/*
- * Copyright (c) 2006 QLogic, Inc. All rights reserved.
+ * Copyright (c) 2006, 2007 QLogic Corporation. All rights reserved.
* Copyright (c) 2003, 2004, 2005, 2006 PathScale, Inc. All rights reserved.
*
* This software is available to you under a choice of one of two
#define PCI_DEVICE_ID_INFINIPATH_HT 0xd
#define PCI_DEVICE_ID_INFINIPATH_PE800 0x10
+/* Number of seconds before our card status check... */
+#define STATUS_TIMEOUT 60
+
static const struct pci_device_id ipath_pci_tbl[] = {
{ PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_HT) },
{ PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_PE800) },
.id_table = ipath_pci_tbl,
};
+static void ipath_check_status(struct work_struct *work)
+{
+ struct ipath_devdata *dd = container_of(work, struct ipath_devdata,
+ status_work.work);
+
+ /*
+ * If we don't have any interrupts, let the user know and
+ * don't bother checking again.
+ */
+ if (dd->ipath_int_counter == 0)
+ dev_err(&dd->pcidev->dev, "No interrupts detected.\n");
+}
static inline void read_bars(struct ipath_devdata *dd, struct pci_dev *dev,
u32 *bar0, u32 *bar1)
dd->pcidev = pdev;
pci_set_drvdata(pdev, dd);
+ INIT_DELAYED_WORK(&dd->status_work, ipath_check_status);
+
list_add(&dd->ipath_list, &ipath_dev_list);
bail_unlock:
ipath_diag_add(dd);
ipath_register_ib_device(dd);
+ /* Check that card status in STATUS_TIMEOUT seconds. */
+ schedule_delayed_work(&dd->status_work, HZ * STATUS_TIMEOUT);
+
goto bail;
bail_irqsetup:
*/
ipath_shutdown_device(dd);
+ cancel_delayed_work(&dd->status_work);
+ flush_scheduled_work();
+
if (dd->verbs_dev)
ipath_unregister_ib_device(dd->verbs_dev);
u64 sendctrl, sendorig;
ipath_cdbg(PKT, "disarm %u PIObufs first=%u\n", cnt, first);
- sendorig = dd->ipath_sendctrl | INFINIPATH_S_DISARM;
+ sendorig = dd->ipath_sendctrl;
for (i = first; i < last; i++) {
- sendctrl = sendorig |
+ sendctrl = sendorig | INFINIPATH_S_DISARM |
(i << INFINIPATH_S_DISARMPIOBUF_SHIFT);
ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
sendctrl);
* while we were looping; no critical bits that would require
* locking.
*
- * Write a 0, and then the original value, reading scratch in
+ * disable PIOAVAILUPD, then re-enable, reading scratch in
* between. This seems to avoid a chip timing race that causes
* pioavail updates to memory to stop.
*/
ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
- 0);
+ sendorig & ~IPATH_S_PIOBUFAVAILUPD);
sendorig = ipath_read_kreg64(dd, dd->ipath_kregs->kr_scratch);
ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
dd->ipath_sendctrl);
goto bail;
}
- /* There is already a thread processing this queue. */
- if (test_and_set_bit(0, &dd->ipath_rcv_pending))
- goto bail;
-
l = dd->ipath_port0head;
hdrqtail = (u32) le64_to_cpu(*dd->ipath_hdrqtailptr);
if (l == hdrqtail)
- goto done;
+ goto bail;
reloop:
for (i = 0; l != hdrqtail; i++) {
ipath_stats.sps_avgpkts_call =
ipath_stats.sps_port0pkts / ++totcalls;
-done:
- clear_bit(0, &dd->ipath_rcv_pending);
- smp_mb__after_clear_bit();
-
bail:;
}
return ret;
}
+
+/*
+ * Flush all sends that might be in the ready to send state, as well as any
+ * that are in the process of being sent. Used whenever we need to be
+ * sure the send side is idle. Cleans up all buffer state by canceling
+ * all pio buffers, and issuing an abort, which cleans up anything in the
+ * launch fifo. The cancel is superfluous on some chip versions, but
+ * it's safer to always do it.
