#include <linux/ata.h>
#define DRV_NAME "pata_marvell"
-#define DRV_VERSION "0.0.5u"
+#define DRV_VERSION "0.1.1"
/**
* marvell_pre_reset - check for 40/80 pin
for(i = 0; i <= 0x0F; i++)
printk("%02X:%02X ", i, readb(barp + i));
printk("\n");
-
+
devices = readl(barp + 0x0C);
pci_iounmap(pdev, barp);
-
+
if ((pdev->device == 0x6145) && (ap->port_no == 0) &&
(!(devices & 0x10))) /* PATA enable ? */
return -ENOENT;
switch(ap->port_no)
{
case 0:
- /* Might be backward, docs unclear */
- if (inb(ap->ioaddr.bmdma_addr + 1) & 1)
- ap->cbl = ATA_CBL_PATA80;
- else
+ if (ioread8(ap->ioaddr.bmdma_addr + 1) & 1)
ap->cbl = ATA_CBL_PATA40;
+ else
+ ap->cbl = ATA_CBL_PATA80;
+ break;
case 1: /* Legacy SATA port */
ap->cbl = ATA_CBL_SATA;
.can_queue = ATA_DEF_QUEUE,
.this_id = ATA_SHT_THIS_ID,
.sg_tablesize = LIBATA_MAX_PRD,
- .max_sectors = ATA_MAX_SECTORS,
.cmd_per_lun = ATA_SHT_CMD_PER_LUN,
.emulated = ATA_SHT_EMULATED,
.use_clustering = ATA_SHT_USE_CLUSTERING,
.proc_name = DRV_NAME,
.dma_boundary = ATA_DMA_BOUNDARY,
.slave_configure = ata_scsi_slave_config,
+ .slave_destroy = ata_scsi_slave_destroy,
/* Use standard CHS mapping rules */
.bios_param = ata_std_bios_param,
+ .resume = ata_scsi_device_resume,
+ .suspend = ata_scsi_device_suspend,
};
static const struct ata_port_operations marvell_ops = {
.bmdma_status = ata_bmdma_status,
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
- .data_xfer = ata_pio_data_xfer,
+ .data_xfer = ata_data_xfer,
/* Timeout handling */
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
+ .irq_on = ata_irq_on,
+ .irq_ack = ata_irq_ack,
/* Generic PATA PCI ATA helpers */
.port_start = ata_port_start,
- .port_stop = ata_port_stop,
- .host_stop = ata_host_stop,
};
.id_table = marvell_pci_tbl,
.probe = marvell_init_one,
.remove = ata_pci_remove_one,
+ .suspend = ata_pci_device_suspend,
+ .resume = ata_pci_device_resume,
};
static int __init marvell_init(void)