check that CONFIG_ISA is set in kernel config.");
- goto failed;
- }
-
((local_info_t*)link->priv)->eth_dev =
- init_atmel_card(link->irq.AssignedIRQ,
+ init_atmel_card(link->irq,
link->io.BasePort1,
did ? did->driver_info : ATMEL_FW_TYPE_NONE,
&link->dev,