{
u32 pcu_reg, beacon_reg, low_id, high_id;
- pcu_reg = 0;
+
+ /* Preserve rest settings */
+ pcu_reg = ath5k_hw_reg_read(ah, AR5K_STA_ID1) & 0xffff0000;
+ pcu_reg &= ~(AR5K_STA_ID1_ADHOC | AR5K_STA_ID1_AP
+ | AR5K_STA_ID1_KEYSRCH_MODE
+ | (ah->ah_version == AR5K_AR5210 ?
+ (AR5K_STA_ID1_PWR_SV | AR5K_STA_ID1_NO_PSPOLL) : 0));
+
beacon_reg = 0;
ATH5K_TRACE(ah->ah_sc);
switch (ah->ah_op_mode) {
case NL80211_IFTYPE_ADHOC:
- pcu_reg |= AR5K_STA_ID1_ADHOC | AR5K_STA_ID1_DESC_ANTENNA |
- (ah->ah_version == AR5K_AR5210 ?
- AR5K_STA_ID1_NO_PSPOLL : 0);
+ pcu_reg |= AR5K_STA_ID1_ADHOC | AR5K_STA_ID1_KEYSRCH_MODE;
beacon_reg |= AR5K_BCR_ADHOC;
+ if (ah->ah_version == AR5K_AR5210)
+ pcu_reg |= AR5K_STA_ID1_NO_PSPOLL;
+ else
+ AR5K_REG_DISABLE_BITS(ah, AR5K_CFG, AR5K_CFG_ADHOC);
break;
case NL80211_IFTYPE_AP:
case NL80211_IFTYPE_MESH_POINT:
- pcu_reg |= AR5K_STA_ID1_AP | AR5K_STA_ID1_RTS_DEF_ANTENNA |
- (ah->ah_version == AR5K_AR5210 ?
- AR5K_STA_ID1_NO_PSPOLL : 0);
+ pcu_reg |= AR5K_STA_ID1_AP | AR5K_STA_ID1_KEYSRCH_MODE;
beacon_reg |= AR5K_BCR_AP;
+ if (ah->ah_version == AR5K_AR5210)
+ pcu_reg |= AR5K_STA_ID1_NO_PSPOLL;
+ else
+ AR5K_REG_ENABLE_BITS(ah, AR5K_CFG, AR5K_CFG_ADHOC);
break;
case NL80211_IFTYPE_STATION:
- pcu_reg |= AR5K_STA_ID1_DEFAULT_ANTENNA |
- (ah->ah_version == AR5K_AR5210 ?
+ pcu_reg |= AR5K_STA_ID1_KEYSRCH_MODE
+ | (ah->ah_version == AR5K_AR5210 ?
AR5K_STA_ID1_PWR_SV : 0);
case NL80211_IFTYPE_MONITOR:
- pcu_reg |= AR5K_STA_ID1_DEFAULT_ANTENNA |
- (ah->ah_version == AR5K_AR5210 ?
+ pcu_reg |= AR5K_STA_ID1_KEYSRCH_MODE
+ | (ah->ah_version == AR5K_AR5210 ?
AR5K_STA_ID1_NO_PSPOLL : 0);
break;
ath5k_hw_reg_write(ah, 0, AR5K_PROFCNT_RXCLR);
ath5k_hw_reg_write(ah, 0, AR5K_PROFCNT_CYCLE);
}
+
+ /* TODO: Handle ANI stats */
}
/**
* @mac: The card's mac address
*
* Set station id on hw using the provided mac address
+ *
+ * NOTE: This is only called during attach, don't call it
+ * on reset because it overwrites all AR5K_STA_ID1 settings.
+ * We have set_opmode (above) for reset.
