are mapped on your particular target board. Refer to the
memory map which should hopefully be in the documentation for
your board.
- Ignore this option if you use run-time physmap configuration
- (i.e., run-time calling physmap_configure()).
config MTD_PHYSMAP_LEN
hex "Physical length of flash mapping"
than the total amount of flash present. Refer to the memory
map which should hopefully be in the documentation for your
board.
- Ignore this option if you use run-time physmap configuration
- (i.e., run-time calling physmap_configure()).
config MTD_PHYSMAP_BANKWIDTH
int "Bank width in octets"
in octets. For example, if you have a data bus width of 32
bits, you would set the bus width octet value to 4. This is
used internally by the CFI drivers.
- Ignore this option if you use run-time physmap configuration
- (i.e., run-time calling physmap_configure()).
config MTD_PHYSMAP_OF
tristate "Flash device in physical memory map based on OF description"
config MTD_LANTIQ
tristate "Lantiq SoC NOR support"
depends on LANTIQ
- select MTD_PARTITIONS
help
Support for NOR flash attached to the Lantiq SoC's External Bus Unit.
This enables access to the flash chips on the Hitachi SolutionEngine and
similar boards. Say 'Y' if you are building a kernel for such a board.
-config MTD_ARM_INTEGRATOR
- tristate "CFI Flash device mapped on ARM Integrator/P720T"
- depends on ARM && MTD_CFI
-
config MTD_CDB89712
tristate "Cirrus CDB89712 evaluation board mappings"
depends on MTD_CFI && ARCH_CDB89712
This enables access to the NV-RAM on autronix autcpu12 board.
If you have such a board, say 'Y'.
-config MTD_EDB7312
- tristate "CFI Flash device mapped on EDB7312"
- depends on ARCH_EDB7312 && MTD_CFI
- help
- This enables access to the CFI Flash on the Cogent EDB7312 board.
- If you have such a board, say 'Y' here.
-
config MTD_IMPA7
tristate "JEDEC Flash device mapped on impA7"
depends on ARM && MTD_JEDECPROBE
This enables access to the NOR Flash on the impA7 board of
implementa GmbH. If you have such a board, say 'Y' here.
-config MTD_CEIVA
- tristate "JEDEC Flash device mapped on Ceiva/Polaroid PhotoMax Digital Picture Frame"
- depends on MTD_JEDECPROBE && ARCH_CEIVA
- help
- This enables access to the flash chips on the Ceiva/Polaroid
- PhotoMax Digital Picture Frame.
- If you have such a device, say 'Y'.
-
config MTD_H720X
tristate "Hynix evaluation board mappings"
depends on MTD_CFI && ( ARCH_H7201 || ARCH_H7202 )