#include <linux/irq.h>
#include <linux/interrupt.h>
-
#include <asm/byteorder.h>
#include <asm/io.h>
#include <asm/irq.h>
int len;
struct pci_controller *hose;
struct resource rsrc;
- int *bus_range;
+ const int *bus_range;
int primary = 0, has_address = 0;
/* PCI Config mapping */
has_address = (of_address_to_resource(dev, 0, &rsrc) == 0);
/* Get bus range if any */
- bus_range = (int *)get_property(dev, "bus-range", &len);
+ bus_range = get_property(dev, "bus-range", &len);
if (bus_range == NULL || len < 2 * sizeof(int)) {
printk(KERN_WARNING "Can't get bus-range for %s, assume"
" bus 0\n", dev->full_name);
(hose)->ops = &tsi108_direct_pci_ops;
- printk(KERN_INFO "Found tsi108 PCI host bridge at 0x%08lx. "
+ printk(KERN_INFO "Found tsi108 PCI host bridge at 0x%08x. "
"Firmware bus number: %d->%d\n",
rsrc.start, hose->first_busno, hose->last_busno);
mb();
}
-static inline int get_pci_source(void)
+static inline unsigned int get_pci_source(void)
{
u_int temp = 0;
int irq = -1;
* Interrupt controller descriptor for cascaded PCI interrupt controller.
*/
-struct hw_interrupt_type tsi108_pci_irq = {
+static struct irq_chip tsi108_pci_irq = {
.typename = "tsi108_PCI_int",
- .enable = tsi108_pci_irq_enable,
- .disable = tsi108_pci_irq_disable,
+ .mask = tsi108_pci_irq_disable,
.ack = tsi108_pci_irq_ack,
.end = tsi108_pci_irq_end,
+ .unmask = tsi108_pci_irq_enable,
};
/*
DBG("Tsi108_pci_int_init: initializing PCI interrupts\n");
for (i = 0; i < NUM_PCI_IRQS; i++) {
- irq_desc[i + IRQ_PCI_INTAD_BASE].handler = &tsi108_pci_irq;
+ irq_desc[i + IRQ_PCI_INTAD_BASE].chip = &tsi108_pci_irq;
irq_desc[i + IRQ_PCI_INTAD_BASE].status |= IRQ_LEVEL;
}
init_pci_source();
}
-int tsi108_irq_cascade(struct pt_regs *regs, void *unused)
+void tsi108_irq_cascade(unsigned int irq, struct irq_desc *desc,
+ struct pt_regs *regs)
{
- return get_pci_source();
+ unsigned int cascade_irq = get_pci_source();
+ if (cascade_irq != NO_IRQ)
+ generic_handle_irq(cascade_irq, regs);
+ desc->chip->eoi(irq);
}