*/
int ath5k_hw_set_lladdr(struct ath5k_hw *ah, const u8 *mac)
{
* Set simple BSSID mask on 5212
*/
if (ah->ah_version == AR5K_AR5212) {
- ath5k_hw_reg_write(ah, 0xffffffff, AR5K_BSS_IDM0);
- ath5k_hw_reg_write(ah, 0xffffffff, AR5K_BSS_IDM1);
+ ath5k_hw_reg_write(ah, AR5K_LOW_ID(ah->ah_bssid_mask),
+ AR5K_BSS_IDM0);
+ ath5k_hw_reg_write(ah, AR5K_HIGH_ID(ah->ah_bssid_mask),
+ AR5K_BSS_IDM1);
}
/*
u32 low_id, high_id;
ATH5K_TRACE(ah->ah_sc);
+ /* Cache bssid mask so that we can restore it
+ * on reset */
+ memcpy(ah->ah_bssid_mask, mask, ETH_ALEN);
if (ah->ah_version == AR5K_AR5212) {
low_id = AR5K_LOW_ID(mask);
high_id = AR5K_HIGH_ID(mask);
filter |= AR5K_RX_FILTER_PROM;
}
- /*Zero length DMA*/
+ /*Zero length DMA (phy error reporting) */
if (data)
AR5K_REG_ENABLE_BITS(ah, AR5K_RXCFG, AR5K_RXCFG_ZLFDMA);
else
* Set the additional timers by mode
*/
switch (ah->ah_op_mode) {
+ case NL80211_IFTYPE_MONITOR:
case NL80211_IFTYPE_STATION:
+ /* In STA mode timer1 is used as next wakeup
+ * timer and timer2 as next CFP duration start
+ * timer. Both in 1/8TUs. */
+ /* TODO: PCF handling */
if (ah->ah_version == AR5K_AR5210) {
timer1 = 0xffffffff;
timer2 = 0xffffffff;
timer1 = 0x0000ffff;
timer2 = 0x0007ffff;
}
+ /* Mark associated AP as PCF incapable for now */
+ AR5K_REG_DISABLE_BITS(ah, AR5K_STA_ID1, AR5K_STA_ID1_PCF);
break;
-
+ case NL80211_IFTYPE_ADHOC:
+ AR5K_REG_ENABLE_BITS(ah, AR5K_TXCFG, AR5K_TXCFG_ADHOC_BCN_ATIM);
default:
+ /* On non-STA modes timer1 is used as next DMA
+ * beacon alert (DBA) timer and timer2 as next
+ * software beacon alert. Both in 1/8TUs. */
timer1 = (next_beacon - AR5K_TUNE_DMA_BEACON_RESP) << 3;
timer2 = (next_beacon - AR5K_TUNE_SW_BEACON_RESP) << 3;
+ break;
}
+ /* Timer3 marks the end of our ATIM window
+ * a zero length window is not allowed because
+ * we 'll get no beacons */
timer3 = next_beacon + (ah->ah_atim_window ? ah->ah_atim_window : 1);
/*
* Set the beacon register and enable all timers.
- * (next beacon, DMA beacon, software beacon, ATIM window time)
*/
- ath5k_hw_reg_write(ah, next_beacon, AR5K_TIMER0);
+ /* When in AP mode zero timer0 to start TSF */
+ if (ah->ah_op_mode == NL80211_IFTYPE_AP)
+ ath5k_hw_reg_write(ah, 0, AR5K_TIMER0);
+ else
+ ath5k_hw_reg_write(ah, next_beacon, AR5K_TIMER0);
ath5k_hw_reg_write(ah, timer1, AR5K_TIMER1);
ath5k_hw_reg_write(ah, timer2, AR5K_TIMER2);
ath5k_hw_reg_write(ah, timer3, AR5K_TIMER3);
+ /* Force a TSF reset if requested and enable beacons */
+ if (interval & AR5K_BEACON_RESET_TSF)
+ ath5k_hw_reset_tsf(ah);
+
ath5k_hw_reg_write(ah, interval & (AR5K_BEACON_PERIOD |
- AR5K_BEACON_RESET_TSF | AR5K_BEACON_ENABLE),
- AR5K_BEACON);
+ AR5K_BEACON_ENABLE),
+ AR5K_BEACON);
+
+ /* Flush any pending BMISS interrupts on ISR by
+ * performing a clear-on-write operation on PISR
+ * register for the BMISS bit (writing a bit on
+ * ISR togles a reset for that bit and leaves
+ * the rest bits intact) */
+ if (ah->ah_version == AR5K_AR5210)
+ ath5k_hw_reg_write(ah, AR5K_ISR_BMISS, AR5K_ISR);
+ else
+ ath5k_hw_reg_write(ah, AR5K_ISR_BMISS, AR5K_PISR);
+
+ /* TODO: Set enchanced sleep registers on AR5212
+ * based on vif->bss_conf params, until then
+ * disable power save reporting.*/
+ AR5K_REG_DISABLE_BITS(ah, AR5K_STA_ID1, AR5K_STA_ID1_PWR_SV);
+
}
#if 0
*/
int ath5k_hw_reset_key(struct ath5k_hw *ah, u16 entry)
{
- unsigned int i;
+ unsigned int i, type;
ATH5K_TRACE(ah->ah_sc);
AR5K_ASSERT_ENTRY(entry, AR5K_KEYTABLE_SIZE);
+ type = ath5k_hw_reg_read(ah, AR5K_KEYTABLE_TYPE(entry));
+
for (i = 0; i < AR5K_KEYCACHE_SIZE; i++)
ath5k_hw_reg_write(ah, 0, AR5K_KEYTABLE_OFF(entry, i));
+ /* Reset associated MIC entry if TKIP
+ * is enabled located at offset (entry + 64) */
+ if (type == AR5K_KEYTABLE_TYPE_TKIP) {
+ entry = entry + AR5K_KEYTABLE_MIC_OFFSET;
+ AR5K_ASSERT_ENTRY(entry, AR5K_KEYTABLE_SIZE);
+ for (i = 0; i < AR5K_KEYCACHE_SIZE / 2 ; i++)
+ ath5k_hw_reg_write(ah, 0, AR5K_KEYTABLE_OFF(entry, i));
+ }
+
/*
* Set NULL encryption on AR5212+
*
git.openpandora.org / pandora-kernel.git / blobdiff