+ * PIOAvail bits are updated by the chip as if normal send had happened.
+ */
+void ipath_cancel_sends(struct ipath_devdata *dd)
+{
+ ipath_dbg("Cancelling all in-progress send buffers\n");
+ dd->ipath_lastcancel = jiffies+HZ/2; /* skip armlaunch errs a bit */
+ /*
+ * the abort bit is auto-clearing. We read scratch to be sure
+ * that cancels and the abort have taken effect in the chip.
+ */
+ ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
+ INFINIPATH_S_ABORT);
+ ipath_read_kreg64(dd, dd->ipath_kregs->kr_scratch);
+ ipath_disarm_piobufs(dd, 0,
+ (unsigned)(dd->ipath_piobcnt2k + dd->ipath_piobcnt4k));
+
+ /* and again, be sure all have hit the chip */
+ ipath_read_kreg64(dd, dd->ipath_kregs->kr_scratch);
+}
+
+
static void ipath_set_ib_lstate(struct ipath_devdata *dd, int which)
{
static const char *what[4] = {
INFINIPATH_IBCS_LINKTRAININGSTATE_MASK]);
/* flush all queued sends when going to DOWN or INIT, to be sure that
* they don't block MAD packets */
- if (!linkcmd || linkcmd == INFINIPATH_IBCC_LINKCMD_INIT) {
- ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
- INFINIPATH_S_ABORT);
- ipath_disarm_piobufs(dd, dd->ipath_lastport_piobuf,
- (unsigned)(dd->ipath_piobcnt2k +
- dd->ipath_piobcnt4k) -
- dd->ipath_lastport_piobuf);
- }
+ if (!linkcmd || linkcmd == INFINIPATH_IBCC_LINKCMD_INIT)
+ ipath_cancel_sends(dd);
ipath_write_kreg(dd, dd->ipath_kregs->kr_ibcctrl,
dd->ipath_ibcctrl | which);
ipath_write_kreg(dd, where, value);
}
+/*
+ * Following deal with the "obviously simple" task of overriding the state
+ * of the LEDS, which normally indicate link physical and logical status.
+ * The complications arise in dealing with different hardware mappings
+ * and the board-dependent routine being called from interrupts.
+ * and then there's the requirement to _flash_ them.
+ */
+#define LED_OVER_FREQ_SHIFT 8
+#define LED_OVER_FREQ_MASK (0xFF<<LED_OVER_FREQ_SHIFT)
+/* Below is "non-zero" to force override, but both actual LEDs are off */
+#define LED_OVER_BOTH_OFF (8)
+
+void ipath_run_led_override(unsigned long opaque)
+{
+ struct ipath_devdata *dd = (struct ipath_devdata *)opaque;
+ int timeoff;
+ int pidx;
+ u64 lstate, ltstate, val;
+
+ if (!(dd->ipath_flags & IPATH_INITTED))
+ return;
+
+ pidx = dd->ipath_led_override_phase++ & 1;
+ dd->ipath_led_override = dd->ipath_led_override_vals[pidx];
+ timeoff = dd->ipath_led_override_timeoff;
+
+ /*
+ * below potentially restores the LED values per current status,
+ * should also possibly setup the traffic-blink register,
+ * but leave that to per-chip functions.
