promiscuous mode via the Wireless Tool's Monitor mode. While in this
mode, no packets can be sent.
-config IPW_QOS
+config IPW2200_RADIOTAP
+ bool "Enable radiotap format 802.11 raw packet support"
+ depends on IPW2200_MONITOR
+
+config IPW2200_PROMISCUOUS
+ bool "Enable creation of a RF radiotap promiscuous interface"
+ depends on IPW2200_MONITOR
+ select IPW2200_RADIOTAP
+ ---help---
+ Enables the creation of a second interface prefixed 'rtap'.
+ This second interface will provide every received in radiotap
+ format.
+
+ This is useful for performing wireless network analysis while
+ maintaining an active association.
+
+ Example usage:
+
+ % modprobe ipw2200 rtap_iface=1
+ % ifconfig rtap0 up
+ % tethereal -i rtap0
+
+ If you do not specify 'rtap_iface=1' as a module parameter then
+ the rtap interface will not be created and you will need to turn
+ it on via sysfs:
+
+ % echo 1 > /sys/bus/pci/drivers/ipw2200/*/rtap_iface
+
+config IPW2200_QOS
bool "Enable QoS support"
depends on IPW2200 && EXPERIMENTAL
say M here and read <file:Documentation/modules.txt>. The module
will be called prism54.ko.
+config USB_ZD1201
+ tristate "USB ZD1201 based Wireless device support"
+ depends on USB && NET_RADIO
+ select FW_LOADER
+ ---help---
+ Say Y if you want to use wireless LAN adapters based on the ZyDAS
+ ZD1201 chip.
+
+ This driver makes the adapter appear as a normal Ethernet interface,
+ typically on wlan0.
+
+ The zd1201 device requires external firmware to be loaded.
+ This can be found at http://linux-lc100020.sourceforge.net/
+
+ To compile this driver as a module, choose M here: the
+ module will be called zd1201.
+
source "drivers/net/wireless/hostap/Kconfig"
source "drivers/net/wireless/bcm43xx/Kconfig"