comment "Watchdog Device Drivers"
depends on WATCHDOG
-# Architecture Independant
+# Architecture Independent
config SOFT_WATCHDOG
tristate "Software watchdog"
enabled.
The driver is limited by the speed of the system's PCLK
- signal, so with reasonbaly fast systems (PCLK around 50-66MHz)
+ signal, so with reasonably fast systems (PCLK around 50-66MHz)
then watchdog intervals of over approximately 20seconds are
unavailable.
To compile this driver as a module, choose M here: the
module will be called ep93xx_wdt.
+config OMAP_WATCHDOG
+ tristate "OMAP Watchdog"
+ depends on WATCHDOG && (ARCH_OMAP16XX || ARCH_OMAP24XX)
+ help
+ Support for TI OMAP1610/OMAP1710/OMAP2420 watchdog. Say 'Y' here to
+ enable the OMAP1610/OMAP1710 watchdog timer.
+
+config PNX4008_WATCHDOG
+ tristate "PNX4008 Watchdog"
+ depends on WATCHDOG && ARCH_PNX4008
+ help
+ Say Y here if to include support for the watchdog timer
+ in the PNX4008 processor.
+ This driver can be built as a module by choosing M. The module
+ will be called pnx4008_wdt.
+
+ Say N if you are unsure.
+
# X86 (i386 + ia64 + x86_64) Architecture
config ACQUIRE_WDT
is no way to know if writing to its IO address will corrupt
your system or have any real effect. The only way to be sure
that this driver does what you want is to make sure you
- are runnning it on an EPX-C3 from Winsystems with the watchdog
+ are running it on an EPX-C3 from Winsystems with the watchdog
timer at IO address 0x1ee and 0x1ef. It will write to both those
IO ports. Basically, the assumption is made that if you compile
this driver into your kernel and/or load it as a module, that you
tristate "Indy/I2 Hardware Watchdog"
depends on WATCHDOG && SGI_IP22
help
- Hardwaredriver for the Indy's/I2's watchdog. This is a
+ Hardware driver for the Indy's/I2's watchdog. This is a
watchdog timer that will reboot the machine after a 60 second
timer expired and no process has written to /dev/watchdog during
that time.
To compile this driver as a module, choose M here: the
module will be called shwdt.
+config SH_WDT_MMAP
+ bool "Allow mmap of SH WDT"
+ default n
+ depends on SH_WDT
+ help
+ If you say Y here, user applications will be able to mmap the
+ WDT/CPG registers.
+#
# SPARC64 Architecture
config WATCHDOG_CP1XXX