+ */
+ val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_ibcstatus);
+ ltstate = (val >> INFINIPATH_IBCS_LINKTRAININGSTATE_SHIFT) &
+ INFINIPATH_IBCS_LINKTRAININGSTATE_MASK;
+ lstate = (val >> INFINIPATH_IBCS_LINKSTATE_SHIFT) &
+ INFINIPATH_IBCS_LINKSTATE_MASK;
+
+ dd->ipath_f_setextled(dd, lstate, ltstate);
+ mod_timer(&dd->ipath_led_override_timer, jiffies + timeoff);
+}
+
+void ipath_set_led_override(struct ipath_devdata *dd, unsigned int val)
+{
+ int timeoff, freq;
+
+ if (!(dd->ipath_flags & IPATH_INITTED))
+ return;
+
+ /* First check if we are blinking. If not, use 1HZ polling */
+ timeoff = HZ;
+ freq = (val & LED_OVER_FREQ_MASK) >> LED_OVER_FREQ_SHIFT;
+
+ if (freq) {
+ /* For blink, set each phase from one nybble of val */
+ dd->ipath_led_override_vals[0] = val & 0xF;
+ dd->ipath_led_override_vals[1] = (val >> 4) & 0xF;
+ timeoff = (HZ << 4)/freq;
+ } else {
+ /* Non-blink set both phases the same. */
+ dd->ipath_led_override_vals[0] = val & 0xF;
+ dd->ipath_led_override_vals[1] = val & 0xF;
+ }
+ dd->ipath_led_override_timeoff = timeoff;
+
+ /*
+ * If the timer has not already been started, do so. Use a "quick"
+ * timeout so the function will be called soon, to look at our request.
+ */
+ if (atomic_inc_return(&dd->ipath_led_override_timer_active) == 1) {
+ /* Need to start timer */
+ init_timer(&dd->ipath_led_override_timer);
+ dd->ipath_led_override_timer.function =
+ ipath_run_led_override;
+ dd->ipath_led_override_timer.data = (unsigned long) dd;
+ dd->ipath_led_override_timer.expires = jiffies + 1;
+ add_timer(&dd->ipath_led_override_timer);
+ } else {
+ atomic_dec(&dd->ipath_led_override_timer_active);
+ }
+}
+
/**
* ipath_shutdown_device - shut down a device
* @dd: the infinipath device
*/
udelay(5);
- /*
- * abort any armed or launched PIO buffers that didn't go. (self
- * clearing). Will cause any packet currently being transmitted to
- * go out with an EBP, and may also cause a short packet error on
- * the receiver.
- */
- ipath_write_kreg(dd, dd->ipath_kregs->kr_sendctrl,
- INFINIPATH_S_ABORT);
-
ipath_set_ib_lstate(dd, INFINIPATH_IBCC_LINKINITCMD_DISABLE <<
INFINIPATH_IBCC_LINKINITCMD_SHIFT);
+ ipath_cancel_sends(dd);
/* disable IBC */
dd->ipath_control &= ~INFINIPATH_C_LINKENABLE;
* Turn the LEDs off explictly for the same reason.
*/
dd->ipath_f_quiet_serdes(dd);
- dd->ipath_f_setextled(dd, 0, 0);
if (dd->ipath_stats_timer_active) {
del_timer_sync(&dd->ipath_stats_timer);
~0ULL & ~INFINIPATH_HWE_MEMBISTFAILED);
ipath_write_kreg(dd, dd->ipath_kregs->kr_errorclear, -1LL);
ipath_write_kreg(dd, dd->ipath_kregs->kr_intclear, -1LL);
+
+ ipath_cdbg(VERBOSE, "Flush time and errors to EEPROM\n");
+ ipath_update_eeprom_log(dd);
}
/**
goto bail;
}
+ if (atomic_read(&dd->ipath_led_override_timer_active)) {
+ /* Need to stop LED timer, _then_ shut off LEDs */
+ del_timer_sync(&dd->ipath_led_override_timer);
+ atomic_set(&dd->ipath_led_override_timer_active, 0);
+ }
+
+ /* Shut off LEDs after we are sure timer is not running */
+ dd->ipath_led_override = LED_OVER_BOTH_OFF;
+ dd->ipath_f_setextled(dd, 0, 0);
+
dev_info(&dd->pcidev->dev, "Reset on unit %u requested\n", unit);
if (!dd->ipath_kregbase || !(dd->ipath_flags & IPATH_PRESENT)) {
git.openpandora.org / pandora-kernel.git / blobdiff